The multiple-group categorical factor analysis (FA) model and the graded response model (GRM) are commonly used to examine polytomous items for differential item functioning to detect possible measurement bias in educational testing. In this study, the multiple-group categorical factor analysis model (MC-FA) and multiple-group normal-ogive GRM models are unified under the common framework of discretization of a normal variant. We rigorously justify a set of identified parameters and determine possible identifiability constraints necessary to make the parameters just-identified and estimable in the common framework of MC-FA. By doing so, the difference between categorical FA model and normal-ogive GRM is simply the use of two different sets of identifiability constraints, rather than the seeming distinction between categorical FA and GRM. Thus, we compare the performance on DIF assessment between the categorical FA and GRM approaches through simulation studies on the MC-FA models with their corresponding particular sets of identifiability constraints. Our results show that, under the scenarios with varying degrees of DIF for examinees of different ability levels, models with the GRM type of identifiability constraints generally perform better on DIF detection with a higher testing power. General guidelines regarding the choice of just-identified parameterization are also provided for practical use.

A speeded item response model is proposed. We consider the situation where examinees may retain the harder items to a later test period in a time limit test. With such a strategy, examinees may not finish answering some of the harder items within the allocated time. In the proposed model, we try to describe such a mechanism by incorporating a speeded-effect term into the two-parameter logistic item response model. A Bayesian estimation procedure of the current model using Markov chain Monte Carlo is presented, and its performance over the two-parameter logistic item response model in a speeded test is demonstrated through simulations. The methodology is applied to physics examination data of the Department Required Test for college entrance in Taiwan for illustration.

Malnutrition is a key factor in metabolic syndrome (MS) and sarcopenia, assessing the nutritional status of these patients is a pressing issue. The purpose of this study was to clarify sarcopenia and sarcopenic obesity in patients with MS based on nutritional status. This was a case–control study between MS/non-MS. Body composition was measured by dual-energy X-ray absorptiometry. Muscle function was assessed by handgrip strength, five times sit-to-stand test, gait speed test and short physical performance battery (SPPB). The Mini Nutritional Assessment (MNA) was performed to assess the nutritional status in the participants in this study. Overall, a total of 56 % and 13 % of participants suffered from possible sarcopenia and sarcopenia, respectively. There was a higher rate of possible sarcopenic obesity in the MS group than in the non-MS group (48·9 % v. 24·7 %, P < 0·01), and all the sarcopenia participants in the MS group had sarcopenic obesity. MNA score was significantly associated with sarcopenia status (P < 0·01). The MNA combined with body fat score showed better acceptable discrimination for detecting sarcopenic obesity and sarcopenia in MS (AUC = 0·70, 95 % CI 0·53, 0·86). In summary, there was a higher prevalence of possible sarcopenic obesity in MS, and all the MS patients with sarcopenia had sarcopenic obesity in the present study. We suggest that the MNA should be combined with body fat percentage to assess the nutritional status of MS participants, and it also serves as a good indicator for sarcopenia and sarcopenic obesity in MS.

The purpose of this study was to investigate the effects of 8-week green tea extract (GTE) supplementation on promoting postexercise muscle glycogen resynthesis and systemic energy substrate utilisation in young college students. A total of eight healthy male participants (age: 22·0 (se 1·0) years, BMI: 24·2 (se 0·7) kg/m2, VO2max: 43·2 (se 2·4) ml/kg per min) participated in this study. GTE (500 mg/d for 8 weeks) was compared with placebo in participants in a double-blind/placebo-controlled and crossover study design with an 8-week washout period. Thereafter, all participants performed a 60-min cycling exercise (75 % VO2max) and consumed a carbohydrate-enriched meal immediately after exercise. Vastus lateralis muscle samples were collected immediately (0 h) and 3 h after exercise, and blood and gaseous samples were collected during the 3-h postexercise recovery period. An 8-week oral GTE supplementation had no effects on further promoting muscle glycogen resynthesis in exercised human skeletal muscle, but the exercise-induced muscle GLUT type 4 (GLUT4) protein content was greater in the GTE supplementation trial (P<0·05). We observed that, during the postexercise recovery period, GTE supplementation elicited an increase in energy reliance on fat oxidation compared with the placebo trial (P<0·05), although there were no differences in blood glucose and insulin responses between the two trials. In summary, 8-week oral GTE supplementation increases postexercise systemic fat oxidation and exercise-induced muscle GLUT4 protein content in response to an acute bout of endurance exercise. However, GTE supplementation has no further benefit on promoting muscle glycogen resynthesis during the postexercise period.

