Hostname: page-component-7c8c6479df-fqc5m Total loading time: 0 Render date: 2024-03-28T20:20:50.965Z Has data issue: false hasContentIssue false

A Novel Latching Relay Fabricated Using an Oxide Molded Tungsten Process

Published online by Cambridge University Press:  01 February 2011

J.G. Fleming
Affiliation:
Org. 1749, MS 1080, Sandia National Laboratories, P.O. Box 5800, Albuquerque, NM 87185.
Michael Baker
Affiliation:
Org. 1749, MS 1080, Sandia National Laboratories, P.O. Box 5800, Albuquerque, NM 87185.
David Luck
Affiliation:
Org. 1749, MS 1080, Sandia National Laboratories, P.O. Box 5800, Albuquerque, NM 87185.
Get access

Abstract

In this paper we describe an oxide molded tungsten process applied to the fabrication of a novel latching relay. The steps in the process are: deposition of a sacrificial oxide, patterning of the oxide, filling of the resulting mold with a blanket film of tungsten using chemical vapor deposition (CVD), and then the removal and planarization of excess tungsten through chemical mechanical polishing (CMP). The process for the incorporation of dielectric isolation has also been developed. The resulting tungsten structures are under high tensile stress, which appears to be compensated in process by the compressive stress of the oxide mold. All the steps are low temperature and the entire process is backend CMOS compatible. This process has been used to fabricate a latching relay which relies on the internal stress of the tungsten and always generates force in a pulling mode. Parts have been successfully fabricated and tested, the devices generate very high forces for a MEMS device and give reasonable contact resistances even without noble metal contacts.

Type
Research Article
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1 Hofmann, W., Chen, L.-Y. and MacDonald, N., Design and fabrication of micromachined electron guns (MEGs) using a multiple-level planar tungsten process, SPIE Proceedings 2640, (1995) pp. 132.Google Scholar
2 Joshi, R.V., Mehter, E., Chow, M., Ishaq, M., Kang, S., Geraghty, P. and McInerney, J., High growth rate CVD-W process for filling high aspect ratio sub-micron contacts/lines, Tungsten and other Advanced Metals for VLSI/ULSI Applications V, MRS conference Proceedings, (1990) pp. 157.Google Scholar
3 Fleming, J.G, Lin, S.-Y., , SY; El-Kady, I., Biswas, R. and Ho, K.M., All-metallic three-dimensional photonic crystals with a large infrared bandgap, Nature, 417, 52 (2002).Google Scholar
4 Schimkat, J., Contact measurements providing basic design data for microrelay actuators, Sensor and actuators A-physical, 73, 138 (1999).Google Scholar