Hostname: page-component-848d4c4894-tn8tq Total loading time: 0 Render date: 2024-06-15T05:17:57.906Z Has data issue: false hasContentIssue false

As, Se, and Re Sorption by Mg-Al Layered Double Hydroxides

Published online by Cambridge University Press:  11 February 2011

Charles R. Bryan
Affiliation:
Sandia National Laboratories, Carlsbad, NM 88220, U.S.A.
Yifeng Wang
Affiliation:
Sandia National Laboratories, Carlsbad, NM 88220, U.S.A.
Huifang Xu
Affiliation:
Department of Earth and Planetary Sciences, University of New Mexico, Albuquerque, NM 87131, U.S.A.
Paul S. Braterman
Affiliation:
Department of Chemistry, University of North Texas, Denton, TX 76203, U.S.A.
Huizhen Gao
Affiliation:
Sandia National Laboratories, Carlsbad, NM 88220, U.S.A.
Get access

Abstract

Layered double hydroxides (LDHs) have high anion exchange capacities and are easily synthesized in the laboratory, giving them considerable potential as adsorbents for anionic contaminants in the environment. In this study, sorption of arsenate, selenate, and perrhenate by uncalcined Mg-Al LDH (Mg:Al ratio 2.4:1) was evaluated. To investigate sorption mechanisms, the substrate was added to the solution both as a pre-wetted slurry (allowing 24 hours for rehydration), and as a dry powder. Sorption results varied for different anionic complexes. For selenate and perrhenate, an incubation time was required for the dry material to achieve the same Kd value as the pre-wetted material. For arsenate, however, both wetted and dry materials initially had high Kds, which decreased with time. These behaviors are attributed to the structural reconstruction of the calcined LDH material in solution. Se and Re are not highly sorbed by the phases present in the calcined material, but are incorporated as interlayer anions in the LDH structure upon hydration and reconstruction, while As may be sorbing onto the dehydration products, and being partially released during rehydration.

Type
articles
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Liang, L. Y., Gu, B.H., and Yin, X.P., Separations Technology, 6, 111122 (1996).Google Scholar
2. Kunze, S., Neck, V., Gompper, K., and Fanghanel, T., Radiochim. Acta, 74, 159163 (1996).Google Scholar
3. Kang, M. J., Chun, K.S., Rhee, S.W., and Do, Y., Radiochim. Acta, 85, 5763 (1999).Google Scholar
4. Bond, A. H., Chang, F.W.K., Thakkar, A.H., Williamson, J.M., J. M., , Gula, M.J., Harvey, J.T., Griffin, S.T., Roger, R.D., and Horwitz, E.P., Ind. Eng. Chem. Res., 38, 16761682 (1999).Google Scholar
5. Monteil-Rivera, F., Fedoroff, M., Jeanjean, M.J., Minel, L., Barthes, M.G., and Dumonceau, J., Colloid, J. and Interface Sci., 221, 291300 (2000).Google Scholar
6. Kovanda, F., Kovaksova, E., and Kolousek, D., Coll. Czech Chem. Commun., 64, 15171529 (1999).Google Scholar
7. You, Y., Vance, G.F., and Zhao, H., Applied Clay Science, 20, 1325 (2001).Google Scholar
8. You, Y.W., Zhao, H.T., and Vance, G.F., Environmental Technology, 22, 14471457 (2001).Google Scholar
9. Rives, V., and Ulibarri, M.A., Coordin. Chem. Rev., 181, 61120 (1999).Google Scholar
10. Han, S., Hou, W., Zhang, C., Sun, D., Huang, X., and Wang, G., J. Chem. Soc., Faraday Trans., 94(7), 915918 (1998).Google Scholar
11. Narita, E., Yamagishi, T., and Tonai, T., Nippon Kagaku Kaishi., 3, 291296 (1992).Google Scholar
12. Shin, H. S., Kim, M.J., Nam, S.Y., and Moon, H.C., Water Sci. Technol., 34, 161168, (1996).Google Scholar
13. Houri, B; Legrouri, A., Barroug, A., Forano, C., and Besse, J.P., J. De Chimie Phyique et Physico-Chimie Biologiue, 96, 455463, (1999).Google Scholar
14. Seida, Y., and Nakano, Y., Water Res., 34, 14871494 (2000).Google Scholar
15. Pavan, P. C., Crepaldi, E.L., and Valim, J.B., J.Colloid Interface Sci., 229, 346352 (2000).Google Scholar
16. Kameda, T., Miyano, Y., Yoshioka, T., Uchida, M., and Okuwaki, A., Chemistry Letters., 10, 11361137 (2000).Google Scholar
17. Hermosin, M. C., Pavlovic, I., Ulibarri, M.A., and J.Cornejo Water. Res., 30, 171177 (1996).Google Scholar
18. Amin, S. and Jayson, G.G., Water Res., 30, 299306, (1996).Google Scholar
19. Onkal-Engin, G., Wibulswas, R., and White, D.A., Envrion. Technol., 21, 167175 (2000).Google Scholar
20. Constantino, V.R.L. and Pinnavaia, T.J., Inorg. Chem., 34, 883892 (1995).Google Scholar
21. Stumm, W., Chemistry of the Solid-Water Interface: Processes in the Mineral-Water and Particle-Water Interface in Natural Systems, p. 95 (1992).Google Scholar