Skip to main content
×
Home
    • Aa
    • Aa

Compressive strength of hollow microlattices: Experimental characterization, modeling, and optimal design

  • Lorenzo Valdevit (a1), Scott W. Godfrey (a2), Tobias A. Schaedler (a3), Alan J. Jacobsen (a3) and William B. Carter (a3)...
Abstract
Abstract

Recent advances in multiscale manufacturing enable fabrication of hollow-truss based lattices with dimensional control spanning seven orders of magnitude in length scale (from ∼50 nm to ∼10 cm), thus enabling the exploitation of nano-scale strengthening mechanisms in a macroscale cellular material. This article develops mechanical models for the compressive strength of hollow microlattices and validates them with a selection of experimental measurements on nickel microlattices over a wide relative density range (0.01–10%). The limitations of beam-theory-based analytical approaches for ultralight designs are emphasized, and suitable numerical (finite elements) models are presented. Subsequently, a novel computational platform is utilized to efficiently scan the entire design space and produce maps for optimally strong designs. The results indicate that a strong compressive response can be obtained by stubby lattice designs at relatively high densities (∼10%) or by selectively thickening the nodes at ultra-low densities.

Copyright
Corresponding author
a)Address all correspondence to this author. e-mail: Valdevit@uci.edu
Linked references
Hide All

This list contains references from the content that can be linked to their source. For a full set of references and notes please see the PDF or HTML where available.

A.G. Evans , J.W. Hutchinson , N.A. Fleck , M.F. Ashby , and H.N.G. Wadley : The topological design of multifunctional cellular metals. Prog. Mater. Sci. 46, 309 (2011).

A.G. Evans , M.Y. He , and V.S. Deshpande : Concepts for enhanced energy absorption using hollow micro-lattices. Int. J. Impact Eng. 37, 947 (2010).

T.J. Lu , L. Valdevit , and A.G. Evans : Active cooling by metallic sandwich structures with periodic cores. Prog. Mater. Sci. 50, 789 (2005).

L. Valdevit , A. Pantano , H.A. Stone , and A.G. Evans : Optimal active cooling performance of metallic sandwich panels with prismatic cores. Int. J. Heat Mass Transfer 49, 3819 (2006).

H.N.G. Wadley , K.P. Dharmasena , M.Y. He , R.M. McMeeking , A.G. Evans , and R. Radovitzky : An active concept for limiting injuries caused by air blasts. Int. J. Impact Eng. 37, 317 (2010).

L. Valdevit , N. Vermaak , F.W. Zok , and A.G. Evans : A materials selection protocol for lightweight actively cooled panels. J. Appl. Mech. 75, 061022 (2008).

L. Valdevit , A.J. Jacobsen , J.R. Greer , and W.B. Carter : Protocols for the optimal design of multi-functional cellular structures: From hypersonics to micro-architected materials. J. Am. Ceram. Soc. 94, 15 (2011).

V.S. Deshpande , N.A. Fleck , and M.F. Ashby : Effective properties of the octet-truss lattice material. J. Mech. Phys. Solids 49, 1747 (2001).

F.W. Zok , H.J. Rathbun , Z. Wei , and A.G. Evans : Design of metallic textile core sandwich panels. Int. J. Solids Struct. 40, 5707 (2003).

F.W. Zok , S.A. Waltner , Z. Wei , H.J. Rathbun , R.M. McMeeking , and A.G. Evans : A protocol for characterizing the structural performance of metallic sandwich panels: Application to pyramidal truss cores. Int. J. Solids Struct. 41, 6249 (2004).

L. Valdevit , J.W. Hutchinson , and A.G. Evans : Structurally optimized sandwich panels with prismatic cores. Int. J. Solids Struct. 41, 5105 (2004).

F.W. Zok , H.J. Rathbun , M.Y. He , E. Ferri , C. Mercer , R.M. McMeeking , and A.G. Evans : Structural performance of metallic sandwich panels with square honeycomb cores. Philos. Mag. 85, 3207 (2005).

H.N.G. Wadley : Cellular metals manufacturing. Adv. Eng. Mater. 4, 726 (2002).

H.N.G. Wadley , N.A. Fleck , and A.G. Evans : Fabrication and structural performance of periodic cellular metal sandwich structures. Compos. Sci. Technol. 63, 13 (2003).

T.A. Schaedler , A.J. Jacobsen , A. Torrents , A.E. Sorensen , J. Lian , J.R. Greer , L. Valdevit, and W.B. Carter : Ultralight metallic microlattices. Science 334, 962 (2011).

A. Torrents , T.A. Schaedler , A.J. Jacobsen , W.B. Carter , and L. Valdevit : Characterization of nickel-based microlattice materials with structural hierarchy from the nanometer to the millimeter scale. Acta Mater. 60, 3511 (2012).

J.R. Greer and J.T.M. De Hosson : Plasticity in small-sized metallic systems: Intrinsic versus extrinsic size effect. Prog. Mater. Sci. 56, 654 (2011).

K.J. Maloney , C.S. Roper , A.J. Jacobsen , L. Valdevit , W.B. Carter , and T.A. Schaedler : Microlattices as architected thin films: Analysis of mechanical properties and high strain elastic recovery. APL Materials (2013, in press).

Recommend this journal

Email your librarian or administrator to recommend adding this journal to your organisation's collection.

Journal of Materials Research
  • ISSN: 0884-2914
  • EISSN: 2044-5326
  • URL: /core/journals/journal-of-materials-research
Please enter your name
Please enter a valid email address
Who would you like to send this to? *
×

Keywords: