Hostname: page-component-848d4c4894-4hhp2 Total loading time: 0 Render date: 2024-05-21T12:56:14.833Z Has data issue: false hasContentIssue false

Boron Incorporation and Its Effect on Electronic Properties of Ge:H Films Deposited by LF Plasma

Published online by Cambridge University Press:  01 February 2011

Andrey Kosarev
Affiliation:
akosarev@inaoep.mx, National Institute for Astrophysics, Optics and Electronics, Electronics, L.E.Erro No.1,, col. Tonantzintla, Puebla, 72840, Mexico, +522222663100ext1409, +522222470517
Alfonso J Torres
Affiliation:
atorres@inaoep.mx, National Institute for Astrophysics, Optics and Electronics, Electronics, L.E.Erro No.1,, col. Tonantzintla, Puebla, 72840, Mexico
Nery D Checa
Affiliation:
ncheca@inaoep.mx, National Institute for Astrophysics, Optics and Electronics, Electronics, L.E.Erro No.1,, col. Tonantzintla, Puebla, 72840, Mexico
Yurii Kudriavtsev
Affiliation:
yuriyk@cinvestav.mx, CINVESTAV Institute Poltechnical National, Mexico DF, 71000, Mexico
Rene Asomoza
Affiliation:
rasomoza@cinvestav.mx, CINVESTAV Institute Poltechnical National, Mexico DF, 71000, Mexico
Salvador G Hernandez
Affiliation:
shernandez@cinvestav.mx, CINVESTAV Institute Poltechnical National, Mexico DF, 71000, Mexico
Get access

Abstract

Boron (B) doping of plasma deposited silicon films have been widely studied and applied in many devices, while B-doping of germanium has been poorly reported in literature. We have reported previously about Ge:H films with low density of localized states deposited by LF plasma with optimal hydrogen dilution.

This work is devoted to a study of boron incorporation and its effect on electronic properties in Ge:H films. The films were obtained by low frequency (LF) plasma deposition from GeH4+SiH4 +B2H6 mixture diluted with hydrogen. The deposition parameters were as follow: substrate temperature Ts = 300 oC, discharge frequency f= 110 kHz, pressure P= 0.6 Torr, power W= 300 W, germane flow QGeH4= 50 sccm, silane flow, hydrogen flow QH2=3500 sccm, diborane flow was varied in the range of QB2H6=0 to 20 sccm providing boron concentration in gas phase in the range of Y=0 to 4%. Composition of the films was characterized by SIMS profiling. Hydrogen bonding was studied by FTIR. Temperature dependence of conductivity measured in DC regime in vacuum thermostat was employed to study carrier transport. Optical measurements provided optical gap, sub-gap absorption and refraction index. Boron incorporation in solid film demonstrated fast increase in the range of Y = 0 to 1.4% and then increase became slower. Hydrogen concentration in the films was determined by absorption of Ge-H stretching mode at k ≈ 1870 cm−1 and it showed weak increase with change of Y from 0 to 4%. Activation energy of conductivity increased in the range of Y = 0 to 1.5% suggesting a compensation of electron conductivity, reaching maximum value Ea =0.5 eV (corresponding approximately to Eg/2) at Y= 1.5%. Then Ea reduced to minimum value Ea = 0.27 eV at Y= 3.5% showing a trend to saturation with further Y increase. This behavior is related to change of charge transport from electron to intrinsic at Y= 1.5% and further to hole transport.

Type
Research Article
Copyright
Copyright © Materials Research Society 2008

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Krause, M. Stiebig, H. Carius, R. Wagner, H. Mat.Res.Symp.Proc., 664, A26.5 (2001).Google Scholar
2. Dalal, V.L.. Current opinion in Solid State & Material Science, 6, 455 (2002).Google Scholar
3. Sanchez, L. Kosarev, A. Torres, A. Ilinskii, A. Kudriavtsev, Y. Asomoza, R. Cabarrocas, P. Rocai, Abramov, A.. Thin Solid Films, 515, 7603 (2007).Google Scholar
4. Stutzman, M. Biegelsen, D.K. Street, R.A.. Phys.Rev. B 35, 5666 (1987),Google Scholar
5. Ebersberger, B. Krueller, W. Fuhs, W. Mell, H.. Appl. Phys. Lett., 65 (13), 26 Sept, 1683 (1994).Google Scholar
6. Jordan, W.B., Wagner, S.. Mat.Res. Soc.Symp.Proc., 762, A5.7.1-6 (2003).Google Scholar