Birds in flight are prone to collide with various transparent or reflective structures. While bird–window collision has been recognised as a critical conservation issue, collision with other transparent structures has been less understood. Noise barriers made of transparent materials are considered critical hazards for birds; however, little is known about the bird mortality they cause. We conducted the first nationwide-scale estimates of bird-collision mortality caused by transparent noise barriers (TNBs) along roads in the Republic of Korea. The total length of existing roadside transparent noise barriers was estimated at 1,416 km nationwide (as of 2018), and it had been increasing exponentially. Based on carcass surveys at 25 sites, daily mortality at the observed barriers was 0.335 ± 1.132 birds/km on average, and no difference in observed mortality was detected between both sides of a single barrier and between road types (i.e. local roads and motorways). Finally, we estimated that approximately 186,000 birds (95% confidence interval: 162,465–204,812 birds) are killed annually by collisions with roadside TNBs. As privately installed barriers were not considered in this study, the actual mortality is likely be higher than our estimates. Thus, collision with TNBs could become an emerging threat to avian conservation, especially in developing and urbanising regions around the world. As such structures are not formally recognised as conservation issues of importance, more systematic surveys aided by citizen science, both for the status of TNBs and bird-collision mortality, are needed in addition to management and mitigation policies.

The efficiency of halide perovskite solar cells has progressed rapidly through a series of major breakthroughs. Currently, a certified efficiency of 25.2% has been achieved for a solar cell using a polycrystalline thin film. This is the result of having reached 75% of the Shockley–Queisser limit for single-junction solar cells. However, for further improvements, new breakthrough technologies are required. This article reviews the impact of previous breakthrough technologies on the efficiency of halide perovskite solar cells, based on certified efficiencies. We clarify the current status of halide perovskite solar cells and introduce photon recycling as the next technological innovation for higher efficiencies. Photon recycling keeps the photon concentration inside the light-harvesting layer high, and consequently, leads to open-circuit voltages close to the theoretical value. Although photon recycling has not yet been implemented in real halide perovskite solar cells, three key technologies for implementing it are examined.

The experiments reported in this research paper aimed to determine the effect of supplementing different forms of L-methionine (L-Met) and acetate on protein synthesis in immortalized bovine mammary epithelial cell line (MAC-T cells). Treatments were Control, L-Met, conjugated L-Met and acetate (CMA), and non-conjugated L-Met and Acetate (NMA). Protein synthesis mechanism was determined by omics method. NMA group had the highest protein content in the media and CSN2 mRNA expression levels (P < 0.05). The number of upregulated and downregulated proteins observed were 39 and 77 in L-Met group, 62 and 80 in CMA group and 50 and 81 in NMA group from 448 proteins, respectively (P < 0.05). L-Met, NMA and CMA treatments stimulated pathways related to protein and energy metabolism (P < 0.05). Metabolomic analysis also revealed that L-Met, CMA and NMA treatments resulted in increases of several metabolites (P < 0.05). In conclusion, NMA treatment increased protein concentration and expression level of CSN2 mRNA in MAC-T cells compared to control as well as L-Met and CMA treatments through increased expression of milk protein synthesis-related genes and production of the proteins and metabolites involved in energy and protein synthesis pathways.

Little is known about longitudinal changes of the first twin presentation in twin gestations. This is a retrospective cohort study including 411 women who were admitted consecutively and delivered live-born twins at 36 weeks of gestation or more. Longitudinal assessment of the first twin presentation was conducted during gestation and at birth in all cases. Gestational age at antenatal assessment was divided into two intervals: early-third trimester (28–31 weeks) and mid-third trimester (32–35 weeks). Fetal presentation was categorized as vertex or non-vertex. We analyzed change of fetal presentation between antepartum intervals and birth. First twin presentation at early-third trimester had the same presentation at birth in 87.6% (360/411) of the study population. In this ‘no change’ group, vertex presentation was seen in 95.6% (283/296) and non-vertex was seen in 67.0% (77/115) of cases. In total, 96.1% (395/411) of the study population maintained their presentation between mid-third trimester and birth. Vertex presentation was seen in 98.4% (310/315) and non-vertex was seen in 88.5% (85/96) of cases. When comparing vertex with non-vertex, vertex presentation during third trimester was a more reliable predictor of presentation at birth (p < .001). The only factor that contributed significantly to spontaneous version of the first twin during mid-third trimester and birth was a lower birth weight of the first twin compared with the second twin. In conclusion, first twin presentation with vertex during third trimester is not likely to change into non-vertex at birth. We concluded that vertex presentation in twin gestations at early- and mid-third trimester is very predictable. In contrast, a non-vertex first twin presentation is relatively unstable.

