We describe the design and performance of the Engineering Development Array, which is a low-frequency radio telescope comprising 256 dual-polarisation dipole antennas working as a phased array. The Engineering Development Array was conceived of, developed, and deployed in just 18 months via re-use of Square Kilometre Array precursor technology and expertise, specifically from the Murchison Widefield Array radio telescope. Using drift scans and a model for the sky brightness temperature at low frequencies, we have derived the Engineering Development Array’s receiver temperature as a function of frequency. The Engineering Development Array is shown to be sky-noise limited over most of the frequency range measured between 60 and 240 MHz. By using the Engineering Development Array in interferometric mode with the Murchison Widefield Array, we used calibrated visibilities to measure the absolute sensitivity of the array. The measured array sensitivity matches very well with a model based on the array layout and measured receiver temperature. The results demonstrate the practicality and feasibility of using Murchison Widefield Array-style precursor technology for Square Kilometre Array-scale stations. The modular architecture of the Engineering Development Array allows upgrades to the array to be rolled out in a staged approach. Future improvements to the Engineering Development Array include replacing the second stage beamformer with a fully digital system, and to transition to using RF-over-fibre for the signal output from first stage beamformers.

Glyphosate is used in the transition zone to control annual bluegrass in fully dormant warm-season grasses. A suspected resistant (R) biotype of annual bluegrass was identified on a golf course in South Carolina after at least 10 consecutive years of glyphosate application. Greenhouse bioassays revealed the R biotype was 4.4-fold resistant to glyphosate compared with a standard susceptible (S) biotype. Further studies were conducted to investigate the mechanism conferring glyphosate resistance in the R biotype. Leaf discs of both biotypes accumulated shikimate in response to increasing glyphosate concentration, but the glyphosate concentration resulting in 50% EPSP synthase inhibition as a result of shikimate accumulation (I50) was 4.2-fold higher in the R biotype compared with the S biotype. At the whole plant level, similar levels of shikimate accumulation were observed between biotypes at 6 and 24 h after treatment (HAT) with glyphosate, but greater shikimate accumulation occurred in the S biotype at 72, 120, and 168 HAT. Shikimate levels decreased in the R biotype after 72 HAT. There were no differences in 14C-glyphosate absorption between biotypes. However, more 14C-glyphosate translocated out of the treated leaf in the R biotype and into root tissues over time compared with the S biotype. Partial sequencing of the EPSP synthase gene revealed a point mutation that resulted in an Ala substitution at Pro106. Although other mechanisms may contribute to glyphosate resistance, these results confirm a Pro106 to Ala substitution is associated with resistance to glyphosate in the R annual bluegrass biotype.

Energy-dispersive X-ray spectrometry (EDS) is an analytical technique used to determine elemental composition. It is a powerful, easy-to-use, non-destructive technique that can be employed for a wide variety of materials. In this technique the electron beam of the scanning electron microscope (SEM) impinges on the sample and excites atomic electrons causing the production of characteristic X rays. These characteristic X rays have energies specific to elements in the sample. The EDS detector collects these X rays as a signal and produces a spectrum. Samples also can be excited by X rays. Collimated and focused X rays from an X-ray source produce characteristic X rays that can be detected by the same EDS detector. When X rays are used as the source of excitation, the method is then called X-ray fluorescence (XRF) or micro-XRF.