The high-power narrow-linewidth fiber laser has become the most widely used high-power laser source nowadays. Further breakthroughs of the output power depend on comprehensive optimization of stimulated Brillouin scattering (SBS), stimulated Raman scattering (SRS) and transverse mode instability (TMI). In this work, we aim to further surpass the power record of all-fiberized and narrow-linewidth fiber amplifiers with near-diffraction-limited (NDL) beam quality. SBS is suppressed by white-noise-signal modulation of a single-frequency seed. In particular, the refractive index of the large-mode-area active fiber in the main amplifier is controlled and fabricated, which could simultaneously increase the effective mode field area of the fundamental mode and the loss coefficient of higher-order modes for balancing SRS and TMI. Subsequent experimental measurements demonstrate a 7.03 kW narrow-linewidth fiber laser with a signal-to-noise ratio of 31.4 dB and beam quality factors of Mx2 = 1.26, My2 = 1.25. To the best of our knowledge, this is the highest reported power with NDL beam quality based on a directly laser-diode-pumped and all-fiberized format, especially with narrow-linewidth spectral emission.

Suppressing mode degradation is the key issue for high-power laser delivery; however, diagnosing mode degradation in its entirety, ranging from the contents and origins to locations, has always been a major obstacle. Here, a versatile approach for tracing the origins of mode coupling is demonstrated through addressing the differential intermodal dispersions of fiber modes. Full recognition for modal contents and the origins of mode degradation are experimentally completed in a two-mode fiber laser delivery system, which assists a significant improvement of beam quality M2 from 1.35 to 1.15 at the highest power of over 300 W. This method yields a quantitative characterization for manipulating the individual mode of dual-mode coupling origins or their combinations. This work points toward a promising strategy for the online tracing of mode coupling in cascade fiber links, thus enabling further pursuit of seeking extreme beam quality in high-power fiber laser systems.

In this study, we investigated the influence of fiber parameters on stimulated Raman scattering (SRS) and identified a unique pattern of SRS evolution in the counter tandem pumping configuration. Our findings revealed that the SRS threshold in counter-pumping is predominantly determined by the length of the output delivery fiber rather than the gain fiber. By employing the counter tandem pumping scheme and optimizing the fiber parameters, a 10 kW fiber laser was achieved with beam quality M2 of 1.92. No mode instability or severe SRS limitation was observed. To our knowledge, this study achieved the highest beam quality in over 10 kW fiber lasers based on conventional double-clad Yb-doped fiber.

The power scaling on short wavelength (SW) fiber lasers operating around 1 μm are in significant demand for applications in energy, environment and industry. The challenge for performance scalability of high-power SW lasers based on rare-earth-doped fiber primarily lies in the physical limitations, including reabsorption, amplified spontaneous emission and parasitic laser oscillation. Here, we demonstrate an all-fiberized, purely passive SW (1018 nm) random-distributed-feedback Raman fiber laser (RRFL) to validate the capability of achieving high-power output at SWs based on multimode laser diodes (LDs) direct pumping. Directly pumped by multimode LDs, the high-brightness RRFL delivers over 656 W, with an electro-optical efficiency of 20% relative to the power. The slope efficiency is 94%. The beam quality M2 factor is 2.9 (which is ~20 times that of the pump) at the maximum output signal power, achieving the highest brightness enhancement of 14.9 in RRFLs. To the best of our knowledge, this achievement also represents the highest power record of RRFLs utilizing multimode diodes for direct pumping. This work may not only provide a new insight into the realization of high-power, high-brightness RRFLs but also is a promising contender in the power scaling of SWs below 1 μm.

A new approach to target development for laboratory astrophysics experiments at high-power laser facilities is presented. With the dawn of high-power lasers, laboratory astrophysics has emerged as a field, bringing insight into physical processes in astrophysical objects, such as the formation of stars. An important factor for success in these experiments is targetry. To date, targets have mainly relied on expensive and challenging microfabrication methods. The design presented incorporates replaceable machined parts that assemble into a structure that defines the experimental geometry. This can make targets cheaper and faster to manufacture, while maintaining robustness and reproducibility. The platform is intended for experiments on plasma flows, but it is flexible and may be adapted to the constraints of other experimental setups. Examples of targets used in experimental campaigns are shown, including a design for insertion in a high magnetic field coil. Experimental results are included, demonstrating the performance of the targets.

In this work, a confined-doped fiber with the core/inner-cladding diameter of 40/250 μm and a relative doping ratio of 0.75 is fabricated through a modified chemical vapor deposition method combined with the chelate gas deposition technique, and subsequently applied in a tandem-pumped fiber amplifier for high-power operation and transverse mode instability (TMI) mitigation. Notably, the impacts of the seed laser power and mode purity are preliminarily investigated through comparative experiments. It is found that the TMI threshold could be significantly affected by the seed laser mode purity. The possible mechanism behind this phenomenon is proposed and revealed through comprehensive comparative experiments and theoretical analysis. Finally, a maximum output power of 7.49 kW is obtained with the beam quality factor of approximately 1.83, which is the highest output power ever reported in a forward tandem-pumped confined-doped fiber amplifier. This work could provide a good reference and practical solution to improve the TMI threshold and realize high-power high-brightness fiber lasers.

