In order to gain a better understanding of clay and Fe (oxyhydr)oxide minerals formed during pedogenesis of basalts in tropical monsoonal Hainan (southern China), a basalt-derived lateritic soil at Nanyang, Hainan, was investigated comprehensively. The results show that the lateritic regolith consists uniformly of kaolinite and Fe (oxyhydr)oxide minerals, with trace gibbsite only in the AE horizon. Abundant dioctahedral smectite in the basalt bedrock formed due to primary hydrothermal alteration, and transformed to kaolinite rapidly in the highly weathering saprolite horizon. The ‘crystallinity’ of kaolinite is notably low and its Hinckley index fluctuates along the soil profile, resulting from intense ferrolysis due to fluctuations between wet/dry climate conditions. From the base to the top of the profile, maghemite shows a decreasing trend, whereas magnetite, hematite, and goethite exhibit a slightly increasing trend, indicating that maghemite formed as an initial product of basalt weathering. Formation of Fe (oxyhydr)oxide species in basalt-derived soil is mainly controlled by local environmental conditions such as soil moisture, redox, and acidic conditions; thus, iron mineral-based paleoclimatic proxies could not be used for subtropical to tropical soils. The highly weathered saprolite has a similar δ56Fe value (+0.06‰) to that (+0.07‰) of the parent rock, while the AE to middle E horizons have greater δ56Fe values of +0.12‰ to +0.19‰. Fe isotopic signatures correlate positively with the Fe mass transfer coefficient (R2=0.77, n=6, ρ<0.05), indicating repetitive weathering and relative accumulation of isotopically heavier Fe in the upper soil horizons, which occurred by reductive dissolution of organic matter under oxic conditions, as reflected by the greater U/Th.

Mud shale is characterized by low strength and strong swelling, with rheological effects and deformation caused by drilling fluid and formation water. Establishing a rheological model to characterize the deformation characteristics is key to solving the problem of wellbore stability. The influence of moisture content on rock strength and creep mechanical properties were studied by means of water absorption, uniaxial compression, and creep tests. The tests showed that with the increase in moisture content, the elastic modulus and strength of hard brittle mud shale decreased. Further, under the same load, the instantaneous strain increased with increasing moisture content. Meanwhile, under various loading stresses, rock creep exhibited non-linear characteristics, which can be divided into three different creep stages: attenuated creep, stable creep, and accelerated creep. Starting with a non-linear viscous dashpot, and then introducing aging degradation and water-bearing weakening effects, based on the water-bearing creep characteristics of hard brittle shale as well as the modeling ideas of the classic component combination model, a new improved creep model based on the Nishihara model was established to describe the characteristics of the accelerated creep stage of hard brittle mud shale with various moisture contents. Subsequently, the Levenberg–Marquardt non-linear, least-squares method was adopted to invert the creep parameters. The results showed that the simulated creep curves achieved by employing the new creep model were consistent with the experimental results, thereby confirming the ability of the new non-linear creep model to provide a theoretical reference for the study of wellbore stability of hard brittle mud shale.

REAP-2 is an interactive dose-response curve estimation tool for Robust and Efficient Assessment of drug Potency. It provides user-friendly dose-response curve estimation for in vitro studies and conducts statistical testing for model comparisons with a redesigned user interface. We also make a major update of the underlying estimation method with penalized beta regression, which demonstrates great reliability and accuracy in dose estimation and uncertainty quantification. In this note, we describe the method and implementation of REAP-2 with a highlight on potency estimation and drug comparison.

