Hostname: page-component-76fb5796d-vvkck Total loading time: 0 Render date: 2024-04-29T21:42:31.951Z Has data issue: false hasContentIssue false
  • English
  • Français

Thick Films of Pb(Mg,Nb)TiO by Aerosol Combustion

Published online by Cambridge University Press:  10 February 2011

A. C. Greenwald ,
A. Kussmaul ,
T. F. Morse  and
C. H. Wei
A. C. Greenwald
Affiliation:
Spire Corporation, Bedford, MA 01730–2396
A. Kussmaul
Affiliation:
Spire Corporation, Bedford, MA 01730–2396
T. F. Morse
Affiliation:
Brown Univ. Providence, RI.
C. H. Wei
Affiliation:
Brown Univ. Providence, RI.
Get access

Abstract

Thick films of solid solutions of lead-magnesium-niobium-oxide (PMN) and lead-titanate (PTO) were deposited by aerosol combustion. Films consisted of submicron ceramic particles synthesized by combustion of a metalorganic solution in a methane-oxygen flame. The particulate material was deposited on heated substrates (200°C) and subsequently sintered at elevated temperatures. Results varied with starting chemistry and sintering conditions. As-deposited materials were mixed perovskite-pyrochlore phase. Sintering at low temperatures produced pure perovskite material that was not completely dense. Sintering at high temperatures produced dense ceramics of pyrochlore material. This technique requires further optimization for direct deposition of continuous films, but is immediately suitable for producing fine powders for tape casting of capacitors, etc.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 495: Symposium W – Chemical Aspects of Electronic Ceramics Processing , 1997 , 433
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Nonaka, K., et. al, J. Mater. 6, 1750 (1991).Google Scholar
2. Zacharia, M.R. and Huarewicz, S., J. Mater. Res., 6, 264 (1991).Google Scholar
3. Zhang, J. et. al., Mat. Res. Soc. Symp. Proc. 275, 419 (1992).Google Scholar
4. Tsu, R., et. al, Mat. Res. Soc. Symp. Proc. 275, 361 (1992).Google Scholar
5. Kussmaul, A., et. al, Mat. Res. Soc. Symp. Proc. 433, 39 (1996).Google Scholar
6. Gupta, S.M. and Kulkarni, A.R., Mater. Chem. And Phys., 39, 98 (1991).Google Scholar
7.LECO Corporation, St. Joseph, MI.Google Scholar
8. Saha, D. et al, J. Mater. Res., 11, 932 1996).Google Scholar