Hostname: page-component-76fb5796d-qxdb6 Total loading time: 0 Render date: 2024-04-27T02:14:51.971Z Has data issue: false hasContentIssue false
  • English
  • Français

Nanoindentation Study of Amorphous Carbon Coatings for Magnetic Discs

Published online by Cambridge University Press:  10 February 2011

A. J. Czaja  and
W. W. Gerberich
A. J. Czaja
Affiliation:
Department of Chemical Engineering and Materials Science, University of Minnesota, Minneapolis, MN 55123 Seagate Technology, Minneapolis, MN 55420
W. W. Gerberich
Affiliation:
Department of Chemical Engineering and Materials Science, University of Minnesota, Minneapolis, MN 55123
Get access

Abstract

Nanoindentation experiments have been performed to characterize the mechanical properties of very thin amorphous carbon films. Amorphous carbon films on the order of 10 nm or less are required on magnetic thin-film discs to maintain the mechanical integrity of the substrate. In this study, three films in the 10 nm to 80 nm thickness range were studied. The films were sputtered onto an electroless nickel substrate. The primary objective was to use nanoindentation to reliably characterize the elastic modulus and hardness of these very thin films. By making very shallow indents and by using appropriate film-substrate deconvolution techniques, film moduli and hardness in the 75–85 GPa range and 10–11 GPa range were measured, respectively. Finally, shear stresses for nucleation of yielding in the substrate as well as the improved elastic recovery afforded by the amorphous carbon overcoats are discussed.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 522: Symposium T – Fundamentals of Nanoindentation & Nanotribology , 1998 , 293
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Savvides, N. and Bell, T. J., J. Appl. Phys. 72, 2791 (1992)Google Scholar
2. Gerberich, W. W., Yu, W., Kramer, D., Strojny, A., Bahr, D., Lilleodden, E., and Nelson, J., J. Mater. Res. 13, 421 (1998).Google Scholar
3. Sneddon, N. I., Int. J. Eng. Sci 3, 47 (1965).Google Scholar
4. Hertz, H., J. Mathematik 92, 156 (1882).Google Scholar
5. Field, J. S. and Swain, M. V., J. Mater. Res 7, 1580 (1992).Google Scholar
6. Doemer, M. F. and Nix, W. D., J. Mater. Res. 1, 601 (1986).Google Scholar
7. Oliver, W. C. and Pharr, G. M., J. Mater. Res. 7, 1580 (1992).Google Scholar
8. King, R. B., Int. J. Solids Structures 23, 1657 (1987).Google Scholar
9. Johnson, K. L., Contact Mechanics, (Cambridge University Press, New York, 1985), p.62 Google Scholar