Skip to main content
    • Aa
    • Aa
  • Get access
    Check if you have access via personal or institutional login
  • Cited by 6
  • Cited by
    This article has been cited by the following publications. This list is generated based on data provided by CrossRef.

    Lind, J. Li, S.F. Pokharel, R. Lienert, U. Rollett, A.D. and Suter, R.M. 2014. Tensile twin nucleation events coupled to neighboring slip observed in three dimensions. Acta Materialia, Vol. 76, p. 213.

    Maire, E. and Withers, P. J. 2014. Quantitative X-ray tomography. International Materials Reviews, Vol. 59, Issue. 1, p. 1.

    Hefferan, Christopher M. Lind, Jonathan Li, Shiu Fai Lienert, Ulrich Rollett, Anthony D. and Suter, Robert M. 2012. Observation of recovery and recrystallization in high-purity aluminum measured with forward modeling analysis of high-energy diffraction microscopy. Acta Materialia, Vol. 60, Issue. 10, p. 4311.

    Miller, Matthew P. Suter, Robert M. Lienert, Ulrich Beaudoin, Armand J. Fontes, Ernest Almer, Jonathan and Schuren, Jay C. 2012. High-energy Needs and Capabilities to Study Multiscale Phenomena in Crystalline Materials. Synchrotron Radiation News, Vol. 25, Issue. 6, p. 18.

    Lienert, U. Li, S. F. Hefferan, C. M. Lind, J. Suter, R. M. Bernier, J. V. Barton, N. R. Brandes, M. C. Mills, M. J. Miller, M. P. Jakobsen, B. and Pantleon, W. 2011. High-energy diffraction microscopy at the advanced photon source. JOM, Vol. 63, Issue. 7, p. 70.

    Uchic, Michael D. Groeber, Michael A. and Rollett, Anthony D. 2011. Automated serial sectioning methods for rapid collection of 3-D microstructure data. JOM, Vol. 63, Issue. 3, p. 25.


Tests of microstructure reconstruction by forward modeling of high energy X-ray diffraction microscopy data

  • C. M. Hefferan (a1), S. F. Li (a1), J. Lind (a1) and R. M. Suter (a1)
  • DOI:
  • Published online: 29 February 2012

Verification tests of the forward modeling technique for near-field high energy X-ray diffraction microscopy are conducted using two simulated microstructures containing uniformly distributed orientations. Comparison between the simulated and reconstructed microstructures is examined with consideration to both crystallographic orientation and spatial geometric accuracy. To probe the dependence of results on experimental parameters, simulated data sets use two different detector configurations and different simulated experimental protocols; in each case, the parameters mimic the experimental geometry used at Advanced Photon Source beamline 1-ID. Results indicate that element orientations are distinguishable to less than 0.1°, while spatial geometric accuracy is limited by the detector resolution.

Corresponding author
a)Author to whom correspondence should be addressed. Electronic mail:
Linked references
Hide All

This list contains references from the content that can be linked to their source. For a full set of references and notes please see the PDF or HTML where available.

B. Adams , K. Kunze , and S. I. Wright (1993). “Orientation imaging: The emergence of a new microscopy,” Metall. Trans. A MTTABN 0360-213324, 819831.10.1007/BF02656503

B. C. Larson , W. Yang , G. E. Ice , J. D. Budai , and J. Z. Tischler (2002). “Three-dimensional X-ray structural microscopy with submicrometre resolution,” Nature (London) NATUAS 0028-0836415, 887890.10.1038/415887a

U. Lienert , M. C. Brandes , J. V. Bernier , J. Weiss , S. D. Shastri , M. J. Mills , and M. P. Miller (2009). “In-situ single grain peak profile measurements on Ti-7Al during tensile deformation,” Mater. Sci. Eng., A MSAPE3 0921-5093524, 4654.10.1016/j.msea.2009.06.047

W. Ludwig , S. Schmidt , E. M. Lauridsen , and H. F. Poulsen (2008). “X-ray diffraction contrast tomography: A novel technique for three-dimensional grain mapping of polycrystals,” J. Appl. Crystallogr. JACGAR 0021-889841, 302309.10.1107/S0021889808001684

H. F. Poulsen (2004). Three-Dimensional X-Ray Diffraction Microscopy: Mapping Polycrystals and Their Dynamics, Springer Tracts in Modern Physics (Springer, Berlin), Vol. 205.

H. F. Poulsen , S. F. Nielsen , E. M. Laurdisen , S. Schmidt , R. M. Suter , U. Lienert , L. Margulies , T. Lorentzen , and D. Juul Jensen (2001). “Three-dimensional maps of grain boundaries and the stress state of individual grains in polycrystals and powders,” J. Appl. Crystallogr. JACGAR 0021-889834, 751756.10.1107/S0021889801014273

R. M. Suter , C. M. Hefferan , S. F. Li , D. Hennessy , C. Xiao , U. Lienert , and B. Tieman (2008). “Probing microstructure dynamics with X-ray diffraction microscopy,” J. Eng. Mater. Technol. JEMTA8 0094-4289, 130, 021007.10.1115/1.2840965

R. M. Suter , D. Hennessy , C. Xiao , and U. Lienert (2006). “Forward modeling method for microstructure reconstruction using x-ray diffraction microscopy: Single crystal verification,” Rev. Sci. Instrum. RSINAK 0034-6748, 77, 123905.10.1063/1.2400017

M. D. Uchic , M. A. Groeber , D. M. Dimiduk , and J. P. Simmons (2006). “3D microstructural characterization of nickel superalloys via serial-sectioning using a dual beam FIB-SEM,” Scr. Mater. SCMAF7 1359-646255, 2328.10.1016/j.scriptamat.2006.02.039

S. I. Wright and B. L. Adams (1992). “Automatic-analysis of electron backscatter diffraction patterns,” Metall. Trans. A MTTABN 0360-213323, 759767.10.1007/BF02675553

Recommend this journal

Email your librarian or administrator to recommend adding this journal to your organisation's collection.

Powder Diffraction
  • ISSN: 0885-7156
  • EISSN: 1945-7413
  • URL: /core/journals/powder-diffraction
Please enter your name
Please enter a valid email address
Who would you like to send this to? *