Hostname: page-component-848d4c4894-ndmmz Total loading time: 0 Render date: 2024-06-12T16:14:39.987Z Has data issue: false hasContentIssue false
  • English
  • Français

Development of a predictive life tool for tapered roller bearings using measured residual stress and retained austenite data

Published online by Cambridge University Press:  29 February 2012

Brent M. Wilson  and
Matthew G. Dick
Brent M. Wilson*
Affiliation:
Department of Mechanical Engineering, University of Nebraska, Lincoln, Nebraska 68588
Matthew G. Dick
Affiliation:
RSI Materials Engineering, Omaha, Nebraska 68102
*
a)Author to whom correspondence should be addressed. Electronic mail: wilson@engr.unl.edu
Get access Rights & Permissions [Opens in a new window]

Abstract

The development of a tool called the Service Load Factor (SLF) for railway tapered roller bearings using residual stress and retained austenite data is presented. Case-carburized tapered roller bearings used in the railroad industry are manufactured with a dual-phase microstructure that consists primarily of tempered martensite and retained austenite. The retained austenite phase is metastable, and will transform to martensite with sufficient thermal or mechanical energy during service. The increase in surface volume because of transformation, and the subsequent increase in compressive residual stress could indicate the onset of certain failure modes, including fatigue spalling. In addition, retained austenite transformation can lead to an increase in bore diameter, which could result in a loss of fit on the axle journal. Several bearing inner races with various service histories were measured with a Siemens X-ray diffractometer using chromium radiation. Results indicated that the transformation of retained austenite and resultant increase in compressive residual stress are interrelated with load and rolling cycles. Results indicate that the SLF is a useful tool that correlates well with current Association of American Railroads failure criteria.

Keywords

bearingsretained austeniteresidual stressdiffractionpredictive tool
Type
X-Ray Diffraction
Information
Powder Diffraction , Volume 23 , Issue 2 , June 2008 , pp. 118 - 120
Copyright
Copyright © Cambridge University Press 2008

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Hilley, M. E. (Ed.) (1971). Residual Stress Measurement by X-ray Diffraction (SAE J784a) (Society of Automotive Engineering, Warrendale, Pennsylvania).Google Scholar
Jatczak, C. F. (1980). Retained Austenite and its Measurement by X-ray Diffraction: An Information Manual (Manual SP-453) (Society of Automotive Engineering, Warrendale, Pennsylvania).Google Scholar
Magner, S. H. (1993). “Microstructural changes during simulated service of case carburized tapered roller bearings with different initial retained austenite profiles,” Doctoral Dissertation, University of Nebraska, Lincoln, Nebraska.Google Scholar
Noyan, I. C. and Cohen, J. B. (1987). Residual Stress: Measurement by Diffraction and Interpretation (Springer-Verlag, New York).CrossRefGoogle Scholar
Voskamp, A. P., Österlund, R., Becker, P. C., and Vingsbo, O. (1980). “Gradual changes in residual stress and microstructure during contact fatigue in ball bearings,” Metall.: J. Met. Technol. Met. Forming Therm. Process. 7, 14–21.Google Scholar