Obese mothers’ offspring develop obesity and metabolic alterations in adulthood. Poor postnatal dietary patterns also contribute to obesity and its comorbidities. We aimed to determine whether in obese mothers’ offspring an adverse postnatal environment, such as high-fat diet (HFD) consumption (second hit) exacerbates body fat accumulation, metabolic alterations and adipocyte size distribution. Female Wistar rats ate chow (C-5 %-fat) or HFD (maternal obesity (MO)-25 %-fat) from weaning until the end of lactation. Male offspring were weaned on either control (C/C and MO/C, maternal diet/offspring diet) or HFD (C/HF and MO/HF) diet. At 110 postnatal days, offspring were killed. Fat depots were excised to estimate adiposity index (AI). Serum glucose, triglyceride, leptin, insulin, insulin resistance index (HOMA-IR), corticosterone and dehydroepiandrosterone (DHEA) were determined. Adipocyte size distribution was evaluated in retroperitoneal fat. Body weight was similar in C/C and MO/C but higher in C/HF and MO/HF. AI, leptin, insulin and HOMA-IR were higher in MO/C and C/HF v. C/C but lower than MO/HF. Glucose increased in MO/HF v. MO/C. C/HF and MO/C had higher triglyceride and corticosterone than C/C, but lower corticosterone than MO/HF. DHEA and the DHEA/corticosterone ratio were lower in C/HF and MO/C v. C/C, but higher than MO/HF. Small adipocyte proportion decreased while large adipocyte proportions increased in MO/C and C/HF v. C/C and exacerbated in MO/HF v. C/HF. Postnatal consumption of a HFD by the offspring of obese mothers exacerbates body fat accumulation as well as the decrease of small and the increase of large adipocytes, which leads to larger metabolic abnormalities.

Glasses and glass-ceramics of the system Diopside [D, CaMgSi2O6] - Fluorapatite [FAp, Ca5(PO4)3F] were synthesized and characterized. The studied theoretical phase compositions were (wt%): 1) 70% D-30% FAp, 2) 60% D-40% FAp and 3) 80% D-20% FAp. The glass-ceramics were synthesized by isothermal treatment of the corresponding parent glasses at either 800, 900 or 1000 °C, with holding times of either 30 min, 2 h or 5 h at high temperature. The in vitro bioactivities of all materials were tested in Kokubo’s Simulated Body Fluid (SBF), for 21 days at pH = 7.4 and 37 °C. All materials were characterized by X-Ray Diffraction (XRD) and Scanning Electron Microscopy (SEM/EDS). In all cases, the in vitro bioactivity increased with decreasing crystallization degree in the materials, which was likely due to an inhibitory effect of the structural changes occurring during thermal treatment of the glasses. This was more accentuated for long thermal treatments. After 21 days of soaking in the SBF, an apatite-like surface layer, with a Ca/P molar ratio close to 1.67, was formed in the case of the parent glass of composition 2. This was attributed to an enhancing effect of so-called “phase separation” phenomenon that took place during the synthesis of that particular glass. Lastly, the MgO content of the glasses made no clear difference on their in vitro bioactivity.

Hydroxyapatite [HAp, Ca5(PO4)3(OH)] was synthesized by chemical precipitation, using H3PO4 and Ca(OH)2 as chemical precursors. The precursors were slowly mixed in suitable proportions aiming to obtain Ca/P molar ratios of 1.5, 1.67 or 2.0 in the reacting suspension. This was followed by 21.5 h of aging. Both reaction and aging stages were carried out under an atmosphere of still ambient air and under continuous stirring, either at room temperature, 60 or 90 °C. The precipitates were characterized by ICP-AES and XRD. The results suggested that the most suitable Ca/P molar ratio for the production of pure phase HAp is Ca/P = 1.67, as long as the initial Ca(OH)2 particle size and/or the suspension pH are carefully controlled, especially when the synthesis is carried out above room temperature.

