Hostname: page-component-848d4c4894-2pzkn Total loading time: 0 Render date: 2024-06-04T19:01:52.219Z Has data issue: false hasContentIssue false
  • English
  • Français

Specimen Preparation of Thin Crystalline Fibers for Transmission Electron Microscopy

Published online by Cambridge University Press:  16 February 2011

Rosemarie Koch  and
Ann F. Marshall
Rosemarie Koch
Affiliation:
Center for Materials Research, Stanford University, Stanford, CA 94305
Ann F. Marshall
Affiliation:
Center for Materials Research, Stanford University, Stanford, CA 94305
Get access

Abstract

A technique was developed to prepare crystalline fibers of less than 1 mm diameter for transmission electron microscopy. Cross sections were made by casting a short piece of the fiber in an epoxy resin, sectioning the block, and laminating the slices against thin glass discs for stability before dimpling. Longitudinal sections were reinforced in a similar manner. TEM tungsten rings were sometimes used as an alternative method to add stability to the longitudinal sections. The technique was especially developed for Bi-Sr-Ca-Cu-O compounds but is also suitable for other materials.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 199: Symposium W – Specimen Preparation for Transmission Electron Microscopy of Materials II , 1990 , 145
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Bravman, J. C. and Sinclair, R., J. Elec. Mic. Tech. 1, 53 (1984).Google Scholar