Hostname: page-component-848d4c4894-wg55d Total loading time: 0 Render date: 2024-05-11T02:13:34.018Z Has data issue: false hasContentIssue false
  • English
  • Français

Lateral Dye Distribution With Ink-Jet Dye Doping of Polymer Organic Light Emitting Diodes

Published online by Cambridge University Press:  10 February 2011

Conor F. Madigan ,
Thomas R. Hebner ,
J. C. Sturm ,
Richard A. Register  and
Sandra Troian
Conor F. Madigan
Affiliation:
Department of Electrical Engineering, Princeton University, Princeton, NJ 08544
Thomas R. Hebner
Affiliation:
Department of Electrical Engineering, Princeton University, Princeton, NJ 08544
J. C. Sturm
Affiliation:
Department of Electrical Engineering, Princeton University, Princeton, NJ 08544
Richard A. Register
Affiliation:
Department of Chemical Engineering, Princeton University, Princeton, NJ 08544
Sandra Troian
Affiliation:
Department of Chemical Engineering, Princeton University, Princeton, NJ 08544
Get access

Abstract

In this work we investigate the lateral dye distribution resulting from the dye doping of a thin polymer film by ink-jet printing (UIP) for the integration of color organic light emitting diodes (OLED's). The dye is found to segregate into distinct outer rings following rapid droplet evaporation, while slower evaporation rates are found to significantly reduce (or eliminate) this effect. The dye segregation phenomena are found to depend critically on the mechanisms of droplet evaporation. Good dye uniformity was obtained using a low vapor pressure solvent, and integrated, 250 micron red, green, and blue polymer organic light emitting diodes (OLED's) were fabricated with this technique. These devices had good color uniformity over most of the device area and similar electrical properties to comparable spin-coated devices without IJP

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 624: Symposium V – Materials Development for Direct Write Technologies , 2000 , 211
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Burroughs, J.H., Bradley, D.D.C., Brown, A.R., Marks, R.N., Mackay, K., Friend, R.H., Bums, P.L., Holmes, A.B., Nature 347, 539 (1990).Google Scholar
[2] Kido, J., Kohda, M., Okuyama, K., Nagai, K., Appl. Phys. Lett. 61, 761 (1992).Google Scholar
[3] Hebner, T.A., Sturm, J.C., APL 73, 1775 (1998).Google Scholar
[4] Chang, C.L., Rokhinson, L.P., Sturm, J.C., Appl. Phys. Lett. 73, 3568 (1998).Google Scholar
[5] Wilkes, E.D., Phillips, S.D., Basaran, O.A., Phys. of Fluids 11, 3577 (1999).Google Scholar
[6] Zhang, X.G., J. Coll. Int. Sci. 212, 107 (1999).Google Scholar
[7] Shield, T.W., Bogy, D. B., Talke, F.E., IBM J. Res. Dev. 31, 96 (1987).Google Scholar
[8] Deegan, R.D., Phys. Rev. E 61, 475 (2000).Google Scholar
[9] Adachi, E., Dimitrov, A.S., Nagayama, K., Langmuir 11, 1057 (1995).Google Scholar
[10] Gennes, P.G. de, Revs. Mod. Phys. 57, 827 (1985).Google Scholar
[11] Wu, C.C., Sturm, J.C., Register, R.A., Tian, J., Dana, E.P., Thompson, M.E., IEEE Trans. on Elec. Dev. 44, 1269 (1997).Google Scholar