We report on the formation of highly flexible and transparent TiO2/Ag/ITO multilayer films deposited on polyethylene terephthalate substrates. The optical and electrical properties of the multilayer films were investigated as a function of oxide thickness. The transmission window gradually shifted toward lower energies with increasing oxide thickness. The TiO2 (40 nm)/Ag (18 nm)/ITO (40 nm) films gave the transmittance of 93.1% at 560 nm. The relationship between transmittance and oxide thickness was simulated using the scattering matrix method to understand high transmittance. As the oxide thickness increased from 20 to 50 nm, the carrier concentration gradually decreased from 1.08 × 1022 to 6.66 × 1021 cm−3, while the sheet resistance varied from 5.8 to 6.1 Ω/sq. Haacke's figure of merit reached a maximum at 40 nm and then decreased with increasing oxide thickness. The change in resistance for the 60 nm-thick ITO single film rapidly increased with increasing bending cycles, while that of the TiO2/Ag/ITO (40 nm/18 nm/40 nm) film remained virtually unchanged during the bending test.

The junction resistance control of conducting networks is a crucial factor for high performance of the network-structured conducting film. Here, we show that silver nanowire (AgNW) networks can be stabilized by using single-walled carbon nanotubes (SWCNTs) which were functionalized with 2-ureido-4[1H]pyrimidinone (UHP) moieties. UHP-modified SWCNTs allowed us to fabricate AgNW suspension containing SWCNTs without adding additional dispersant molecules. The stabilization of AgNW networks was achieved by minimizing the joule heating at the NW-NW junction assisted by in-situ interconnection with the work function modulated SWCNTs. We propose that the electrical transportation pathway was modulated by the SWCNTs through the SWCNT-AgNW junctions, which results in a relatively lower junction resistance than the NW-NW junction in the network film.

Since 1994, the KHNP has developed a vitrification technology to treat the LILW generated from Korean nuclear power plant. To vitrify the LILW including combustible Dry Active Waste (DAW) and Ion Exchange Resin (IER) containing Zeolite, two borosilicate glasses are formulated. One of the formulated glass, DG2, is for the DAW vitrification solely and the other one, AG8W1, is for the blended wastes (DAW & IER) vitrification in a commercial vitrification facility in HanUl (former Ulchin) nuclear power plant. The physicochemical properties of the two glasses have been evaluated. To evaluate the processability of the glasses, the viscosities and electrical conductivities of the glass melts were measured in the laboratory within a temperature range between 950 and 1,350 degrees C, respectively. The liquidus temperatures of the glasses were evaluated using a gradient furnace for DG2 and data from heat treatment for AG8W1. The Mössbauer spectroscopy for AG8W1 was employed to evaluate the relations between the redox equilibria of iron. In addition, to verify the waste acceptance criteria for the final disposal of the vitrified forms, the compressive strengths of the vitrified forms were tested after an immersion test, a thermal cycling test, and an irradiation test. To verify the chemical durability of the glasses, several tests such as PCT, ISO, VHT, Soxhlet, MCC-1, and ANS16.1 were carried out. The PCT showed leach rates of B, Na, Li and Si were much less than those of the benchmark glass. The ISO test was performed at 90 degrees C for 1,022 days and Cumulative Fraction Leached of all elements in the glasses were analyzed. According to the VHT, the glasses had an outstanding chemical resistance under humid environment at 200 degrees C for 7 days. The Soxhlet leaching was performed on rectangular glass samples at 98 degrees C for 30 days. To analyze the forward dissolution rates of major glass elements, the MCC-1 was conducted at temperatures of 40, 70, and 90 degrees C for three weeks in pH buffer solutions ranging from pH 4 to 11. The processability of the glasses was in the desired ranges. And the product quality of the glasses met all regulatory guidelines. Using two glasses, the CCIM commissioning tests in the UVF were successfully performed and they showed good workability.

Mutation breeding techniques have been used to induce new genetic variations and improve agronomic traits in soybean. In Korea, the Korea Atomic Energy Research Institute (KAERI) has unique radiation facilities to induce plant mutations and has been conducting soybean mutation breeding programmes since the mid-1960s. Until now, the KAERI has developed five soybean mutant cultivars exhibiting early maturity, high yield and seed-coat colour change. In this paper, we review these five mutant cultivars in terms of how to successfully induce unique agronomic characteristics through mutation breeding programmes. A number of induced mutants exhibiting null lipoxygenase enzymes, altered protein patterns or Kunitz trypsin inhibitor activity could serve as genetic resources for the genetic analysis of target genes, and one mutant population has been developed for a reverse genetic study.

