Skip to main content

Sealed Tube Combustion Method with MnO2 for AMS 14C Measurement

  • Róbert Janovics (a1), István Futó (a1) and Mihály Molnár (a1)

An effective sealed tube combustion method was designed with an MnO2 oxidant for accelerator mass spectrometry radiocarbon (AMS 14C) measurements. Different types of materials (oxalic acid, cellulose, sucrose, wood, collagen, graphite, and humic acid) were used to test the method. A normal borosilicate glass tube was used instead of quartz and the combustion was done at 550ºC. The yield of the combustion is above 98% even in the case of the less combustible material such as graphite. The MnO2 reagent does not introduce detectable carbon contamination. The typical background is 0.29±0.20 pMC in the case of 200 µg carbon, measured as solid graphite target. With direct measurement of the CO2 by gas ion source AMS, the method is applicable up to 50 µg of carbon with an acceptable (~1 pMC) 14C background. A new type of tube cracker was developed for a quick chipless method of tube cracking and sample changing. In this way, the gas handling process takes only 5–6 min/sample.

Corresponding author
*Corresponding author. Email:
Hide All
Aerts-Bijma, A, van der Plicht, J, Meijer, H. 2001. Automatic AMS sample combustion and CO2 collection. Radiocarbon 43(2A):293298.
Boutton, TW. et al. 1983. Comparison of quartz and Pyrex tubes for combustion of organic-samples for stable carbon isotope analysis. Analytical Chemistry 55:18321833.
Brock, F, Froese, DG, Roberts, RG. 2010. Low temperature (LT) combustion of sediments does not necessarily provide accurate radiocarbon ages for site chronology. Quaternary Geochronology 5:625630.
Burr, GS. et al. 2001. Sample preparation of dissolved organic carbon in groundwater for AMS 14C analysis. Radiocarbon 43(2A):183190.
Fung, K. 1990. Particulate carbon speciation by MnO2 oxidant. Aerosol Science and Technology 12:122127.
Fung, K, Chow, JC, Watson, JG. 2002. Evaluation of OC/EC speciation by thermal manganese dioxide oxidation and the improve method. Journal of the Air & Waste Management Association 52:13331341.
Genberg, J, Perron, N, Olsson, M, Stenström, K. 2013. Sealed glass tube combustion of μg-sized aerosol samples. Radiocarbon 55(2–3):617623.
Gonfiantini, R, Stichler, W, Rozanski, K. 1995. Standards and intercomparison materials distributed by the International Atomic Energy Agency for stable isotope measurements. IAEA-TECDOC-825. Vienna: International Atomic Energy Agency.
Gröning, M. 2007. Reference Sheet for Quality Control Materials. Vienna.
Jull, AJT et al. 2000. Radiocarbon beyond this world. Radiocarbon 42(1):151172.
Kato, K et al. 2014. Automated sample combustion and CO2 collection system with IRMS for 14C AMS in Yamagata University, Japan. Radiocarbon 56(1):327331.
Leonard, A et al. 2013. A wet oxidation method for AMS radiocarbon analysis of dissolved organic carbon in water. Radiocarbon 55(2–3):545552.
McGeehin, J et al. 2004. Stepped-combustion 14C dating of bomb carbon in lake sediment. Radiocarbon 46(2):893900.
Minami, M et al. 2009. Comparison of δ13C and 14C activities of CO2 samples combusted in closed-tube and elemental-analyzer systems. Nuclear Instruments and Methods in Physics Research B 268:914918.
Molnár, M et al. 2013. Status report of the new AMS 14C sample preparation lab of the Hertelendi Laboratory of Environmental Studies (Debrecen, Hungary). Radiocarbon 55(2–3):665676.
Ramsey, CB, Humm, M. 2000. On-line combustion of samples for AMS and ion source developments at ORAU. Nuclear Instruments and Methods in Physics Research B 172:242246.
Rinyu, L et al. 2013. Optimised of sealed tube graphitisation method for environmental C-14 studies using MICADAS. Nuclear Instruments and Methods in Physics Research B 1:270275.
Santos, GM. 2008. KCCAMS facility combustion protocol. California: KCCAMS.
Schuur, EAG, Druffel, ERM, Trumbore, SE. 2016. Radiocarbon and Climate Change; Mechanics, Application and Laboratory Techniques. Irvine (CA): University of California Department of Earth System Science.
Scott, EM, Cook, GT, Naysmith, P. 2010. The fifth international radiocarbon intercomparison (VIRI): An assessment of laboratory performance in stage 3. Radiocarbon 52(2–3):859865.
Steier, P et al. 2013. A new UV oxidation setup for small radiocarbon samples in solution. Radiocarbon 55(2–3):373382.
Stenström, KE et al. 2011. A guide to radiocarbon units and calculations. Lund: Lund University.
Stuvier, M, Polach, H. 1977. Discussion: reporting of 14C data. Radiocarbon 19(3):355363.
Synal, HA, Stocker, M, Suter, M. 2007. MICADS: A new compact radiocarbon AMS system. Nuclear Instruments and Methods in Physics Research B 259:713.
Vandeputte, K, Moens, L, Dams, R. 1996. Improved sealed-tube combustion of organic samples to CO2 for stable carbon isotope analysis, radiocarbon dating and percent carbon determinations. Analytical Letters 29(15):27612773.
Wacker, L, Němec, M, Bourquin, J. 2010a. A revolutionary graphitisation system: fully automated, compact and simple. Nuclear Instruments and Methods in Physics Research B 268(7–8):931934.
Wacker, L, Christl, M, Synal, H. 2010b. Bats: A new tool for AMS data reduction. Nuclear Instruments and Methods in Physics Research B 268(7–8):976979.
Recommend this journal

Email your librarian or administrator to recommend adding this journal to your organisation's collection.

  • ISSN: 0033-8222
  • EISSN: 1945-5755
  • URL: /core/journals/radiocarbon
Please enter your name
Please enter a valid email address
Who would you like to send this to? *



Full text views

Total number of HTML views: 0
Total number of PDF views: 0 *
Loading metrics...

Abstract views

Total abstract views: 0 *
Loading metrics...

* Views captured on Cambridge Core between <date>. This data will be updated every 24 hours.

Usage data cannot currently be displayed