A high-energy pulsed vacuum ultraviolet (VUV) solid-state laser at 177 nm with high peak power by the sixth harmonic of a neodymium-doped yttrium aluminum garnet (Nd:YAG) amplifier in a KBe2BO3F2 prism-coupled device was demonstrated. The ultraviolet (UV) pump laser is a 352 ps pulsed, spatial top-hat super-Gaussian beam at 355 nm. A high energy of a 7.12 mJ VUV laser at 177 nm is obtained with a pulse width of 255 ps, indicating a peak power of 28 MW, and the conversion efficiency is 9.42% from 355 to 177 nm. The measured results fitted well with the theoretical prediction. It is the highest pulse energy and highest peak power ever reported in the VUV range for any solid-state lasers. The high-energy, high-peak-power, and high-spatial-uniformity VUV laser is of great interest for ultra-fine machining and particle-size measurements using UV in-line Fraunhofer holography diagnostics.

In the absence of the necessary valley topography, karst depressions are sometimes used to construct conventional impoundments in order to contain tailings. Leakage is a primary concern for such impoundments. The purpose of the current study was to determine the characteristics and barrier performance of laterite mantling karst depressions, using, as an example, the Wujiwatang (WJWT) tailings impoundment, located in the Gejiu mining area, southwestern China. The geotechnical-hydrogeological properties, geochemistry, mineral compositions, and particle shapes of the laterite were investigated by geotechnical techniques, chemical analysis, X-ray diffraction (XRD), and scanning electron microscopy (SEM). The results showed that the laterite contained poorly sorted particles that covered a wide spectrum of grain sizes (<5 mm to <50 nm), and was unexpectedly categorized as silty clay or silt with a high liquid limit. The continuous gradation and small D90 value helped the laterite achieve saturated hydraulic conductivities in the range of <10–6 cm/s required for impoundment liners. The laterite beneath the tailings impoundment was finer-grained and had a lower permeability than that of the laterite on the depression walls within the same depression. Geochemically and mineralogically, the laterite was classified as true laterite and its major mineralogical constituents were gibbsite and goethite with chlorite occurring in trace amounts. The laterite was dominated by subspherolitic–spherolitic cohesionless grains (concretions) made up of Al, Fe, Ti, and Mn oxides and hydroxides. The laterite did not have plasticity indices in the clay range. Fortunately, slopewash prior to tailings containment selectively transported the finer oxide concretions to the depression floor, creating a natural low-permeability barrier for the WJWT tailings impoundment. This is undoubtedly important for the planning and design of future karst depression-type tailings impoundments around the world.

We present a high-energy, hundred-picosecond (ps) pulsed mid-ultraviolet solid-state laser at 266 nm by a direct second harmonic generation (SHG) in a barium borate (BaB2O4, BBO) nonlinear crystal. The green pump source is a 710 mJ, 330 ps pulsed laser at a wavelength of 532 nm with a repetition rate of 1 Hz. Under a green pump energy of 710 mJ, a maximum output energy of 253.3 mJ at 266 nm is achieved with 250 ps pulse duration resulting in a peak power of more than 1 GW, corresponding to an SHG conversion efficiency of 35.7% from 532 to 266 nm. The experimental data were well consistent with the theoretical prediction. To the best of our knowledge, this laser exhibits both the highest output energy and highest peak power ever achieved in a hundred-ps/ps regime at 266 nm for BBO-SHG.

Hypertension represents one of the most common pre-existing conditions and comorbidities in Coronavirus disease 2019 (COVID-19) patients. To explore whether hypertension serves as a risk factor for disease severity, a multi-centre, retrospective study was conducted in COVID-19 patients. A total of 498 consecutively hospitalised patients with lab-confirmed COVID-19 in China were enrolled in this cohort. Using logistic regression, we assessed the association between hypertension and the likelihood of severe illness with adjustment for confounders. We observed that more than 16% of the enrolled patients exhibited pre-existing hypertension on admission. More severe COVID-19 cases occurred in individuals with hypertension than those without hypertension (21% vs. 10%, P = 0.007). Hypertension associated with the increased risk of severe illness, which was not modified by other demographic factors, such as age, sex, hospital geological location and blood pressure levels on admission. More attention and treatment should be offered to patients with underlying hypertension, who usually are older, have more comorbidities and more susceptible to cardiac complications.