The hydrobaric effect on photoactivity of titanium dioxide (TiO2) fabricated by cathodic deposition in an aqueous solution was evaluated in this study. When the applied pressure was increased to 35 MPa, the water-splitting performance was improved by almost fourfold of the performance of the TiO2 prepared at atmospheric pressure. The surface states effect was significant in the deposited TiO2, which was exploited to affect the charges recombination of TiO2, and thereby enhance the resultant photoelectrochemical water-splitting performance. The hydrobaric cathodic deposition could be extended to fabrication of other metal oxides to eliminate the negative influence from the high-temperature process.

Modulation of the cellular response by the administration of probiotic bacteria may be an effective strategy for preventing or inhibiting tumour growth. We orally pre-inoculated mice with probiotics Lactobacillus acidophilus NCFM (La) for 14 d. Subcutaneous dorsal-flank tumours and segmental orthotopic colon cancers were implanted into mice using CT-26 murine colon adenocarcinoma cells. On day 28 after tumour initiation, the lamina propria of the colon, mesenteric lymph nodes (MLN) and spleen were harvested and purified for flow cytometry and mRNA analyses. We demonstrated that La pre-inoculation reduced tumour volume growth by 50·3 %, compared with untreated mice at 28 d after tumour implants (2465·5 (sem 1290·4) v. 4950·9 (sem 1689·3) mm3, P < 0·001). Inoculation with La reduced the severity of colonic carcinogenesis caused by CT-26 cells, such as level of colonic involvement and structural abnormality of epithelial/crypt damage. Moreover, La enhanced apoptosis of CT-26 cells both in dorsal-flank tumour and segmental orthotopic colon cancer, and the mean counts of apoptotic body were higher in mice pre-inoculated with La (P < 0·05) compared with untreated mice. La pre-inoculation down-regulated the CXCR4 mRNA expressions in the colon, MLN and extra-intestinal tissue, compared with untreated mice (P < 0·05). In addition, La pre-inoculation reduced the mean fluorescence index of MHC class I (H-2Dd, -Kd and -Ld) in flow cytometry analysis. Taken together, these findings suggest that probiotics La may play a role in attenuating tumour growth during CT-26 cell carcinogenesis. The down-regulated expression of CXCR4 mRNA and MHC class I, as well as increasing apoptosis in tumour tissue, indicated that La may be associated with modulating the cellular response triggered by colon carcinogenesis.

The optimized N2O fluence is demonstrated for plasma enhanced chemical vapor deposition (PECVD) of Si-rich substoichiometric silicon oxide (SiOx) films with buried Si nanocrystals. Strong room-temperature photoluminescence (PL) at 550-870 nm has been observed in SiOx films grown by PECVD under a constant SiH4 fluence of 20 sccm with an N2O fluence varying from 105 sccm to 130 sccm. A 22-nm-redshift in the central PL wavelength has been detected after annealing from 15 min to 180 min. The maximum PL irradiance is observed from the SiOx film grown at the optimal N2O fluence of 120 sccm after annealing for 30 minutes. Larger N2O fluence or longer annealing time leads to a PL band that is blue-shifted by 65 nm and 20 nm, respectively. Such a blue shift is attributed to shrinkage in the size of the Si nanocrystals with the participation of oxygen atoms from N2O incorporated within the SiOx matrix. The (220)-oriented Si nanocrystals exhibit radii ranging from 4.4 nm to 5.0 nm as determined by transmission electron microscopy (TEM). The luminescent lifetime lengthens to 52 μs as the nc-Si size increase to > 4 nm. Optimal annealing times for SiOx films prepared at different N2O fluences are also reported. A longer annealing process results in a stronger oxidation effect in SiOx films prepared at higher N2O fluences, yielding a lower PL irradiance at shorter wavelengths. In contrast, larger Si nanocrystals can be precipitated when the N2O fluence becomes lower; however, such a SiOx film usually exhibits weaker PL at longer wavelength due to a lower nc-Si density. These results indicate that a N2O/SiH4 fluence ratio of 6:1 is the optimized PECVD growth condition for the Si-rich SiO2 wherein dense Si nanocrystals are obtained after annealing.

The structures and properties of the HSQ film during the cage/network transformation were studied by curing at 300°C for 1 hour. The experimental results show that the ratio of the network/cage structure of the cured HSQ film increases from 0.21 to 0.39 by curing. The porosity of the cured film increases from 10.0% to 12.3 %, while the refractive index decreases from 1.413 to 1.376 during curing. These results suggest that the dependence of the structure and properties of the HSQ film by curing. The CMP characteristics of HSQ were studied by using different kinds of slurries and surfactant. The CMP results of polishing HSQ suggest that the hardness and charge status of the abrasive, the interaction of the surfactant with the abrasive and film surface significantly affect the polishing results.