Rodents and shrews are major reservoirs of various pathogens that are related to zoonotic infectious diseases. The purpose of this study was to investigate co-infections of zoonotic pathogens in rodents and shrews trapped in four provinces of China. We sampled different rodent and shrew communities within and around human settlements in four provinces of China and characterised several important zoonotic viral, bacterial, and parasitic pathogens by PCR methods and phylogenetic analysis. A total of 864 rodents and shrews belonging to 24 and 13 species from RODENTIA and EULIPOTYPHLA orders were captured, respectively. For viral pathogens, two species of hantavirus (Hantaan orthohantavirus and Caobang orthohantavirus) were identified in 3.47% of rodents and shrews. The overall prevalence of Bartonella spp., Anaplasmataceae, Babesia spp., Leptospira spp., Spotted fever group Rickettsiae, Borrelia spp., and Coxiella burnetii were 31.25%, 8.91%, 4.17%, 3.94%, 3.59%, 3.47%, and 0.58%, respectively. Furthermore, the highest co-infection status of three pathogens was observed among Bartonella spp., Leptospira spp., and Anaplasmataceae with a co-infection rate of 0.46%. Our results suggested that species distribution and co-infections of zoonotic pathogens were prevalent in rodents and shrews, highlighting the necessity of active surveillance for zoonotic pathogens in wild mammals in wider regions.

According to the public data collected from the Health Commission of Gansu Province, China, regarding the COVID-19 pandemic during the summer epidemic cycle in 2022, the epidemiological analysis showed that the pandemic spread stability and the symptom rate (the number of confirmed cases divided by the sum of the number of asymptomatic cases and the number of confirmed cases) of COVID-19 were different among 3 main epidemic regions, Lanzhou, Linxia, and Gannan; both the symptom rate and the daily instantaneous symptom rate (daily number of confirmed cases divided by the sum of daily number of asymptomatic cases and daily number of confirmed cases) in Lanzhou were substantially higher than those in Linxia and Gannan. The difference in the food sources due to the high difference of the population ethnic composition in the 3 regions was probably the main driver for the difference of the symptom rates among the 3 regions. This work provides potential values for prevention and control of COVID-19 in different regions.

In vitro rearing of honey bee larvae is ideal for bioassay studies; no honey bee stable cell lines are available. Inconsistency of internal development staging of reared larvae and a susceptibility to contamination are common problems encountered. Standardized protocols on rearing larvae in vitro to make the larvae growth and development more similar to that of natural colonies are necessary to ensure the accuracy of experimental results and promote honey bee research as a model organism. Here, we concluded that when larval fasting weight was >160 mg, the time point of gut emptying can be defined as the critical point separating the larval and prepupal stages. In this way, we can conduct precise studies on the prepupal stage, such as organ remodeling during metamorphosis. Simultaneously, we further verified that recombinant AccApidaecin in genetic engineered bacteria added to the larval diet upregulated antibacterial peptide gene expression, and did not stimulate the stress response in larvae, nor did it affect the pupation rate or eclosion rate. This demonstrated that feeding recombinant AccApidaecin can enhance the individual antibacterial ability at the molecular level.

It is generally accepted that high-oleic crops have at least 70% oleate. As compared to their normal-oleic counterparts, oil and food products made from high-oleic peanut have better keeping quality and are much healthier. Therefore, high-oleic peanut is well recognized by processors and consumers. However, owing to the limited availability of high-oleic donors, most present-day high-oleic peanut varietal releases merely have F435 type FAD2 mutations. Through screening of a mutagenized peanut population of 15L46, a high-yielding peanut line with desirable elliptical oblong large seeds, using near infrared model for predicting oleate content in individual single seeds, high-oleic peanut mutants were identified. Sequencing FAD2A and FAD2B of the mutants along with the wild type revealed that these mutants possessed G448A FAD2A (F435 type FAD2A mutation) and G558A FAD2B (non-F435 type FAD2B mutation). Expression of the wild and mutated type FAD2B in yeast verified that the functional mutation contributed to the high-oleic phenotype in these mutants. The mutants provided additional high-oleic donors to peanut quality improvement.

In this paper, the generation of relativistic electron mirrors (REMs) and the reflection of an ultra-short laser off this mirrors are discussed, applying two-dimensional particle-in-cell (2D-PIC) simulations. REMs with ultra-high acceleration and expanding velocity can be produced from a solid nanofoil illuminated normally by an ultra-intense femtosecond laser pulse with a sharp rising edge. Chirped attosecond pulse can be produced through the reflection of a counter-propagating probe laser off the accelerating REM. In the electron moving frame, the plasma frequency of the REM keeps decreasing due to its rapidly expanding. The laser frequency, on the contrary, keeps increasing due to the acceleration of REM and the relativistic Doppler shift from the lab frame to the electron moving frame. Within an ultra-short time interval, the two frequencies will be equal in the electron moving frame, which leads the resonance between laser and REM. The reflected radiation near this interval and the corresponding spectra will be amplified due to the resonance. Through adjusting the arriving time of the probe laser, certain part of the reflected field could be selectively amplified or depressed, leading to the selectively adjusting of the corresponding spectra.

