This paper retrospectively analysed the prevalence of macrolide-resistant Mycoplasma pneumoniae (MRMP) in some parts of China. Between January 2013 and December 2019, we collected 4,145 respiratory samples, including pharyngeal swabs and alveolar lavage fluid. The highest PCR-positive rate of M. pneumoniae was 74.5% in Beijing, the highest resistance rate was 100% in Shanghai, and Gansu was the lowest with 20%. The highest PCR-positive rate of M. pneumoniae was 74.5% in 2013, and the highest MRMP was 97.4% in 2019; the PCR-positive rate of M. pneumoniae for adults in Beijing was 17.9% and the MRMP was 10.48%. Among the children diagnosed with community-acquired pneumonia (CAP), the PCR-positive and macrolide-resistant rates of M. pneumoniae were both higher in the severe ones. A2063G in domain V of 23S rRNA was the major macrolide-resistant mutation, accounting for more than 90%. The MIC values of all MRMP to erythromycin and azithromycin were ≥ 64 μg/ml, and the MICs of tetracycline and levofloxacin were ≤ 0.5 μg/ml and ≤ 1 μg/ml, respectively. The macrolide resistance varied in different regions and years. Among inpatients, the macrolide-resistant rate was higher in severe pneumonia. A2063G was the common mutation, and we found no resistance to tetracycline and levofloxacin.

The passive film of reinforcing steel in marine concrete is damaged by the infiltration of chloride and sulfate ions. Layered double hydroxide (LDH) can adsorb anions and release interlayer ions to form passive films due to its ion exchange property. A Mg-Al-NO3 layered double hydroxide/montmorillonite (LDH/Mnt) composite inhibitor was prepared by layer-by-layer self-assembly (LBL) of LDH and Mnt. The structure and morphology of the LDH/Mnt composites were characterized by X-ray diffraction (XRD), laser Raman spectroscopy, N2-adsorption/desorption measurements, and transmission electron microscopy (TEM). The LDH/Mnt composites, as inhibitors of chloride ions and sulfate ions, exhibited high slow-release efficiency. The mass ratio of LDH and Mnt affected the curing capacity of the synthesized composites, and the optimum mass ratio was LDH/Mnt = 1:1 for which slow-release efficiency reached 94.16%.

Soil aggregates consist of sand, silt, and clay size particles. Many of the clay size particles in soils are clay minerals, which actively influence soil behavior. The properties of clay minerals may change significantly as soil particle size decreases to the nanoscale; however, little information is available about these properties for the Ultisols in China. In the present study, the clay mineral components and structural characteristics of four particle-size fractions (i.e., <2000, 450–2000, 100–450, and 25–100 nm) of two Ultisol samples (Ult-1 and Ult-2) were investigated using elemental analysis, X-ray diffraction, Fouriertransform infrared spectroscopy, and thermal analysis. The molar SiO2 to Al2O3 ratios were lower in the nanoscale particle-size fraction (25–100 nm) than in the 450–2000 and <2000 nm fractions. This indicates greater desilicification and allitization of the smaller Ultisol particles. Furthermore, the Fe oxide and Al oxide contents increased and reached a maximum level in the 25–100 nm fraction of the two Ultisols. Goethite was mainly found in the 100–450 nm and 25–100 nm fractions. The dominant clay minerals in the Ultisol 25–100 nm fraction were kaolinite and illite with a small amount of a hydroxy-interlayered mineral in Ult-1 and gibbsite in Ult-2. The kaolinite crystallinity decreased as particle size decreased. The low crystallinity of the kaolinite in the A horizon 25–100 nm fraction was attributed to a reduction in the thickness of coherent scattering domains, as well as to decreases in OH groups and the dimensions of octahedral AlO6 sheets. A determination of the chemical and mineralogic properties of the different size fractions of the Ultisols is important to understand the desilicification and Al and Fe oxide enrichment mechanisms during soil formation. The significance of these results can help to reveal the nanoscale transformations of clay minerals. Analysis of clay mineral compositions in nanoparticles can provide the additional data needed to understand the adsorption and mobility of nutrients and pollutants.

X-ray powder diffraction data for 5-Chloro-N-(4-nitrophenyl)pentanamide, C11H13ClN2O3, are reported [a = 8.036(4) Å, b = 15.972(5) Å, c = 9.829(5) Å, α = 90°, β = 104.227(2)°, γ = 90°, V = 1222.98 Å3, Z = 4, ρx = 1.3941 g cm−3 and space group P21/c]. All measured lines were indexed and are consistent with the P21/c space group. No detectable impurities were observed.

X-ray powder diffraction data for piperaquine, C29H32Cl2N6, are reported [a = 15.8865(1) Å, b = 12.5975(3) Å, c = 13.2647(3) Å, β = 91.2890(1)°, unit-cell volume V = 2654.02 Å3, Z = 4, and space group P21/n]. All measured lines were indexed and are consistent with the P21/n space group. No detectable impurities were observed.

