Hostname: page-component-848d4c4894-wzw2p Total loading time: 0 Render date: 2024-06-12T16:30:44.460Z Has data issue: false hasContentIssue false
  • English
  • Français

Deposition of Diamond-Like Carbon Films using Plasma Based Ion Implantation with Bipolar Pulses

Published online by Cambridge University Press:  17 March 2011

S. Miyagawa  and
Y. Miyagawa
S. Miyagawa
Affiliation:
Particle Beam Science Laboratory, National Industrial Research Institute of Nagoya 1-1 Hirate-cho, Kita-ku, Nagoya 462-8510, Japan
Y. Miyagawa
Affiliation:
Particle Beam Science Laboratory, National Industrial Research Institute of Nagoya 1-1 Hirate-cho, Kita-ku, Nagoya 462-8510, Japan
Get access

Abstract

Plasma based ion implantation (PBII) with bipolar high voltage pulses has been proposed to improve a dose uniformity in an ion implantation on a three-dimensional target. A pulsed glow discharge plasma is produced around the target by a positive high-voltage pulse, and then ions are implanted into the target from all sides by the subsequent negative high-voltage pulse. A time resolved plasma density and the spatial profiles of the pulsed glow discharge plasma are measured by a Langmuir probe in a boxcar mode, and diamond like carbon (DLC) films are deposited under optimal conditions of the pulsed plasma. It is shown that the PBII with bipolar pulses is a useful method in depositing DLC films on the three-dimensional target. A carbon ion implantation procedure results in the enhanced adherence of DLC coating to the target, and the enhanced adhesion is due to a graded carbon interface produced by carbon implantation.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 647: Symposium O – Ion Beam Synthesis & Processing of Advanced Materials , 2000 , O11.7
Copyright
Copyright © Materials Research Society 2001

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1.Keller, G., Paulus, M., Mandl, S., Strizker, B., Rauschenbach, B., Nucl.Instrum.Meth. B148,64(1999).Google Scholar
2.Walter, K.C., Nastasi, M., Munson, C., Surf. Coat. Technol. 93,287(1997).Google Scholar
3.Malaczynski, G.W., Elmoursi, A.A., Leung, C.H., Hamdi, A.H., Campbell, A.B., J.Vac.Sci.Technol. B17,813(1999).Google Scholar
4.Tuszewski, M., Scheuer, J.T., Adler, R.A., Surf. Coat.Tech. 93,203(1997).Google Scholar
5.Miyagawa, S., Nakao, S., Saitoh, K., Baba, K., Miyagawa, Y., Surf.Coat.Technol. 128/129,260(2000).Google Scholar
6.Hopkins, M.B., J.Res. Natl.Inst. Stand. Technol. 100,415(1995).Google Scholar
7.Miyagawa, Y., Ikeyama, M., Saitoh, K., Nakao, S., Miyagawa, S., Surf. and Coat. Technol. 83, 275(1996).Google Scholar
8.Baba, K., Hatada, R., Surf. and Coat. Technol. 103/104,235(1998).Google Scholar
9.Jacob, W., Thin Solid Films 326, 1(1998).Google Scholar