Intracrystalline water adsorption of Ca-montmorillonite was calculated as the product of one-half the interlayer spacing from X-ray powder diffraction analysis and the difference between the desorption surface area determined with ethylene glycol-monoethyl ether and BET surface area determined by N2 adsorption. Osmotic adsorption was calculated as the product of the N2 surface area and theoretical double layer thickness. Measured water adsorption of P2O5-dry clay, compacted to initial densities (γ0) from 0.52 to 1.59 g/cm3 and submerged in 0.01 N CaCl2 was 2.4 to 4.2 times greater than intracrystalline plus osmotic adsorption due to the occurrence of pores exceeding double layer dimensions. The increase in expansion caused by reducing electrolyte concentration to 0.001 N was equal to the predicted increase in double layer volume, verifying the existence of an osmotic component to swelling.

Measured expansion following submersion in 0.01 N CaCl2 increased continuously with γ0 from 0.53 cm3/g at γ0 = 0.52 g/cm3 to 1.17 cm3/g at γ0 = 1.59 g/cm3, while estimated osmotic plus intracrystalline expansion was constant at 0.30 cm3/g. This discrepancy is attributed to swelling caused by gas pressures developing ahead of advancing wetting fronts. The effect of compaction on expansion is explained by reductions in pore size, as measured by N2 desorption, which accompany compaction. Reduced pore size should increase entrapped air pressures, whereas gradual wetting should favor their dissipation. Accordingly, slow wetting reduced the expansion of a sample where γ0 = 1.06 g/cm3 from 0.77 to 0.37 cm3/g. Swelling due to entrapped air pressures produced a large increase in the number of pores > 104 Å in diameter, as determined by Hg intrusion porosimetry.

The behavioural reactions and blood Cortisol levels of cattle stunned using a penetrating captive-bolt pistol whilst standing free in a stunning box were compared with those obtained from cattle similarly stunned but with their heads held in a hydraulically operated chin-lift type of head restrainer. Few (8 out of 55) animals voluntarily put their heads into the restrainer, most had to be ‘persuaded’ to use the head-restrainer; some (5 out of 24) could not be. The mean time between entry into the stunning pen and the stun for 23 free standing animals was 5.6s and for 19 animals which could be persuaded to use the head restrainer was 34.2s. The Cortisol levels in the blood taken at the stick, from 30 animals stunned while standing free was 67.6 nmoVlitre while that from 30 stunned while head-restrained was 143.1 nmolHitre. The behaviour and Cortisol results suggest that enforced usage of this type of head restrainer could be a cause of distress to the cattle involved.

The first demonstration of laser action in ruby was made in 1960 by T. H. Maiman of Hughes Research Laboratories, USA. Many laboratories worldwide began the search for lasers using different materials, operating at different wavelengths. In the UK, academia, industry and the central laboratories took up the challenge from the earliest days to develop these systems for a broad range of applications. This historical review looks at the contribution the UK has made to the advancement of the technology, the development of systems and components and their exploitation over the last 60 years.

We compared systematic and random survey techniques to estimate breeding population sizes of burrow-nesting petrel species on Marion Island. White-chinned (Procellaria aequinoctialis) and blue (Halobaena caerulea) petrel population sizes were estimated in systematic surveys (which attempt to count every colony) in 2009 and 2012, respectively. In 2015, we counted burrows of white-chinned, blue and great-winged (Pterodroma macroptera) petrels within 52 randomized strip transects (25 m wide, total 144 km). Burrow densities were extrapolated by Geographic Information System-derived habitat attributes (geology, vegetation, slope, elevation, aspect) to generate island-wide burrow estimates. Great-winged petrel burrows were found singly or in small groups at low densities (2 burrows ha−1); white-chinned petrel burrows were in loose clusters at moderate densities (3 burrows ha−1); and blue petrel burrows were in tight clusters at high densities (13 burrows ha−1). The random survey estimated 58% more white-chinned petrels but 42% fewer blue petrels than the systematic surveys. The results suggest that random transects are best suited for species that are widely distributed at low densities, but become increasingly poor for estimating population sizes of species with clustered distributions. Repeated fixed transects provide a robust way to monitor changes in colony density and area, but might fail to detect the formation/disappearance of new colonies.

While our fascination with understanding the past is sufficient to warrant an increased focus on synthesis, solutions to important problems facing modern society require understandings based on data that only archaeology can provide. Yet, even as we use public monies to collect ever-greater amounts of data, modes of research that can stimulate emergent understandings of human behavior have lagged behind. Consequently, a substantial amount of archaeological inference remains at the level of the individual project. We can more effectively leverage these data and advance our understandings of the past in ways that contribute to solutions to contemporary problems if we adapt the model pioneered by the National Center for Ecological Analysis and Synthesis to foster synthetic collaborative research in archaeology. We propose the creation of the Coalition for Archaeological Synthesis coordinated through a U.S.-based National Center for Archaeological Synthesis. The coalition will be composed of established public and private organizations that provide essential scholarly, cultural heritage, computational, educational, and public engagement infrastructure. The center would seek and administer funding to support collaborative analysis and synthesis projects executed through coalition partners. This innovative structure will enable the discipline to address key challenges facing society through evidentially based, collaborative synthetic research.

A literature-based compilation of phylogenetic relationships and biometric measurements of 342 Cenozoic planktonic foraminiferal species suggests that the group shows a net increase in size through the Cenozoic, thus appearing to follow Cope's Rule of phyletic size increase. However, when the data are corrected for size-related biases, they do not support the hypothesis that this apparent trend is driven by an organismal adaptive advantage of larger size.

When the planktonic foraminifera return to their “primitive” globigerine morphology during the Eocene-Oligocene transition, there is no indication of size-dependent origination or extinction; however, when the extinction signal is decomposed into pseudoextinctions and true lineage terminations, a differential pulse of pseudoextinction is observed among the smaller forms. This observation suggests that smaller bodied species, rather than surviving stressful times with static morphologies, may evolve their way through times of crisis and go on to found lineages which, by virtue of their initial small size, are stochastically likely to increase in mean size during subsequent diversification. Thus, one general explanation for Cope's Rule might be that smaller bodied species are more adaptively responsive due to their tendency to have shorter generation times. During times of stress, this adaptive responsiveness may give them an advantage that is correlated with, but causally unrelated to, their size.

Thin native oxide layers can dominate the mechanical properties of metallic thin films. However, to date there has been little quantification of how such overlayers affect yield and fracture during indentation in constrained film systems. To gain insight into such processes, electrical contact resistance was measured in situ during nanoindentation on constrained thin films of epitaxial Cr and polycrystalline Al, both possessing a native oxide overlayer. Measurements during loading of the films show both increases and decreases in current, which can then be used to distinguish between various sources of plasticity. Ex situ measurements of the oxide thickness are used to provide a starting point for elasticity simulations of stress in both systems. The results show that dislocation nucleation in the metal film can be differentiated from oxide fracture during indentation.