Hostname: page-component-848d4c4894-ndmmz Total loading time: 0 Render date: 2024-06-02T02:51:27.247Z Has data issue: false hasContentIssue false
  • English
  • Français

Gamma Ray Spectrometers Fabricated from Modified Bridgman/Annealed CZT Crystal Material

Published online by Cambridge University Press:  10 February 2011

K. Chattopadhyay ,
H. Chen ,
K-T. Chen ,
Arnold Burger ,
J. P. Flint ,
H. L. Glass  and
R. B. James
K. Chattopadhyay
Affiliation:
Center for Photonic Materials and Devices, Fisk University, Nashville, TN
H. Chen
Affiliation:
Center for Photonic Materials and Devices, Fisk University, Nashville, TN
K-T. Chen
Affiliation:
Center for Photonic Materials and Devices, Fisk University, Nashville, TN
Arnold Burger
Affiliation:
Center for Photonic Materials and Devices, Fisk University, Nashville, TN
J. P. Flint
Affiliation:
Johnson Matthey Electronics, Spokane, WA
H. L. Glass
Affiliation:
Johnson Matthey Electronics, Spokane, WA
R. B. James
Affiliation:
Advanced Electronics Manufacturing Technologies Department, Sandia National Laboratories, Livermore, CA
Get access

Abstract

The CZT boule was grown by a modified vertical Bridgman process using in-situ compounding, Cd over-pressure and a pyrolytic boron nitride crucible within a fused ampoule. During growth, the Cd vapor pressure was near 1 atmosphere. These growth conditions tend to give high purity, good stoichiometry, few precipitates, and dislocation densities in the low to mid-104 cm−2 range. The crystals, after polishing, were annealed in a nearly saturated Cd, Zn atmosphere to fill residual Cd-site vacancies and achieve high resistivity in the 1010 γ-cm range. Low temperature photoluminescence study shows very good crystalline quality and a very low concentration of deep level recombinations. Single crystal samples were diced into 1 cm squares for evaluation as gamma ray detectors. The best detector results (4.5% resolution at 60 keV) were achieved for a 2 hour anneal at 850°C.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 487: Symposium I – Semiconductors for Room-Temperature Radiation II , 1997 , 123
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Butler, J. F., Doty, F. P., Apotovsky, B., Lajzerowicz, L., and Verger, L. Materials Science and Engineering B16 (1993) 291.Google Scholar
2. Raiskin, E. and Butler, J. F., IEEE Trans. Nucl. Sci. NS–35 (1988) 82.Google Scholar
3. Glass, H. L., Socha, A. J., Parfeniuk, C. L., Bakken, D. W., Symposium F, MRS Fall Meeting (1997)Google Scholar
4. Sher, A., Chen, An-Ban, Spicer, W. E., and Shih, C-K., J. Vac. Sci. Technol. A3, (1985) 112.Google Scholar
5. Nemirovsky, Y., Ruzin, A., Asa, G., Gorelik, Y., and Li, L., J. Electronics Materials, V26, N 6, (1997) 756.Google Scholar
6. Butler, J. F., Doty, F. P., Apotovsky, B., Frieshenhahn, S. J., and Lingren, C., Mat. Res. Soc. Symp. Vol.302 (1993) 497.Google Scholar