Hostname: page-component-848d4c4894-2pzkn Total loading time: 0 Render date: 2024-06-03T07:45:57.462Z Has data issue: false hasContentIssue false
  • English
  • Français

Processing and characterization of hydroxyapatite coatings on titanium produced by magnetron sputtering

Published online by Cambridge University Press:  31 January 2011

T. G. Nieh ,
A. F. Jankowski  and
J. Koike
T. G. Nieh
Affiliation:
Lawrence Livermore National Laboratory, L-350, P.O. Box 808, Livermore, California 94551–9900
A. F. Jankowski
Affiliation:
Lawrence Livermore National Laboratory, L-350, P.O. Box 808, Livermore, California 94551–9900
J. Koike
Affiliation:
Department of Materials Science, Tohoku University, 02 Aoba-yama, Aoba-ku, Sendai 980–8579, Japan
Get access

Abstract

Hydroxyapatite (HA) coatings with different thicknesses were produced on Ti and Si substrates using the radio frequency magnetron sputtering method. The mechanical properties, for example, modulus and hardness, of the coatings were measured using nanoindentation. The measured values of modulus and hardness were close to the upper limit of that reported for bulk HA, indicating a fully dense structure. Interfacial strengths between the HA coatings and substrates were also evaluated using a nanoscratch technique. The HA–Ti interface appeared to be stronger than the HA–Si interface. The microstructures of the HA coating and the HA–Ti interface were examined using high-resolution electron microscopy. Chemical compositions of the HA coating and the HA–Ti interface were also analyzed using x-ray energy dispersive spectrometer and electron energy loss spectroscopy. The results indicated that the strong HA–Ti bonding is associated with an outward diffusion of Ti into HA layer and concomitant formation of TiO2 at or near the interface.

Type
Articles
Information
Journal of Materials Research , Volume 16 , Issue 11 , November 2001 , pp. 3238 - 3245
Copyright
Copyright © Materials Research Society 2001

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Triffit, J.T., in Fundamental and Clinical Bone Physiology, edited by Urist, M.R. (Lippincott, Philadelphia, PA, 1980), Chap. 3.Google Scholar
2.Hohling, H.J., Ashton, B.A., and Koster, H.D., Cell Tissue Res. 148, 11 (1974).CrossRefGoogle Scholar
3.Posner, A.S., Perloff, A., and Diorio, A.D., Acta Crystallogr. 11, 308 (1958).CrossRefGoogle Scholar
4.McConell, D., Apatite: Its Crystal Chemistry, Mineralogy, Utili-zation, and Biologic Occurrence (Springer-Verlag, Berlin, Ger-many, 1973).CrossRefGoogle Scholar
5.Hench, L.L., J. Am. Ceram. Soc. 74, 1487 (1991).CrossRefGoogle Scholar
6.Shors, E.C. and Holmes, R.E., in An Introduction to Bioceramics, edited by Hench, L.L. and Wilson, J. (World Scientific, Singapore, 1993), p. 181.CrossRefGoogle Scholar
7.Liu, D.M., Chou, H.M., and Wu, J.D., J. Mater. Sci.: Medicine 5, 147 (1994).Google Scholar
8.Wolke, J.G.C., van Dijk, K., Schaeken, H.G., de Groot, K., and Jansen, J.A., Biomed, J.. Mater. Res. 28, 1477 (1994).Google Scholar
9.van Dijk, K., Schaeken, H.G., Maree, C.H.M., Verhoeven, J., Wolke, J.G.C., Habraken, F.H.P.M., and Jansen, J.A., Surf. Coating Technol. 76–77, 206 (1995).CrossRefGoogle Scholar
10.van Dijk, K., Schaeken, H.G., Wolke, J.G.C., and Jansen, J.A., Bio-mater. 17, 405 (1996).Google Scholar
11.Dasarathy, H., Riley, C., Coble, H., Lacefield, W., and Maybee, G., Biomed, J.. Mater. Res. 31, 81 (1996).Google Scholar
12.Wei, M., Ruys, A.J., Swain, M.V., Kim, S.H., Milthorpe, B.K., and Sorrell, C.C., J. Mater. Sci.: Medicine 10, 401 (1999).Google Scholar
13.Hamdi, M., Hakamata, S., and Ektessabi, A.M., Thin Sol. Films. 377–378, 484 (2000).CrossRefGoogle Scholar
14.Khor, K.A., Dong, Z.L., Quek, C.H., and Cheang, P., Mater. Sci. Eng. A 281, 221 (2000).CrossRefGoogle Scholar
15.Luo, P. and Nieh, T.G., Biomater. 17, 1959 (1996).CrossRefGoogle Scholar
16.Bhushan, B., Handbook of Micro/Nano Tribology, edited by Bhushan, B. (CRC Press, Boca Raton, FL, 1995), p. 321.Google Scholar
17.Wang, J.G., Choi, B.W., Nieh, T.G., and Liu, C.T., J. Mater. Res. 15, 913 (2000).CrossRefGoogle Scholar
18.Chou, T.C., Nieh, T.G., McAdams, S.D., and Pharr, G.M., Scripta. Metall. Mater. 25, 2203 (1991).CrossRefGoogle Scholar
19.Kawahara, H., in Ceramics in Surgery, edited by Vincenzini, P. (Elsevier, Amsterdam, The Netherlands, 1982), p. 49.Google Scholar
20.Leapman, R.D., Grunes, L.A., and Fejes, P.L., Phys. Rev. B. 26, 614 (1982).CrossRefGoogle Scholar
21.Chenglin, C., Jingchuan, Z., Zhongda, Y., and Shidong, T., Mater. Sci. Eng. A 271, 95 (1999).CrossRefGoogle Scholar