Hostname: page-component-848d4c4894-ndmmz Total loading time: 0 Render date: 2024-05-18T08:00:49.901Z Has data issue: false hasContentIssue false
  • English
  • Français

The Use of a Portable X-Ray Unit for Measuring Residual Stresses in Aluminum, Titanium, and Steel Alloys

Published online by Cambridge University Press:  06 March 2019

Donald A. Bolstad  and
William E. Quist
Donald A. Bolstad
Affiliation:
The Boeing Company Renton, Washington
William E. Quist
Affiliation:
The Boeing Company Renton, Washington
Get access

Abstract

The principles of measuring surface stresses in metals by X-ray diffraction with commercially available equipment are well known. Two techniques of making stress measurement by X-ray diffraction now in general use are (1) X-ray diffractometer with electronic control panel and (2) back-reflection film camera.

The X-ray diffractometer technique has a number of important advantages over the film method, the major ones being accuracy and speed, but serious size and shape limitations are imposed on the specimen by the equipment: Because of its bulk and weight, specimens must be brought to it. The Airplane Division of The Boeing Company has capitalized on the advantages offered by the mobile backreflection film technique, especially with regard to specimen sizes and shapes. Results and techniques used, at Boeing for stress measurements in alloys of aluminum, titanium, and steel are presented. Experimental difficulties are discussed, and comparisons are made between results from the dirfractometer and backreflection camera, A portable darkroom and electropolishing unit are also presented which, with the X-ray unit, comprise a completely mobile stress-measuring facility.

Type
Research Article
Information
Advances in X-Ray Analysis , Volume 8: Thirteenth Annual Conference on Applications of X-ray Analysis, August 12-14, 1964 , 1964 , pp. 26 - 37
Copyright
Copyright © International Centre for Diffraction Data 1964

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Barrett, C. S., Structure of Metals, McGraw-Hill Book Co., Inc., New York, 1952.Google Scholar
2. Cullity, B. D., Elements of X-Ray Diffraction, Addison-Wesley Publishing Co., Inc., Reading, Mass., 1956.Google Scholar
3. Jacquet, P. A., Proc. ASTM 57: 1290, 1957.Google Scholar
4. Cullity, B. D., “Sources of Error in X-Ray Measurements of Residual Stress,” J. Appl. Phys. 33(6) :1915-17, 1964.Google Scholar
5. Davis, R. A., “Stress-Corrosion Cracking Investigation of Two Low-Alloy High-Strength Steels,” Corrosion Magazine 19:45t-55t, Feb. 1963.Google Scholar
6. Bolstad, D. A. and Quist, W. E., Boeing Document No. D6-7016, December 1960.Google Scholar
7. Donachie, M. J. Jr. and Norton, J. T., “X-Ray Studies of Lattice Strains Under Elastic Loading,” Am. Soc. Metals Trans. Quart. 55: 51, 1962.Google Scholar
8. Bolstad, D. A., Davis, R. A., Quist, W. E., and Roberts, E. C., “Measuring Stress in Steel Parts by X-Ray Diffraction,” Metal Progr., pp. 88-92, July 1963.Google Scholar