Hostname: page-component-848d4c4894-ttngx Total loading time: 0 Render date: 2024-06-01T15:59:28.290Z Has data issue: false hasContentIssue false
  • English
  • Français

Stress Concentrations in Electronic Packaging

Published online by Cambridge University Press:  21 February 2011

Ravi Mahajan ,
Erdogan Madenci ,
Levent Ileri  and
Mark Thurston
Ravi Mahajan
Affiliation:
INTEL Corporation, Assembly Technology Development, Chandler, AZ 85226
Erdogan Madenci
Affiliation:
The University of Arizona, Center for Electronics Packaging Research and Department of Aerospace and Mechanical Engineering, Tucson, AZ 85721
Levent Ileri
Affiliation:
The University of Arizona, Center for Electronics Packaging Research and Department of Aerospace and Mechanical Engineering, Tucson, AZ 85721
Mark Thurston
Affiliation:
INTEL Corporation, Assembly Technology Development, Chandler, AZ 85226
Get access

Abstract

The reliability of ceramic and plastic packages used in microelectronics is compromised by interface (delamination) and homogeneous (bulk) cracking that is initiated during processing and stress testing. These cracking failures have certain characteristics in that they begin at locations of geometric stress concentrations and propagate along typical failure paths. Characterization of these stress concentrations is therefore essential to a good design and for defining material response parameters such as bulk and interfacial fracture toughness. In this paper, applications of a general-purpose finite element technique for the characterization of stress concentrations are presented. The technique uses the full twodimensional elasticity solution for different materials that are bonded together. It is possible to use this technique to extract relevant material parameters, such as stress intensity factors, the J-integral, or energy release rate, and hence to eventually define the conditions necessary for crack initiation and propagation.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 390: Symposium S – Electronic Packaging Materials Science VIII , 1995 , 39
Copyright
Copyright © Materials Research Society 1995

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Kinsman, K. R., J. Metals 40, 23 (1988).Google Scholar
2. van Vroonhoven, J. C. W., Fatigue Fract. Eng. Mater. Struc. 15 (2), 159 (1992).Google Scholar
3. Hein, V. L. and Erodogan, F., Int. J. Fract. 7, 317 (1971).Google Scholar
4. Theocaris, P. S., Int. J. Eng. Sci. 12, 107 (1974).Google Scholar
5. Blanchard, P. J. and Watson, R. D., Nuc. Eng. Des. 4, 61 (1986).Google Scholar
6. Madenci, E. and Ileri, L., ASME J Elect. Pkg. (submitted).Google Scholar
7. Barsoum, R. S., Int. J Num. Meth. Eng. 26, 531 (1988).Google Scholar
8. Munz, D., Fett, T., and Yang, Y. Y., Eng. Fract. Mech. 6, 185 (1993).Google Scholar
9. fleri, L. and Madenci, E., to be presented at the 45th ECTC, Las Vegas, NV, May 21–24, 1995.Google Scholar
10. Lin, K. Y. and Mar, J. W., Int. J. Fract. 12 (4), 521 (1976).Google Scholar
11. Rice, J. R., ASME J. Appl. Mech. 35, 379 (1968).Google Scholar