BaAl2Si2O8 and SrAl2Si2O8 were synthesized by solid-state reaction of stoichiometric mixtures of either BaCO3 or SrCO3 with coal fly ash and Al2O3. The mixtures were mechanically activated in an attrition mill for up to 12 h and then reaction-sintered at 900-1300 °C, aiming to promote the formation of BaAl2Si2O8 and SrAl2Si2O8 as well as the conversion from their hexagonal (Hexacelsian) into their monoclinic (Celsian) forms, which is associated with improved mechanical properties in the sintered materials. Especially in the case of SrAl2Si2O8, the formation of Celsian was favored at relatively low sintering temperatures by increasing milling time. Although only the SrAl2Si2O8 composition was fully converted into Celsian, the Hexacelsian to Celsian conversions obtained for the mechanically-activated BaAl2Si2O8 composition were significantly higher than those previously reported in the literature for this compound. This could be attributed to the use of coal fly ash as raw material, which contains mineralizers that promote the mentioned conversion.

Glass-ceramics of eutectic composition in the wollastonite [W, CaO⋅SiO2]- tricalcium phosphate [TCP, β-Ca3(PO4)2] binary system were synthesized by using the glass-crystallization method. The parent glass was crystalized at 800-1300 °C for 0.5-5 h. The in vitro bioactivity of the synthesized glass-ceramics was tested in Kokubo’s Simulated Body Fluid (SBF) for 7-21 days, at pH = 7.4 and 37 °C. All materials were characterized by X-Ray Diffraction (XRD) and Scanning Electron Microscopy (SEM/EDS). The results showed that metastable Apatite phase [Ap, Ca10(PO4)6O], plus W and TCP phases expected according to the binary phase diagram, were formed. Ap was the first phase formed at 900 °C/0.5 h, which was followed by formation of W phase at 900 °C/2 h and of TCP phase at 1200 °C/0.5 h. The relative proportion of the formed crystalline phases was a function of heat treatment temperature and time. A eutectic microstructure was obtained for the materials heat-treated at 1300 °C for 2 or 5 h. All glass-ceramics showed the formation of a hydroxyapatite (HAp)-like layer during the in vitro bioactivity tests. After 21 days of soaking in SBF, the samples treated at 1300 °C/5 h showed a behavior similar to that typically shown by Bioeutectic® material, while the materials heat-treated at lower temperatures tended to form denser HAp-like layers, with similar thicknesses but with higher Ca/P molar ratios.

Visual stress (VS) affects reading in 5–12% of the general population and 31–36% of children with reading disorders. Symptoms include print distortions and visual discomfort when reading, and are exacerbated by fluorescent lighting. Prior research has indicated that VS can also affect proficient readers. We therefore examined levels of visual discomfort in a group of expert readers (n = 24) under both standard and spectrally-filtered fluorescent lighting. Participants rated their awareness of six symptoms of VS under each lighting condition. Under the standard condition, 4(16.7%) of the group recorded moderate to high levels of VS. Differences in symptom levels and reading speed between conditions were analysed using the Wilcoxon Signed Rank Test. Under the filter condition, the group reported less discomfort regarding all six symptoms of VS surveyed. The differences were significant with respect to three of the symptoms (p = .029 - p < .001), with a medium effect size in all of them (r = .31 - r = .46) and total score (p = .007; r = .39). Variations in reading proficiency included significantly fewer self-corrections (p = .019) and total errors (p = .004). Here we present evidence that VS-type symptoms of reading discomfort are not confined to populations with reading difficulties and may also occur in proficient readers, and that simple adaptations to fluorescent lighting may alleviate such symptoms.

This study aimed to evaluate the effect of 12 substrates in the seedling growth of chili apple (Capsicum pubescens R. & P.) hybrid Grajales ST. The substrates were prepared with different proportions of five materials: perlite, coconut fiber, loam, Sunshine3 ® and wood dust. The seeds were sown in trays of 50 cavities. For the substrates were determined physical and chemical properties. Significant differences in growth parameters of seedlings are the effect of the substrate. Based on the remarkable accumulation of dry matter of each of the organs of the seedling, and their relative distribution, one can surmise a seedling quality with 47.70 % dry matter in leaves, 35.34 % in stem and 16.95 % in root. The substrate with better features for the production of chile apple seedlings was prepared with 25 % loam and 75 % perlite (v/v), which showed retention of 85.5 % moisture, electrical conductivity of 0.03 dS·m-1 and total porosity of 62.5 %.