Skip to main content
×
Home
    • Aa
    • Aa

The motion of long bubbles in polygonal capillaries. Part 1. Thin films

  • Harris Wong (a1) (a2), C. J. Radke (a3) and S. Morris (a1)
Abstract

Foam in porous media exhibits an unusually high apparent viscosity, making it useful in many industrial processes. The rheology of foam, however, is complex and not well understood. Previous pore-level models of foam are based primarily on studies of bubble flow in circular capillaries. A circular capillary, however, lacks the corners that characterize the geometry of the pores. We study the pressure–velocity relation of bubble flow in polygonal capillaries. A long bubble in a polygonal capillary acts as a leaky piston. The ‘piston’ is reluctant to move because of a large drag exerted by the capillary sidewalls. The liquid in the capillary therefore bypasses the bubble through the leaky corners at a speed an order higher than that of the bubble. Consequently, the pressure work is dissipated predominantly by the motion of the fluid and not by the motion of the bubble. This is opposite to the conclusion based on bubble flow in circular capillaries. The discovery of this new flow regime reconciles two groups of contradictory foam-flow experiments.

Part 1 of this work studies the fluid films deposited on capillary walls in the limit Ca → 0 (Ca ≡ μU/σ, where μ is the fluid viscosity, U the bubble velocity, and σ the surface tension). Part 2 (Wong et al. 1995) uses the film profile at the back end to calculate the drag of the bubble. Since the bubble length is arbitrary, the film profile is determined here as a general function of the dimensionless downstream distance x. For 1 [Lt ] x [Lt ] Ca−1, the film profile is frozen with a thickness of order Ca2/3 at the centre and order Ca at the sides. For xCa−1, surface tension rearranges the film at the centre into a parabolic shape while the film at the sides thins to order Ca4/3. For x [Gt ] Ca−1, the film is still parabolic, but the height decreases as film fluid leaks through the side constrictions. For xCa−5/3, the height of the parabola is order Ca2/3. Finally, for x [Gt ] Ca−5/3, the height decreases as Ca1/4x−1/4.

Copyright
Linked references
Hide All

This list contains references from the content that can be linked to their source. For a full set of references and notes please see the PDF or HTML where available.

Albrecht, R. A. & Marsden, S. S.1970Foams as blocking agents in porous media. Soc. Pet. Engng J.10, 51.

Bretherton, F. P. 1961 The motion of long bubbles in tubes. J. Fluid Mech. 10, 166188.

Burgess, D. & Foster, M. R.1990Analysis of the boundary conditions for a Hele-Shaw bubble. Phys. Fluids A 2, 11051117.

Falls, A. H., Musters, J. J. & Ratulowski, J.1989The apparent viscosity of foams in homogeneous beadpacks. SPE Reservoir Engng4, 155164.

Frankel, S. & Mysels, K. J.1962On the dimpling during the approach of two interfaces. J. Phys. Chem.66, 190191.

Hirasaki, G. J.1989The steam-foam process. J. Pet. Technol.41, 449456.

Holm, L. W. & Garrison, W. H.1988CO2 diversion with foam in an immiscible CO2 field project. SPE Reservoir Engng3, 112118.

Jones, A. F. & Wilson, S. D. R. 1978 The film drainage problem in droplet coalescence. J. Fluid Mech. 87, 263288.

Mason, G. & Morrow, N. R.1984Meniscus curvatures in capillaries of uniform cross-section. J. Chem. Soc. Faraday Trans.80, 23752393.

Park, C. W. & Homsy, G. M. 1984 Two-phase displacement in Hele-Shaw cells: theory. J. Fluid Mech. 139, 291308.

Reinelt, D. A.1987The effect of thin film variations and transverse curvature on the shape of fingers in a Hele-Shaw cell. Phys. Fluids30, 26172623.

Reinelt, D. A. & Kraynik, A. M. 1990 On the shearing flow of foams and concentrated emulsions. J. Fluid Mech. 215, 431455.

Saffman, P. G. & Taylor, G. I.1958The penetration of a fluid into a porous medium or Hele-Shaw cell containing a more viscous liquid. Proc. R. Soc. Lond. A 245, 312329.

Schwartz, L. W., Princen, H. M. & Kiss, A. D. 1986 On the motion of bubbles in capillary tubes. J. Fluid Mech. 172, 259275.

Stebe, K. J., Lin, S. Y. & Maldarelli, C.1991Remobilizing surfactant retarded fluid particle interfaces. I. Stress-free conditions at the interfaces of micellar solutions of surfactants with fast sorption kinetics. Phys. Fluids A 3, 320.

Wong, H., Morris, S. & Radke, C. J.1992aTwo-dimensional menisci in non-axisymmetric capillaries. J. Colloid Interface Sci.148, 284287.

Wong, H., Morris, S. & Radke, C. J.1992bThree-dimensional menisci in polygonal capillaries. J. Colloid Interface Sci.148, 317336.

Wong, H., Radke, C. J. & Morris, S.1995The motion of long bubbles in polygonal capillaries. Part 2. Drag, fluid pressure and fluid flow. J. Fluid Mech.292, 95110.

Recommend this journal

Email your librarian or administrator to recommend adding this journal to your organisation's collection.

Journal of Fluid Mechanics
  • ISSN: 0022-1120
  • EISSN: 1469-7645
  • URL: /core/journals/journal-of-fluid-mechanics
Please enter your name
Please enter a valid email address
Who would you like to send this to? *
×
MathJax

Metrics

Full text views

Total number of HTML views: 0
Total number of PDF views: 88 *
Loading metrics...

Abstract views

Total abstract views: 182 *
Loading metrics...

* Views captured on Cambridge Core between September 2016 - 23rd May 2017. This data will be updated every 24 hours.