Skip to main content Accessibility help
×
Hostname: page-component-74656f9884-j7cmm Total loading time: 0 Render date: 2026-11-07T19:07:43.456Z Has data issue: false hasContentIssue false

15 - Receivers

Published online by Cambridge University Press:  28 May 2018

Steven W. Ellingson
Affiliation:
Virginia Polytechnic Institute and State University
Get access

Summary

INTRODUCTION

We have now arrived at a point where we can reasonably consider the analysis and design of radio receivers. In Chapter 1, we considered two broad classes of radio receivers: those employing analog detection (Figure 1.10), used primarily with AM/ASK and FM/FSK modulations; and receivers employing analog-to-digital conversion (Figure 1.11), where the ADC output is subsequently processed digitally. In either case, the central problem in receiver design is to accept the signal provided by the antenna – a problem we addressed in Chapter 12 – and to deliver it to the analog detector or ADC with sufficient gain, sensitivity, selectivity, and linearity. Receivers by this definition are also sometimes referred to as downconverters, implying that frequency downconversion occurs; or tuners implying that the center frequency of the received bandpass is variable.

We have already addressed the topic of analog detectors in Chapter 5, so this chapter begins with a discussion of the requirements and characteristics of ADCs (Section 15.2). In Section 15.3 we consider the central question of gain – how much is nominal, how little is adequate, and the relationship to sensitivity. Sections 15.4 and 15.5 address techniques and requirements for selectivity. Section 15.6 provides a summary of the principal receiver architectures. Section 15.7 elaborates on the problem of frequency planning in superheterodyne receivers. In Section 15.8 we revisit the question of gain, now in the context of the various receiver architectures, and summarize the principles of automatic gain control. This chapter concludes with suggestions for receiver design case studies (Section 15.9), intended to further demonstrate the practical aspects of modern receiver design.

ANALOG-TO-DIGITAL CONVERSION

An ADC is a device that converts a continuous-time analog signal into a sequence of discretetime digital values that approximate the input signal. After a brief introduction to ADC method of operation, the issues of sample rate versus bandwidth (Section 15.2.2) and quantization noise (Section 15.2.3) are discussed. Finally, we consider the characteristics and limitations of practical ADCs (Section 15.2.4).

Method of Operation

A simple model for analog-to-digital conversion is shown in Figure 15.1. This model consists of three parts: an analog sample and hold device (S/H), a quantizer, and a output word generator.

Information

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Book purchase

Temporarily unavailable

Save book to Kindle

To save this book to your Kindle, first ensure no-reply@cambridge.org is added to your Approved Personal Document E-mail List under your Personal Document Settings on the Manage Your Content and Devices page of your Amazon account. Then enter the ‘name’ part of your Kindle email address below. Find out more about saving to your Kindle.

Note you can select to save to either the @free.kindle.com or @kindle.com variations. ‘@free.kindle.com’ emails are free but can only be saved to your device when it is connected to wi-fi. ‘@kindle.com’ emails can be delivered even when you are not connected to wi-fi, but note that service fees apply.

Find out more about the Kindle Personal Document Service.

  • Receivers
  • Steven W. Ellingson, Virginia Polytechnic Institute and State University
  • Book: Radio Systems Engineering
  • Online publication: 28 May 2018
  • Chapter DOI: https://doi.org/10.1017/CBO9781107705852.016
Available formats
×

Save book to Dropbox

To save content items to your account, please confirm that you agree to abide by our usage policies. If this is the first time you use this feature, you will be asked to authorise Cambridge Core to connect with your account. Find out more about saving content to Dropbox.

  • Receivers
  • Steven W. Ellingson, Virginia Polytechnic Institute and State University
  • Book: Radio Systems Engineering
  • Online publication: 28 May 2018
  • Chapter DOI: https://doi.org/10.1017/CBO9781107705852.016
Available formats
×

Save book to Google Drive

To save content items to your account, please confirm that you agree to abide by our usage policies. If this is the first time you use this feature, you will be asked to authorise Cambridge Core to connect with your account. Find out more about saving content to Google Drive.

  • Receivers
  • Steven W. Ellingson, Virginia Polytechnic Institute and State University
  • Book: Radio Systems Engineering
  • Online publication: 28 May 2018
  • Chapter DOI: https://doi.org/10.1017/CBO9781107705852.016
Available formats
×