Urinary Na excretion is a potential risk factor for CVD. However, the underlying biological mechanisms and effects of salt sensitivity are unclear. The purpose of this study was to characterise the relative contribution of biological factors to the Na–CVD association. A total of 2112 participants were enrolled in this study. Structured questionnaires and blood and urine samples were obtained. Twenty-four-hour Na excretion was estimated using a single overnight urine sample. Hypertension, the metabolic syndrome and overweight status were considered to indicate salt sensitivity. Cox proportional hazard models were used to investigate the effects of salt sensitivity on urinary Na excretion and CVD risk. The traditional mediation approach was used to calculate the proportion of mediation. The mean age (sd) of the 2112 participants was 54·5 (sd 12·2) years, and they were followed up for a mean of 14·1 (sd 8·1) years. Compared with those in the lowest quartile, the highest baseline urinary Na excretion (>4·2 g/24 h) was associated with a 43 % higher CVD risk (hazard ratio, 1·43; 95 % CI 1·02, 1·99). Participants with high urinary Na excretion, hypertension or the metabolic syndrome had a significantly high risk of CVD. The carotid intima-media thickness had the largest mediating effect (accounting for 35 % of the Na–CVD association), followed by systolic blood pressure (BP) (33 %), left ventricular mass (28 %) and diastolic BP (14 %). Higher urinary Na excretion increased the risk of CVD, which was explained largely by carotid media-thickness and systolic BP.

This study aimed to evaluate associations between toxoplasmosis and psychiatric disorders in Taiwan based on the National Health Insurance Research Database, Taiwan (1997–2013). Patients newly diagnosed with toxoplasmosis formed the case group (n = 259), and the control group included propensity-score matched patients without toxoplasmosis (n = 1036). The primary outcome was incidence of psychiatric disorders. Cox proportional hazards regression and stratified analyses were performed to examine risk of developing specific psychiatric disorders between patients with and without toxoplasmosis. Patients with toxoplasmosis had significantly higher incidence of psychiatric disorders than those without toxoplasmosis (P = 0.016). A significant difference was found in numbers of psychiatric disorders between the two groups during 14 years of follow-up (log-rank P < 0.001). Those with toxoplasmosis had significantly higher risk of bipolar disorder [adjusted hazard ratio (aHR = 3.60, 95% confidence interval (CI) = 2.07, 7.26), depression (aHR = 4.94, 95% CI = 2.15, 11.80) and anxiety (aHR = 5.36, 95% CI = 2.98, 25.88), but no significant between-group differences were found for schizophrenia and other psychiatric disorders. In conclusion, the present nationwide population-based analysis revealed that Toxoplasma gondii infection in Taiwan significantly increases the risk for developing bipolar disorder, depression and anxiety, but not for schizophrenia and other psychiatric disorders.

A simple numerical model has been proposed for laser cladding. The model does not involve complex techniques such as cell addition, moving mesh, or prescribing a clad profile with a certain polynomial function. Instead, a mass function has been introduced to register the clad mass deposition on substrate, and from which the clad-track height can be estimated. The model takes several operational parameters, laser power, laser-head speed, and clad powder feeding rate, into consideration and predicts clad-track geometry, dilution, and substrate temperature. Experiments using two different combinations of substrate and clad powder materials to lay single and multiple clad tracks were conducted to provide data for model validation. The results show that the present model returns good agreement with experimental clad profiles for single and multiple tracks.

This study adopted a Kansei engineering methodology to examine users’ Kansei values toward automotive interior designs by conducting experiments under two models: sensory experience and perceived value evaluation models. In the sensory experience model, 60 participants were recruited to experience using 27 vehicle samples and to assign scores to eight Kansei keywords. Hayashi's quantification theory type 1 was used to calculate the weight of 12 interior space items and 40 interior design categories. In the perceived value evaluation model, 60 participants completed a questionnaire on the influence levels of the Kansei keywords on their Kansei values from the perspectives of four consumer perceived value dimensions. The questionnaire scores were then evaluated using factor analysis to extract nine primary factors affecting participants’ perceptions. This study determined that the interesting and dynamic perceptions corresponded to five design items under the Excitement Quality factors, vigorous and recreational perceptions corresponded to four items under the Relaxation and Comfort factor, and technological and luxurious perceptions corresponded to six items under the Luxury and Splendor factor and the Esteemed Image factor. These findings can help designers and researchers in the relevant sectors create automotive interior designs that fulfill the expectations of users.

