Hostname: page-component-848d4c4894-v5vhk Total loading time: 0 Render date: 2024-06-18T20:39:51.137Z Has data issue: false hasContentIssue false
  • English
  • Français

Mechanical design and fabrication of a two-blade stripline for the Advanced Photon Source storage ring

Published online by Cambridge University Press:  01 October 2010

L. H. Morrison ,
C. Y. Yao  and
M. Givens
L. H. Morrison*
Affiliation:
Advanced Photon Source, Argonne National Laboratory, Argonne, IL 60439, USA
C. Y. Yao
Affiliation:
Advanced Photon Source, Argonne National Laboratory, Argonne, IL 60439, USA
M. Givens
Affiliation:
Advanced Photon Source, Argonne National Laboratory, Argonne, IL 60439, USA
*
†Email address for correspondence:lhm@aps.anl.gov
Get access

Abstract

The storage ring tune measurement system at the Advanced Photon Source (APS) consists of signal pickup and beam excitation drive striplines. Striplines currently installed in the APS storage ring are of a four-blade (inner conductor) design that serves as a beam diagnostic tool and for transverse and longitudinal tune measurements. A new two-blade stripline was designed for the transverse feedback system and to be used for horizontal beam excitation. In this paper, we discuss its mechanical design, assembly procedure, and construction.

Type
Poster paper
Information
Diamond Light Source Proceedings , Volume 1 , Issue MEDSI-6 , October 2010 , e6
Copyright
Copyright © Diamond Light Source Ltd 2010

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Van Valkenburg, M. E. 1995 Reference Data for Engineers: Radio, Electronics, Computer, and Communications, 8th edn, Prentice Hall Computer Publishing, ISBN 0-672-22753-3.Google Scholar
Winick, H. Synchrotoron Radiation Sources, A Primer, Series on Synchrotron Radiation Techniques and Applications, vol.1, World Scientific Publishing Co. Pte. Ltd., 1994.Google Scholar