Protein content (PC) and oil content (OC) are important breeding traits of soybean [Glycine max (L.) Merr.]. Quantitative trait locus (QTL) mapping for PC and OC is important for molecular breeding in soybean; however, the negative correlation between PC and OC influences the accuracy of QTL mapping. In the current study, a four-way recombinant inbred lines (FW-RILs) population comprising 160 lines derived from the cross (Kenfeng14 × Kenfeng15) × (Heinong48 × Kenfeng19) was planted in eight different environments and PC and OC measured. Conditional and unconditional QTL analyses were carried out by interval mapping (IM) and inclusive complete IM based on linkage maps of 275 simple sequences repeat markers in a FW-RILs population. This analysis revealed 59 unconditional QTLs and 52 conditional QTLs among the FW-RILs. An analysis of additive effects indicated that the effects of 13 protein QTLs were not related to OC, whereas OC affected the expression of 13 and eight QTLs either partially or completely, respectively. Eight QTLs affecting OC were not influenced by PC, whereas six and 26 QTLs were partially and fully affected by PC, respectively. Among the QTLs detected in the current study, two protein QTLs and five oil QTLs had not been previously reported. These findings will facilitate marker-assisted selection and molecular breeding of soybean.

In inertial confinement fusion experiments that involve short-laser pulses such as fast ignition (FI), diagnosis of neutrons is usually very challenging because high-intensity γ rays generated by short-laser pulses would mask the much weaker neutron signal. In this paper, fast-response scintillators with low afterglow and gated microchannel plate photomultiplier tubes are combined to build neutron time-of-flight (nTOF) spectrometers for such experiments. Direct-drive implosion experiments of deuterium-gas-filled capsules were performed at the Shenguang-II Upgrade (SG-II-UP) laser facility to study the compressed fuel areal density (〈ρR〉) and evaluate the performance of such nTOF diagnostics. Two newly developed quenched liquid scintillator detectors and a gated ultrafast plastic scintillator detector were used to measure the secondary DT neutrons and primary DD neutrons, respectively. The secondary neutron signals were clearly discriminated from the γ rays from (n, γ) reactions, and the compressed fuel areal density obtained with the yield-ratio method agrees well with the simulations. Additionally, a small scintillator decay tail and a clear DD neutron signal were observed in an integrated FI experiment as a result of the low afterglow of the oxygen-quenched liquid scintillator.

Introduction: To investigate the effects of paroxetine (PAR) on motor and cognitive function recovery in patients with non-depressed ischemic stroke (nD-AIS).

Methods: One hundred sixty-seven patients hospitalized for non-depressed acute ischemic stroke were selected and divided into treatment (T) and control (C) groups using a random number table. All patients received conventional secondary ischemic stroke prevention and rehabilitation training; patients in Group T additionally received treatment with PAR (10 mg/day during week 1 and 20 mg/day thereafter) for 3 months. The follow-up observation lasted 6 months. The Fugl–Meyer motor scale (FMMS), Montreal cognitive assessment (MoCA), and Hamilton depression scale (HAMD) were used on D0, D15, D90, and D180 (T0, 1, 2, and 3, respectively; D180 = 90 days after treatment cessation) after study initiation, and scores were compared between the groups.

Results: The FMMS and MoCA scores differed significantly between Groups T and C at T2 and T3 (p < .05); by contrast, these scores did not differ significantly between the groups at T1 (p > .05). Furthermore, the HAMD scores differed significantly between the two groups at T3 (p < .05), but not at T1 and T2 (p > .05).

Conclusions: PAR treatment may improve motor and cognitive function recovery in patients with nD-AIS. Moreover, PAR may reduce the occurrence of depression after stroke.