Hostname: page-component-848d4c4894-wg55d Total loading time: 0 Render date: 2024-05-21T07:03:17.035Z Has data issue: false hasContentIssue false
  • English
  • Français

The Use of a Cold Gas Plasma for the Final Processing of Contamination-Free TEM Specimens

Published online by Cambridge University Press:  02 July 2020

P.E. Fischione ,
J. Ringnalda ,
Y. Feng ,
T. Krekels ,
H.O. Colijn ,
M.J. Mills  and
J.M. Wiezorek
P.E. Fischione
Affiliation:
E.A. Fischione Instruments,Inc., Export, PA15632, USA
J. Ringnalda
Affiliation:
Philips Electron Optics,Inc., MahwahNJ07430, USA
Y. Feng
Affiliation:
Philips Electron Optics,Inc., MahwahNJ07430, USA
T. Krekels
Affiliation:
Philips Electron Optics, Eindhoven, The Netherlands
H.O. Colijn
Affiliation:
The Ohio State University, Columbus, OH43210, USA
M.J. Mills
Affiliation:
The Ohio State University, Columbus, OH43210, USA
J.M. Wiezorek
Affiliation:
The Ohio State University, Columbus, OH43210, USA
Get access

Extract

The issue of specimen contamination becomes more important at a rate proportional to the use of high-brightness electron source Transmission Electron Microscopes (TEM). These TEMs combine smaller electron probes with increased current, allowing high resolution specimen imaging and enhanced analytical data collection. Small, high current electron probes tend to increase the detrimental effect of hydrocarbon presence on the specimen's surface. The subsequent formation of carbon deposits caused by the focused probe often times obstructs imaging and precludes acceptable analytical results. by plasma cleaning the specimen, contamination is removed and the results obtained by high resolution electron microscopy (HREM), scanning transmission electron microscopy (STEM) and analytical electron microscopy (AEM) using EDS or electron energy loss spectroscopy (EELS) are greatly enhanced. Recent instrumentation developments have resulted in the application of a high frequency, low energy, reactive gas plasma generated in an oil-free vacuum that chemically removes hydrocarbon contamination from both the TEM specimen holder and the specimen without altering its properties.

Type
Analytical Electron Microscopy
Information
Microscopy and Microanalysis , Volume 3 , Issue S2: Proceedings: Microscopy & Microanalysis '97, Microscopy Society of America 55th Annual Meeting, Microbeam Analysis Society 31st Annual Meeting, Histochemical Society 48th Annual Meeting, Cleveland, Ohio, August 10-14, 1997 , August 1997 , pp. 985 - 986
Copyright
Copyright © Microscopy Society of America 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1.Thomas, R.S., “Use of Chemically-Reactive Gas Plasmas in Preparing Specimens for Scanning Electron Microscopy and Electron Probe Microanalysis”, Proceeding of the 7th Annual Scanning EM Sym.,Scanning Electron Microscopy, Pgs. 84–89, 1974.Google Scholar
2.Zandbergen, H.W., Delsing, A.C. A., Traeholt, C., VanVeen, A., and deRoode, J., “The Use of Plasma-Cleaning for the Preparation of Clean Electron-Transparent Thin Foils”, Proceedings of the Xm ICEM Volume 1, Pages 1003–1004, 1994.Google Scholar
3. U.S. Patent Number 5,510,624, Simultaneous Specimen and Stage Cleaning Device for Analytical Electron Microscopy - Argonne National Laboratory and the Univ. of ChicagoGoogle Scholar
4.Lieberman, Michael A., Lichtenberg, Allan J., “Principles of Plasma Discharges and Materials Processing, ”, John Wiley & Sons, Inc., New York, 1994Google Scholar