Hostname: page-component-848d4c4894-p2v8j Total loading time: 0 Render date: 2024-05-06T18:59:17.545Z Has data issue: false hasContentIssue false
  • English
  • Français

Evolution of Defect and Impurity Profile During High Dose Co Implantation into Si at Elevated Temperatures

Published online by Cambridge University Press:  03 September 2012

S. Schippel  and
A. Witzmann
S. Schippel
Affiliation:
Friedrich-Schiller Universitdt Jena, Institut fur Festkörperphysik, Max-Wien-Platz 1, D–07743 Jena, Germany
A. Witzmann
Affiliation:
Friedrich-Schiller Universitdt Jena, Institut fur Festkörperphysik, Max-Wien-Platz 1, D–07743 Jena, Germany
Get access

Abstract

<111> -Si was implanted with 250 keV Co ions at a target temperature of 350°C. The ion dose was varied between 1 × 1014 cm−2 and 2 × 1017 cm−2. The evolution of the defect and impurity profile was investigated by Rutherford Backscattering Spectrometry (RBS), channeling and transmission electron microscopy (TEM).

Up to a dose of 1 × 1015 Co cm−2 no defects can be detected. At higher Co doses, we find correlated defects in the center of the Co distribution and point defects in the region below. Moreover, damage accumulation at the surface is observed. The concentration of defects increases with increasing ion dose and reaches its level of saturation at a dose of 2 × 1016 cm−2.

The Co profiles of samples implanted at 350°C differ considerably from the Gaussian shape. The near surface and the back flank are parts of Gaussian distributions. However, the standard deviation of the near surface flank is always smaller than that of the back flank. Moreover, the distributions show tails into the substrate at depths > 320 nm. This proves that radiation damage acts as an effective center for the nucleation of CoSi2.

During annealing we find a redistribution of Co towards the defective regions for Co doses between 1 × 1016 cm−2 and 5 × 1016 cm−2.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 320: Symposium D – Silicides, Germanides, and Their Interfaces , 1993 , 179
Copyright
Copyright © Materials Research Society 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] White, A.E., Short, K.T., Dynes, R.C., Gibson, J.M. and Garno, J.P.; Appl. Phys. Lett. 50 (1987) p. 95.Google Scholar
[2] Mantl, S., MSREEL 8 (1992) 1 and references there in.Google Scholar
[3] Bulle-Lieuwma, C.W.T., Omnmen, A.H. van, Vandenhoudt, D.E.W., Ottenheimn, J.J.M. and Jong, A.F. de, J. Appl. Phys. 70 (1991) p. 3049.Google Scholar
[4] Witzmann, A., Schippel, S. and Zentgraf, A.; NucI. Instr. and Methods B68 (1992) p. 430.Google Scholar
[5] RUBSODY - an interactive program for RBS analysis, manual of the program, Friedrich-Schiller-Universitiit Jena, 1991.Google Scholar
[6] Götz, G. and Gäirtner, K. (eds.) High Energy Ion Beam Analysis of Solids, Akademie-Verlag, Berlin 1988.Google Scholar
[7] Ziegler, J.F., Biersack, J.P., Littmark, U. in The Stopping and Range of Ions in Solids, edited by Ziegler, J. F. (Pergamon, New York Vol. 11985).Google Scholar
[8] Omnmen, A.H. van, Ottenheim, J.J.M., Bulle-Lieuwma, C.W.T., Theunissen, A.M.L., Appl. Surf. Sci 38 (1989) p. 197.CrossRefGoogle Scholar
[9] Witzmann, A., Schippel, S., Zentgraf, A., and Gaiduk, P.I., J. AppI. Phys. 73 (1993) p. 7250.Google Scholar
[10] Miiller, M., Bahr, P., Press, W., Jebasinski, R. and Mantl, S., J. Appl. Phys. 74 (1993) p. 1590.Google Scholar