This paper reports a novel means of integrating a high-performance dual-modal ZnO piezoelectric transducer with a flexible stainless steel substrate (SUS304) to construct dual-modal vibration-power transducers. To fabricate vibration-power transducers, the off-axis RF magnetron sputtering method for the growth of ZnO piezoelectric thin films is adopted. The stainless steel substrate has a higher Young’s modulus than those of the other substrates, and behaves the long-term stability under vibration. The transducer includes a ZnO piezoelectric thin film deposited on the stainless steel substrate combined with Pt/Ti layers at room temperature, which is fabricated by an RF magnetron two-step sputtering system. In this report, the ZnO piezoelectric thin films deposited with the tilting angle of 34° are set by controlling the deposition parameters. Scanning electron microscopy and X-ray diffraction of ZnO piezoelectric thin films reveal a rigid surface structure and a high dual-modal orientation. To investigate the generating characteristics of the dual-modal transducer, two basic experiments of longitudinal and shear modes are carried out. Based on cantilever vibration theory, the cantilever length of 1 cm and a vibration area of 1 cm2 are used to fabricate a transducer with a low resonant-frequency of 65 Hz for the natural vibration. A mass loading at the front-end of the cantilever is critical to increase the amplitude of vibration and the power generated by the piezoelectric transducer. The maximum open circuit voltage of the power transducer is 19.4 V.

A novel allergy biosensor is designed and fabricated by using thin film bulk acoustic resonator (TFBAR) devices with shear mode ZnO piezoelectric thin films. To fabricate TFBAR devices, the off-axis RF magnetron sputtering method for the growth of piezoelectric ZnO piezoelectric thin films is adopted. The influences of the relative distance and sputtering parameters are investigated. In this report, the piezoelectric ZnO thin films with tilting angle are set by controlling the deposition parameters. The properties of the shear mode ZnO thin films are investigated by X-ray diffraction and scanning electron microscopy. The frequency response is measured using an HP8720 network analyzer with a CASCADE probe station. The resonance frequency of the shear mode is 796.75 MHz. The sensitivity of the shear mode is calculated to be 462.5 kHz·cm2/ng.

Three types of Ganium Nitride (GaN) transistors were studied in this work. The devices were fabricated and exhibited unique characteristics over on-state current and off-state blocking performances. We also compared the performance differences of devices fabricated by multiepitaxial GaN/AlGaN layers on different substrates (Sapphire and Si) and evaluated the correlations among starting substrate, device variation, and manufacturing uniformity. The first device is a normally-on device with Sapphire substrate which shows good drain saturation current (Idsat) and breakdown characteristics, but the gate leakage current is quite large. The second device is a normally-off GaN transistor named metal-insulate-semiconductor (MIS) heterojunction field-effect transistor (MIS-HFET) which exhibits good performance with threshold voltage (Vth) of 3V and breakdown voltage (Vbd) of over 1800V. However the third device is a normally-off GaN metal-oxide-semiconductor field-elect transistor (MOSFET) structure which is rather difficult to exhibit good blocking characteristic due to inadequate doping process control of the reduce-surface-field (RESURF) region.