A new method for determining the vitrification rate of pottery depending on the firing temperature was devised using secondary electron images (SEI) of scanning electron microscope (SEM). Several tests were performed to establish the appropriate operating conditions of SEM and reproducibility as well as to examine the applicability of the method. The grayscale values converted from each pixel of SEI were used to determine the vitrification rate of pottery, which in our study were artificially fired specimens composed of three types of clay. A comparison between the vitrification rate value and appearance temperature of minerals shows that mullite formation starts at 1,100°C, during which the vitrification rate rapidly increases by over 10%. In consequence, the result presented here demonstrates that the new method can be applied to estimate the firing temperature of pottery.

We performed this study to investigate the effect of histone deacetylase inhibition during extended culture of in vitro matured mouse oocytes. In vitro matured mouse (BDF1) oocytes were cultured in vitro for 6, 12, and 24 h, respectively, and then inseminated. During in vitro culture for 6 and 12 h, two doses of trichostatin A (TSA), a histone deacetylase inhibitor, were added (100 nM and 500 nM) to the culture medium and the oocytes were then inseminated. During the 24-h in vitro culture, two doses of TSA were added (100 nM and 500 nM) to the medium and the oocytes were activated with 10 mM SrCl2. After the 6-h culture, the fertilization rate was similar to that of the control group, but the blastocyst formation rate was significantly decreased. After the 12-h culture, both the fertilization and blastocyst formation rates were significantly decreased. After the 24-h culture, total fertilization failure occurred. In the oocytes cultured for 6 and 12 h, the fertilization and blastocyst formation rates did not differ between the TSA-supplemented and control groups. Although extended culture of the mouse oocytes significantly affected their fertilization and embryo development, TSA supplementation did not overcome their decreased developmental potential.

We investigated the pressure dependence of the inductive coupled plasma (ICP) oxidation on the electrical characteristics of the thin oxide films. Activation energies and electron temperatures with different pressures were estimated. To demonstrate the pressure effect on the plasma oxide quality, simple N type metal-oxide-semiconductor (NMOS) transistors were fabricated and investigated in a few electrical properties. At higher pressure than 200mTorr, plasma oxide has a slightly higher on-current and a lower interfacial trap density. The on-current gain seems to be related to the field mobility increase and the lower defective interface to the electron temperature during oxidation.

Background: Low education and illiteracy are associated with an increased risk of dementia. This study aimed to develop a neuropsychological test battery applicable to both illiterate and literate elderly and to assess its reliability and validity for a diagnosis of dementia.

Methods: We developed the Literacy Independent Cognitive Assessment (LICA), which consists of 13 subtests assessing memory, language, visuoconstruction, executive function, attention and calculation. We investigated its reliability and validity on 152 patients with dementia, 66 with mild cognitive impairment and 639 normal controls.

Results: The subtests were found to be applicable to most of the illiterate normal controls (97.3%) and were found to have high inter-rater reliabilities (r = 0.85–1.00, p < 0.001) and moderate to high test-retest reliabilities (r = 0.50–0.86, p < 0.001). The LICA performed well in discriminating participants across Clinical Dementia Rating stages and showed excellent internal consistency and good concurrent validity with the Korean Mini-mental State Examination in both literate and illiterate participants. The area under the curve of the receiver operating characteristic was 0.985 in each of the two literacy groups. Sensitivity and specificity of the LICA to make a diagnosis of dementia was 91.9% and 91.8% at the cutoff point of 186.0 in the literate subjects and 96.2% and 91.1% at the cutoff point of 154.5 in the illiterate subjects. The battery was factored into two separate factors consisting of verbal memory tests and tests for other cognitive domains.

Conclusion: The LICA is a valid and reliable instrument for a diagnosis of dementia in both illiterate and literate elderly.

We have fabricated two metal/double insulator/metal diodes using a sputtering system and atomic layer deposition. Here, we show metal/double insulator/metal diode applied as a switch element. The diode exhibits good rectifying characteristics at room temperature. We used the electrode material with Pt and insulators were HfO2/ZrO2 and NiO/ZnO each. The devices were fabricated using the lithographic system and top electrode sizes were 30 µm x 30 µ;m. The double insulator diode produces an enhanced nonlinearity by incorporating two adjacent oxides instead of the single oxide layer of the MIM diode. In the double insulator diode the mode of tunneling under positive applied biases can be made different from that under negative applied biases resulting in improved asymmetry.