A series of CoCrFeNiMox (x = 0.2, 0.4, 0.6, 0.8, 1.0, and 1.2) high-entropy alloys were designed to develop a eutectic high-entropy alloy system and to acquire a superfine eutectic structure. The results show that for the CoCrFeNiMox alloys, with the increase of Mo content from 0.2 to 1.2, the microstructures shift from a typical dendrite structure to a hypoeutectic microstructure (x = 0.6), and then to a fully eutectic microstructure (x = 0.8) with a lamellar spacing only 110 nm, and finally culminate in the hypereutectic structure (x = 1.0, x = 1.2). The XRD results show that CoCrFeNiMox alloys have a single FCC phase when x is 0.2 or 0.4. When Mo content is over 0.6, it begins to separate Cr9Mo21Ni20 intermetallic compounds. The hardness of the CoCrFeNiMox alloys is increasing significantly from 172.8 to 763.7 HV with the increase of Mo content. Meanwhile, the fracture strength increased but the ductility decreases. Among these alloys, the CoCrFeNiMo0.6 alloy shows excellent integrated mechanical properties of compressive fracture strength and strain, which are 2051 Mpa and 23%, respectively.

In this paper, the recent studies of laboratory astrophysics with strong magnetic fields in China have been reviewed. On the Shenguang-II laser facility of the National Laboratory on High-Power Lasers and Physics, a laser-driven strong magnetic field up to 200 T has been achieved. The experiment was performed to model the interaction of solar wind with dayside magnetosphere. Also the low beta plasma magnetic reconnection (MR) has been studied. Theoretically, the model has been developed to deal with the atomic structures and processes in strong magnetic field. Also the study of shock wave generation in the magnetized counter-streaming plasmas is introduced.

We aimed to examine the contribution of blood lipids to the association between BMI and blood pressure (BP) in children with overweight and obesity. Data were collected in elementary and high schools of Chaoyang District, Beijing, China in 2012. Participants’ weight, height, BP and fasting plasma lipid profile were measured by standard protocols. Mediation analysis was used to examine the mediation role of blood lipids on the relation between BMI and BP, with age included as a covariate. We found that in boys 8·29 % (mediation effect=0·106, P=0·012) of the association between BMI and systolic BP was mediated through TAG. TAG mediated 12·53 % (mediation effect=0·093, P=0·018) and LDL-cholesterol mediated 7·75 % (mediation effect=0·57, P=0·046) of the association between BMI and diastolic BP was mediated by TAG and LDL-cholesterol, respectively. However, blood lipids did not show the mediation effect in girls. Our findings suggested that there was a sex difference in the contribution of blood lipids to the association between BMI and BP. Controlling TAG or LDL-cholesterol may be beneficial for reducing the risk of the BMI-related high BP in overweight boys; however, this outcome is not the case when controlling TAG or LDL-cholesterol in girls. This study may provide clues to explore the underlying mechanism of the association between obesity and hypertension.

A joint diagnostic system was established for the diagnosis of laser-driven shock wave experiments. The system has high temporal resolution (time resolution ~12 ps) and high spatial resolution (spatial resolution ~7 μm) and fits for diagnostics of the experiment with small sample size and short time physical process. The joint diagnostic system was applied for shock wave measurement on the Shenguang-II laser facility. The passive shock breakout signal and active diagnostic signal were simultaneously obtained. The temporal measurement reliability of the system was verified using a multi-layered target. The experimental results show that the two measurement results were consistent.

