Hostname: page-component-76fb5796d-25wd4 Total loading time: 0 Render date: 2024-04-30T02:53:23.348Z Has data issue: false hasContentIssue false
  • English
  • Français

Effect of Ion-Accelerated Plasma Hydrogenation and Thermal Treatments on Hydrogen Silsesquioxane (HSQ) Low-K Dielectric Films

Published online by Cambridge University Press:  01 February 2011

R. Jeyakumar ,
L. Ren  and
S. Sivoththaman
R. Jeyakumar
Affiliation:
Dept. of Electrical and Computer Engineering, University of Waterloo, Waterloo, Ontario, Canada.
L. Ren
Affiliation:
Dept. of Electrical and Computer Engineering, University of Waterloo, Waterloo, Ontario, Canada.
S. Sivoththaman
Affiliation:
Dept. of Electrical and Computer Engineering, University of Waterloo, Waterloo, Ontario, Canada.
Get access

Abstract

Hydrogen silsesquioxane (HSQ), a low dielectric constant material was deposited by spin coating on Si substrates. The films were cured between 175°C and 575°C. The cured films were subjected to ion-accelerated hydrogen plasma at different DC bias voltage to reduce the dielectric constant (k) of the films. The effect of ion-accelerated hydrogen plasma on cured films was discussed and compared with (i) non-plasma, and (ii) hydrogen plasma without the accelerating DC bias. Capacitance-Voltage measurements (C-V) and Fourier Transform Infrared Spectroscopy (FTIR) studies were done on these films. The C-V measurement shows that k values increase as the curing temperature increases for all the cases. A PECVD system was used for plasma hydrogenation and ion-accelerated plasma hydrogenation. Depending on the curing temperature the dielectric constant values were found to be, (i) between ∼ 3 and 8.8 for nonplasma films, (ii) between ∼3 and 5.1 for plasma hydrogenated films, (iii) between ∼ 2.3 and 2.9 for plasma hydrogenation with ion-acceleration at 100V and between ∼2 and 2.9 for the 150V case. The ion-accelerated plasma treatment results in lower k values as compared to the nonplasma films. FTIR studies showed a reduction in intensity of Si-H peaks with increasing temperature which increases the k value. The hydrogen plasma treatment reduces the k value and the ion-accelerated hydrogen plasma further reduces the k value suggesting further hydrogen incorporation in the films.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 716: Symposium B – Silicon Materials-Processing, Characterization, and Reliability , 2002 , B7.24
Copyright
Copyright © Materials Research Society 2002

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Loiu, Huey-Chiang, Dehate, Evan, Duel, Jerry, and Dall, Fred in Mat. Res.Soc.Symp.Proc., 612 (2000)D5.12 Google Scholar
2. Liu, P.T., Chang, T.C., Sze, S.M., Pan, F.M., Mei, Y.J., Wu, W.F., Tsai, M.S., Dai, B.T., Chang, C.Y., Shih, F.Y., Huang, H.D. in Thin Solid Films 332(1998)345.Google Scholar
3. Chang, T.C., Liu, P.T., Shih, F.Y., and Sze, S.M. in Electrochem. and Solid-State Lett., 2(1999)390.Google Scholar
4. Pires, F., Noel, P., Lecornec, C., Passenard, G., Louis, D., Lajoine, E. in Microelectronic Engineering, 37/38(1997) 277.Google Scholar
5. Cook, R., Liniger, E., Klaus, D., Simonyi, E. and Cohen, S., MRS Symp. Proc., 511(1998)33.Google Scholar