Nanogenerators (NGs) have great potential to solve the problems of energy depletion and environmental pollution. Here, two types of flexible nanogenerators (FNGs) based on graphene oxide (GO) and multiwall carbon nanotubes (MW-CNTs) are presented. The peak output voltage and current of GO based FNG reached up to 2 V and 30 nA, respectively, under 15 N force at 1 Hz. Moreover, the output voltage could be improved to 34.4 V when the frequency was increased to 10 Hz. It was also found the output voltage increased from 0.1 V to 2.0 V using a released GO structure. The other FNG was made by MW-CNTs mixed with ZnO nanoparticles (NPs). Its output voltage and power reached up to 7.5 V and 18.75 mW, respectively, which is much larger than that of bare ZnO based FNG. Furthermore, a peak voltage of 30 V could be gained by stamping one’s foot on the FNG. Finally, a modified NG was fabricated using four springs and two flexible layers. As a result, the voltage and power reached up to 9 V and 27mW, respectively. These works may bring out broad applications in energy harvesting.

Interspecies intracytoplasmic sperm injection has been carried out to understand species-specific differences in oocyte environments and sperm components during fertilization. While sperm aster organization during cat fertilization requires a paternally derived centriole, mouse and hamster fertilization occur within the maternal centrosomal components. To address the questions of where sperm aster assembly occurs and whether complete fertilization is achieved in cat oocytes by interspecies sperm, we studied the fertilization processes of cat oocytes following the injection of cat, mouse, or hamster sperm. Male and female pronuclear formations were not different in the cat oocytes at 6 h following cat, mouse or hamster sperm injection. Microtubule asters were seen in all oocytes following intracytoplasmic injection of cat, mouse or hamster sperm. Immunocytochemical staining with a histone H3-m2K9 antibody revealed that mouse sperm chromatin is incorporated normally with cat egg chromatin, and that the cat eggs fertilized with mouse sperm enter metaphase and become normal 2-cell stage embryos. These results suggest that sperm aster formation is maternally dependent, and that fertilization processes and cleavage occur in a non-species specific manner in cat oocytes.

Epidermal growth factor receptor (EGFR) is becoming a perfect target for killing carcinoma cells, especially because of its overexpression on the surface of these cells. Cationic antimicrobial peptides (CAP) have their own special mechanism of membrane-lytic cytotoxicity. In this study, a membrane-lytic immunotoxin (IT), chimeric protein MEGFMEL, was constructed to kill carcinoma cells with EGFR overexpression. This protein is composed of mouse (Mus musculus) epidermal growth factor (MEGF), as the target part, and melittin (MEL), as the cytotoxic part. Using Escherichia coli BL21 and pET30a as expression strain and vector, respectively, 63.45 μg/ml of MEGFMEL (68% purity) was obtained through low-temperature induction of expression and a thawing-freezing purification procedure (without cytolysis). In vitro activity measurement showed that this MEGFMEL significantly induced a lethal effect on A431 carcinoma cells overexpressing EGFR on the surface, with an LD50 value 52.6 μg/ml. The results suggest that the use of CAP as the toxin in the construction of unique membrane-lytic ITs aimed at EGFR is feasible.

Zebrafish (Danio rerio), the only vertebrate organism now amenable to large scale of “saturation genetic screens”, provides a single opportunity to investigate the complex gene mechanisms for normally vertebrate-specific processes. Studies of bone formation and bone diseases utilizing zebrafish system are therefore of interest. In the present study, microstructure and mechanical properties of skeletal bone in gene-mutated Stöpsel dtl28d (stp/stp) and wild-type zebrafish were investigated using transmission electron microscopy (TEM) and an atomic force microscopy (AFM)-based nanoindenter. Abnormal collagen matrix and minerals were observed in stp/stp bone comparing to the wild-type control. Nanoindentation measurement disclosed that there was a significant increase of elastic modulus in stp/stp bone compared to that of the control. AFM examinations of the residual indenter impressions indicate that the bone of zebrafish becomes more brittle after stp gene-mutation. This observation of the alteration of bone collagen, minerals and mechanical behavior by gene-mutation in zebrafish system is of scientific and clinical importance in many fields, such as bone fracture and brittleness in human heritable disorders and materials fabrication of bone tissue engineering via gene control.

A pair of mutant mice with a first sparse coat appeared spontaneously in the production stock of BALB/c mice with a normal coat. After being sib-mated, they produced three phenotypes in their progeny: mice with normal hair, mice with a first sparse coat and then a fuzzy coat, and uncovered mice. Genetic studies revealed the mutants had inherited an autosomal monogene that was semi-dominant. By using 11 biochemical loci – Idh, Car2, Mup1, Pgm1, Hbb, Es1, Es10, Gdc, Ce2, Mod1 and Es3 – as genetic markers, two-point linkage tests were made. The results showed the gene was assigned to chromosome 11. The result of a three-point test with Es3 and D11Mit8 (microsatellite DNA) as markers showed that the mutation was linked to Es3 with the recombination fraction 7·89±2·19%, and linked to D11Mit8 with the recombination fraction 26·30±3·57%. The recombination fraction between Es3 and D11Mit8 was 32·90±3·81%. It is suggested that the mutation is a new genetic locus that affected the skin and hair structure of the mouse. The mutation was named uncovered, with the symbol Uncv. Further studies showed the mutation affected not only the histology of skin and hair but also the growth and reproductive performance of the mice. The molecular characterization of the Uncv locus needs to be further studied.