Hostname: page-component-848d4c4894-8kt4b Total loading time: 0 Render date: 2024-06-20T14:04:24.576Z Has data issue: false hasContentIssue false

Mechanically-Induced Phase Transformations in Plutonium Alloys

Published online by Cambridge University Press:  06 March 2019

P. L. Wallace
Affiliation:
Lawrence Livermore National Laboratory
W. L. Wien
Affiliation:
Lawrence Livermore National Laboratory
R. P. Goehner
Affiliation:
Nicolet Instrument Corporation
Get access

Abstract

In this article, we show that mechanically-induced phase transformations can be readily achieved in two Pu-alloy systems. We have observed mechanically-induced phase transformations in both Ti-stabilized β-Pu and Ga-stabilized δ-Pu, In both of these alloys, the parent phase has been largely transformed to α-Pu, and the cause of these transformations was mechanical strain introduced by the metallographic sample preparation. For the Ga alloys, x-ray diffraction (XRD) patterns were taken at about 1.5-μm steps down to the undisturbed material in order to develop depth profiles of the surface damage. The total depth of the disturbed material in these alloys is estimated to be about 7.6μm, but this depth was not measured for the Ti alloys. The proportions of α-Pu and δ-Pu in the Ga alloys have been estimated using (a) a new quantitative phase analysis program (SPECQUAN) that uses multiple peaks of each phase in order to minimize the effects of preferred orientation and (b) an older manual technique (i.e., hand calculations). The results from these techniques are compared. SPECQUAN was developed to use the Specplot data file structure directly, thus reducing our data processing. The program is written in Fortran 77 and employs an external intensity ratio quantification procedure to obtain its results. XRD calibration has been done independently by means of accurate density measurements on a reference Ga alloy.

Type
IX. Qualitative and Quantitative Phase Analysis Diffraction Applications
Copyright
Copyright © International Centre for Diffraction Data 1988

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Wick, O.J., ed. , “Plutonium Handbook, a Guide to the Technology,” The American Nuclear Society, La Grange, Ill. (1980).Google Scholar
2. Morgan, J.R., New Pressure-Temperature Phase Diagram of Plutonium, in: “Plutonium 1970 and other Actinides, Part II,” Miner, W. N., ed. , The Metallurgical Society of AIME, New York (1971).Google Scholar
3. Goldberg, A. and Massalski, T.B., Phase Transformations in the Actinides, in: “Plutonium 1970 and other Actinides, Part II,” Miner, W.N., ed. , The Metallurgical Society of AIME, New York (1971).Google Scholar
4. Goldberg, A. and Shyne, J.C., Thermodynamic Analysis of Stress and Pressure Effects on the S-MX Transformation in Plutonium Alloys, J. Nucl. Mat. 60:137 (1976).Google Scholar
5. Bergin, J.B., private communication (1982).Google Scholar
6. Peters, C.M., private communication (1988).Google Scholar
7. Wallace, P.L., Shimamoto, F.Y., and Quick, T.M., “Large-Scale Automation of the Lawrence Livermore Laboratory X-ray Analytical Facilities,” Lawrence Livermore National Laboratory, Livermore, Calif. , UCRL-52953 (1980).Google Scholar
8. Goehner, R.P., SPECPLOT—An Interactive Data Reduction and Display Program for Spectra Data, in: “Advances in X-ray Analysis, Vol. 23,” pp. 305311, Plenum Publishing Corp. , New York (1980).Google Scholar
9. Coohnor, R.P., private communication (1986).Google Scholar
10. Goehner, R.P., x-ray Diffraction Quantitative Analysis Using Intensity Ratios and External Standards, in “Advances in x-ray Analysis, Vol. 25,” pp. 309—313, Plenum Publishing Corp. , New York (1982).Google Scholar
11. Biltoft, P.J., private communication (1986).Google Scholar
12. Gallegos, G.F., private communication (1986).Google Scholar