Hostname: page-component-848d4c4894-m9kch Total loading time: 0 Render date: 2024-06-03T06:11:37.210Z Has data issue: false hasContentIssue false
  • English
  • Français

Fabricaton Ofactive Devices and Logic Gates on Fibers

Published online by Cambridge University Press:  15 February 2011

Yong Woo Choi ,
Ioannis Kymissis ,
Annie Wang  and
Akintunde I. Akinwande
Yong Woo Choi
Affiliation:
Microsystems Technology Lab. (MTL)
Ioannis Kymissis
Affiliation:
Department of Electrical Engineering and Computer Science, Massachusetts Institute of Technology (MIT), 60 Vassar St. Cambridge, MA02139
Annie Wang
Affiliation:
Department of Electrical Engineering and Computer Science, Massachusetts Institute of Technology (MIT), 60 Vassar St. Cambridge, MA02139
Akintunde I. Akinwande
Affiliation:
Microsystems Technology Lab. (MTL) Department of Electrical Engineering and Computer Science, Massachusetts Institute of Technology (MIT), 60 Vassar St. Cambridge, MA02139
Get access

Abstract

Textiles are a suitable substrate for large area, flexible and wearable electronics because of their excellent flexibility, mechanical properties and low cost manufacturability. The ability to fabricate active devices on fiber is a key step for achieving large area and flexible electronic structures. We fabricated transistors and inverters with a-Si film and pentacene film on Kapton film and cut them into fibers. The a-Si TFT showed a threshold voltage of 8.5 V and on/off ratio of 103 at a drain voltage of 10 V. These are similar to the characteristics of a TFT fabricated on a glass substrate at the same time. The maximum gain of the inverter with an enhancement n-type load was 6.45 at a drain voltage of 10 V. The pentacene OTFT showed a threshold voltage of -8 V and on/off ratio of 103 at a drain voltage of -30 V. The inverter with a depletion p-type load showed a voltage inversion but the inversion occurred at the wrong voltage. The antifuse was successfully programmed with a voltage pulse and also a current pulse. The resistance decreased from 10 GΩ to 2 kΩ after the programming.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 769: Symposium H – Flexible Electronics - Materials and Device Technology , 2003 , H8.6
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Gleskova, H., Wagner, S., Gasparik, V., and Kovac, P., J. Electrochem Soc., 148, G370 (2001).Google Scholar
2. Nelson, S. F., Lin, Y. –Y., Gundlach, D. J., and Jackson, T. N., Appl. Phys. Lett., 72, 1854 (1998).Google Scholar
3. Bonse, M., Thomasson, D. B., Klauk, H., Gundlach, D. J., and Jackson, T. N., “Integrated a-Si:H/pentacene inorganic/organic complementary circuits.” International Electron Devices Meeting, 1998 Technical Digest, pp249–252, San Francisco, CA, December 1998.Google Scholar
4. Hamdy, E., McCollum, J., Chen, S., Chiang, S., Eltoukhy, S., Chang, J., Speers, T., and Mohsen, A., “Dielectric Based Antifuse for Logic and Memory IC”, International Electron Devices Meeting, 1988 Technical Digest, pp786–789, San Francisco, CA, December 1988.Google Scholar
5. Dimitrakopoulos, C. D., Brown, A. R., and Pomp, A., J. Appl. Phys., 80, 2501, (1996).Google Scholar
6. Meyer zu Heringdorf, Frank-J., Reuter, M. C., and Tromp, R. M., Nature, 412, 517 (2001).Google Scholar
7. Dimitrakopoulos, C. D., Furman, B. K., Graham, T., Hegde, S., and Purushothaman, S., Synthetic Metals, 92, 47 (1998).Google Scholar