The quantum defect (QD) is an important issue that demands prompt attention in high-power fiber lasers. A large QD may aggravate the thermal load in the laser, which would impact the frequency, amplitude noise and mode stability, and threaten the security of the high-power laser system. Here, we propose and demonstrate a cladding-pumped Raman fiber laser (RFL) with QD of less than 1%. Using the Raman gain of the boson peak in a phosphorus-doped fiber to enable the cladding pump, the QD is reduced to as low as 0.78% with a 23.7 W output power. To our knowledge, this is the lowest QD ever reported in a cladding-pumped RFL. Furthermore, the output power can be scaled to 47.7 W with a QD of 1.29%. This work not only offers a preliminary platform for the realization of high-power low-QD fiber lasers, but also proves the great potential of low-QD fiber lasers in power scaling.

In late December 2019, patients of atypical pneumonia due to an unidentified microbial agent were reported in Wuhan, Hubei Province, China. Subsequently, a novel coronavirus was identified as the causative pathogen which was named SARS-CoV-2. As of 12 February 2020, more than 44 000 cases of SARS-CoV-2 infection have been confirmed in China and continue to expand. Provinces, municipalities and autonomous regions of China have launched first-level response to major public health emergencies one after another from 23 January 2020, which means restricting movement of people among provinces, municipalities and autonomous regions. The aim of this study was to explore the correlation between the migration scale index and the number of confirmed coronavirus disease 2019 (COVID-19) cases and to depict the effect of restricting population movement. In this study, Excel 2010 was used to demonstrate the temporal distribution at the day level and SPSS 23.0 was used to analyse the correlation between the migration scale index and the number of confirmed COVID-19 cases. We found that since 23 January 2020, Wuhan migration scale index has dropped significantly and since 26 January 2020, Hubei province migration scale index has dropped significantly. New confirmed COVID-19 cases per day in China except for Wuhan gradually increased since 24 January 2020, and showed a downward trend from 6 February 2020. New confirmed COVID-19 cases per day in China except for Hubei province gradually increased since 24 January 2020, and maintained at a high level from 24 January 2020 to 4 February 2020, then showed a downward trend. Wuhan migration scale index from 9 January to 22 January, 10 January to 23 January and 11 January to 24 January was correlated with the number of new confirmed COVID-19 cases per day in China except for Wuhan from 22 January to 4 February. Hubei province migration scale index from 10 January to 23 January and 11 January to 24 January was correlated with the number of new confirmed COVID-19 cases per day in China except for Hubei province from 22 January to 4 February. Our findings suggested that people who left Wuhan from 9 January to 22 January, and those who left Hubei province from 10 January to 24 January, led to the outbreak in the rest of China. The ‘Wuhan lockdown’ and the launching of the first-level response to this major public health emergency may have had a good effect on controlling the COVID-19 epidemic. Although new COVID-19 cases continued to be confirmed in China outside Wuhan and Hubei provinces, in our opinion, these are second-generation cases.

The prevalence of impaired fasting glucose (IFG) and diabetes mellitus (DM) has reportedly increased significantly among Chinese children and adolescents. We aimed to examine the prevalence of IFG and DM, the disparities in sex and region and related risk factors among Chinese children and adolescents. A total of 16 434 Chinese children aged 6–17 years were selected from a national cross-sectional survey, and fasting glucose was measured for all participants. Overall, mean fasting plasma glucose (FPG) concentration was (4·64 (sd 0·51)) mmol/l, and the prevalence of DM and IFG was 0·10 and 1·89 %, respectively. Compared with girls, boys had higher FPG concentration (4·69 v. 4·58 mmol/l, r 0·107, P<0·001) and IFG prevalence (2·67 v. 1·07 %, rφ 0·059, P<0·001). Compared with rural children and adolescents, urban children and adolescent had higher FPG concentration (4·65 v. 4·62 mmol/l, r 0·029, P<0·001) and DM prevalence (0·15 v. 0·05 %, rφ 0·016, P<0·01). In addition, self-reported fried foods intake and overweight/obesity were positively associated with IFG, and the proportion of consuming fried foods more than or equal to once per week and overweight/obesity prevalence in boys and urban children and adolescents were significantly higher than girls and rural children and adolescents, respectively (P<0·05). Although the prevalence of IFG and DM was relatively low in Chinese children and adolescents, sex and region disparities were observed, which may be associated with differences in overweight/obesity prevalence and dietary factors.

The gene expression profile of a normal-suffering monozygotic twin pair is investigated to explore biological mechanisms of spastic type cerebral palsy. Main works include following three aspects: First, a cDNA microarray test is carried out to get the differentially expressed genes of the patient with cerebral palsy compared to her monozygotic twin sister. Second, these differentially expressed genes are searched for their bioinformation within 4 biological databases: FatiGO, FatiGOPlus, KEGG, and SOURCE. Third, a set of special genes and gene families are screened out from the spastic type cerebral palsy patient. These biological analyses reveal that those genes for cell junction are mostly down-regulated, while those genes for metabolism are mostly up-regulated. The individual genes, gene family, and their associated biological functions can reflect the pathological and physiological characteristics of the cerebral palsy.