The preference of fertilized (IVF) and somatic cell nuclear transfer (SCNT) presumptive zygotes for different media when cultured in vitro to the blastocyst stage was evaluated in this study. The experiment comprised two zygote production methods (IVF and SCNT) × two culture media (mSOF and G1.5/G2.5) factorial design in which culture droplets that contained approximate 30 presumptive zygotes formed the experimental plots for the assessment of cleavage and blastocyst development. There were 15 to 20 replicates (culture droplets) per treatment combination. Sub-samples 30 to 41 of the blastocysts produced were assessed for cell number and cell apoptosis. A further 10 blastocysts per treatment combination were used for quantitative real-time polymerase chain reaction (RT-PCR) to evaluate the relative abundance of Hsp70 and Bax mRNA. Presumptive zygotes produced by IVF were developmentally more competent than SCNT zygotes in terms of cleavage rate (66.9 vs. 57.0%; P < 0.05) and blastocyst development rates (blastocysts of presumptive zygotes 29.7 vs. 24.8%; blastocysts of cleaved zygotes 44.4 vs. 36.6%; P < 0.05). Over both zygote production systems, however, the results were similar whether culture was in mSOF or in G1.5/G2.5 media for cleavage rate (63.2 vs. 62.4%; P > 0.05) and blastocyst development rate (blastocysts of presumptive zygotes 26.4 vs. 25.7%; P > 0.05; blastocysts of cleaved zygotes 41.8 vs. 41.2%; P > 0.05). There was, however, a significant interaction between the method of zygote production and culture medium for the apoptotic index of blastocysts. The interaction was such that IVF-produced zygotes cultured in mSOF had a lower apoptotic index compared with those cultured in G1.5/G2.5 (4.7 ± 1.2% vs. 9.8 ± 0.9%; P < 0.05) whereas SCNT zygotes had a higher apoptotic index when cultured in mSOF compared with those cultured in G1.5/G2.5 (11.9 ± 1.5% vs. 4.5 ± 1.2%; P < 0.05). Moreover, RT-PCR analysis showed that embryos from IVF-produced zygotes cultured in mSOF had a lower expression level of stress-related and apoptosis genes (Hsp70 and Bax) than those cells cultured in G1.5/G2.5 medium, while SCNT-derived embryos cultured in mSOF had a higher expression level of these genes than those embryos cultured in G1.5/G2.5 medium. The results of this study show that bovine IVF- and SCNT-produced presumptive zygotes have different nutrient requirements for in vitro culture to the blastocyst stage of development. IVF-derived zygotes have a preference for mSOF as the culture medium whereas the G1.5/G2.5 medium is more suitable for the culture of bovine SCNT-derived zygotes.

Accumulated evidence suggests that social support is influenced by genetic and environmental factors. However, there are little data that examine this issue from Asian samples. We reported results from a preliminary study that examined familial effects on social support in a Chinese adult twin sample. We administered a 10-item social support instrument that measures three dimensions of social support (i.e., objective support, subjective support, and utilization of support) developed for the Chinese population. Two hundred forty-two same-sex twin pairs, where both members of the pair completed the personal interview, were included in the final analysis. Structural equation modeling was used to estimate additive genetic (A), shared environmental (C), and nonshared environmental (E) effects on each dimension of social support. Familial factors (A+C) explained 56.63% [95% CI = 45.48–65.72%] and 42.42% [95% CI = 29.93–53.25%] of the total phenotypic variances of subjective support and utilization of support, respectively. For the objective support, genetic effects did not exist, but common environmental effect explained 37.56% [95% CI = 26.17–48.28%] of the total phenotypic variances. Neither gender nor age effects were seen on any dimension of social support. Except for objective support, genetic factors probably influence variation in subjective support and utilization of support. Shared environmental factors may influence all dimensions of social support.

The effects of specific components in culture medium on embryo physiology have been extensively investigated to optimize in vitro culture systems; however, little attention has been paid to antibiotics, the reagents used most commonly in culture systems to prevent contamination. To investigate the potential effects of routine use of antibiotics on cultured embryos, mouse zygotes were cultured with or without antibiotics. In both groups, the developmental rate and cell number of blastocysts appear to be normal. The proportion of embryos with blastomere fragmentation increased slightly when embryos were cultured with antibiotics. In contrast, the presence of antibiotics in the embryo culture system significantly disturbs expression of zygotically activated genes, damages chromatin integrity and increases apoptosis of cultured embryos. These results provide evidence that, when cultured with antibiotics, embryos with normal appearance may possess intrinsic physiological and genetic abnormalities. We demonstrate that the adverse effects of antibiotics on mammalian embryos are more severe than we previously presumed and that antibiotics are not essential for sterility of embryo culture system therefore abolishing antibiotic supplementation during embryo culture.

In exploring an effective and reliable karyotyping method in Brassica crop plants, Brassica oleracea was successfully karyotyped using genomic in situ hybridization (GISH). B. oleracea genomic DNA was labelled as probe using DIG-high prime mix kit, with B. rapa genomic DNA acting as blocking agent. Specific fluorescent signals were detected on each pair of homologous chromosomes, and nine pairs of chromosomes of B. oleracea were clearly identified according to the signal characteristics. A practical and accurate method for conducting karyotyping of small chromosomes has been demonstrated.