Subcutaneous (s.c.) d-galactose (DG) treatment has been shown to facilitate the development of biomarkers for Alzheimer's disease in C57BL/6J mice. The aim of the present study was to determine whether this treatment in young BALB/cJ mice, another mouse strain, enhanced oxidative stress to similar extents shown in older mice, and to further determine the effects of fructo-oligosaccharide (FO), a prebiotic fibre and vitamin E (antioxidant control) on the DG-induced oxidative damage of lipids, proteins and mitochondrial DNA, and erythrocyte antioxidant enzyme activities. Mice (12 weeks of age, n 40) were divided into four groups: vehicle (s.c. saline)+control (modified rodent chow); DG (s.c. 1·2 g/kg body weight)+control; DG+FO (5 %, w/w); DG+vitamin E (α-tocopherol, 0·2 %). Then, the animals were killed after 52 d of treatment. Another natural ageing (NA) group without any injection was killed at 47 weeks of age, which served as an aged control. The results indicated that the DG treatment enhanced malonaldehyde dimethyl acetal (MDA) levels in the plasma, liver and cerebral cortex, and protein carbonyl levels in the liver and hippocampus to similar levels shown in the NA group. FO, similar to α-tocopherol, systemically normalised DG-induced elevations in the levels of MDA in the plasma, liver and cerebral cortex, protein carbonyls in the liver and hippocampus, hepatic mitochondrial 8-oxo-deoxyguanosine and erythrocyte superoxide dismutase activity. In conclusion, the s.c. DG treatment in younger BALB/cJ mice resembled the oxidative status in older mice. FO supplementation systemically prevented DG-induced oxidative stress, probably through its fermentation products and prebiotic effect.

Although mature seeds of the monogeneric conifer family Cephalotaxaceae sensu stricto have underdeveloped embryos, no definitive studies have been done to classify dormancy in this family. Our primary purpose was to determine the kind of dormancy in seeds of Cephalotaxus wilsoniana and to put the results into a broad phylogenetic context for gymnosperms. The species is of horticultural and medicinal value, and information is needed on how to propagate it efficiently from seeds. Embryo growth and germination were monitored for seeds at warm, cold and warm plus cold temperatures, and germination was monitored for seeds subjected to: (1) cold →  warm →  cold →  warm; and (2) warm →  cold →  warm →  cold →  warm temperature sequences. The effects of gibberellic acids GA3 and GA4 were tested on radicle emergence in ungerminated seeds and on shoot emergence in root-emerged seeds. Germination was promoted by ≥ 36 weeks of warm stratification followed by ≥ 8 weeks of cold stratification, but only if seeds were returned to high temperatures. The underdeveloped embryo must increase in length by >120% before the radicle emerges. Neither GA3 nor GA4 was effective in promoting radicle emergence; however, both plant growth regulators increased rate (but not percentage) of shoot emergence in root-emerged seeds. We conclude that seeds of C. wilsoniana have the deep simple level of morphophysiological dormancy (MPD), C1b-C3-B1b; thus, warm stratification followed by cold stratification and then warm-temperature incubation are required for germination. In gymnosperms, MPD is known in cycads, Ginkgo and now in three families of conifers.

Intact seeds (seed+endocarp) from freshly harvested fruits of Prunus campanulata were dormant, and required 4–6 weeks of warm followed by 8 weeks of cold stratification for maximum germination percentage. Removing both endocarp and seed coat, however, promoted germination in a high percentage of non-stratified seeds. Treatment of intact, non-stratified seeds with gibberellic acid (GA3) was only partially effective in breaking dormancy. However, GA3 promoted germination of non-stratified seeds in which the endocarp (but not the seed coat) had been removed. The order of abscisic acid (ABA) concentration in fresh seeds was endocarp > seed coat > embryo, and its concentration in endocarp plus seed coat was about 6.2-fold higher than that in the embryo. Total ABA contents of seeds subjected to warm and/or cold moist stratification were reduced 6- to 12-fold. A higher concentration of GA4 was detected in embryos of non-dormant than in those of dormant seeds. Fluridone, a carotenoid biosynthesis inhibitor, was efficient in breaking dormancy of Prunus seeds. Paclobutrazol, a GA biosynthesis inhibitor, completely inhibited seed germination, and the inhibitory effect could be partially reversed by GA4, but not by GA3. Thus, dormancy in P. campanulata seeds is imposed by the covering layers. Dormancy break is accompanied by a decrease in ABA content of the covering layers and germination by an increase of embryonic GA4 content.

In this paper, location-controlled Silicon crystal grains are fabricated by a novel excimer laser crystallization method. An array of 1.8-μm-sized disk-liked grains are formed by this method, and the high-performance n-channel LTPS TFTs with field-effect-mobility reaching 308 cm2/Vs can be fabricated owing to the artificially-controlled lateral grain growth. This position-manipulated Silicon grains are essential to high performance and good uniformity thin film transistors.