Hostname: page-component-78c5997874-94fs2 Total loading time: 0 Render date: 2024-10-31T23:11:46.255Z Has data issue: false hasContentIssue false

Study of Stress and Morphology of Silicon–On–Insulator by Means of Ultraviolet Reflectance Spectroscopy

Published online by Cambridge University Press:  21 February 2011

Bea M Lacquet
Affiliation:
Sensors Sources and Signal Processing Research Group, Faculty of Engineering, Rand Afrikaans University, P O Box 524, Johannesburg, 2000, South Africa.
Pieter L Swart
Affiliation:
Sensors Sources and Signal Processing Research Group, Faculty of Engineering, Rand Afrikaans University, P O Box 524, Johannesburg, 2000, South Africa.
Get access

Abstract

SOI material was prepared by implanting a high dose of nitrogen into crystalline silicon at an energy of 160 keY to form a buried layer of silicon nitride. Ultraviolet reflectance spectroscopy was employed to characterize the material. In the current presentation the isothermal annealing behaviour of the surface material was investigated with regard to amorphization and stress. Measured UV–reflectance of the samples are compared to simulated reflectance data which were obtained by presenting the implanted material as a layered structure with the surface layer consisting of a mixed layer of amorphous and crystalline silicon. From these simulations the percentage amorphization at each stage during the annealing cycle is quantitatively determined. Stress is qualitatively determined by considering the shift in the position of the frequencies at which reflectance maxima associated with Van Hove singularities are observed in the ultraviolet range. The annealing cycle used in this work proved to be adequate for returning the material back to single crystal status and relieving the initial stress in this layer.

Type
Research Article
Copyright
Copyright © Materials Research Society 1989

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Chen, W.Y., Stegen, G.R.; J. Geophys. Res., 79 (1974) 3019.Google Scholar
2. Imai, K., Unno, H.; IEEE Trans. Elect. Dev., ED–31 (1984) 297.Google Scholar
3. Douglas, J.H.; High Technol. (1983) 55.Google Scholar
4. Bean, K.E.; J. Electrochem. Soc., 124 (1977) 50.Google Scholar
5. Partridge, S.L.; Proc. IEEE. 133 (1986) 106.Google Scholar
6. Moss, T.S., Burrell, G.J., Ellis, B.; Semiconductor Opto-Electronics, Butterworths, London, 1973.Google Scholar
7. Greenaway, D.L., Harbeke, G.; Optical Properties and Band Structure of Semiconductors, Pergamon Press, Oxford, 1968.Google Scholar
8. Schmidt, E.; Appl. Optics, 8 (1969) 1905.Google Scholar
9. Palik, E.D.; Handbook of Optical Constants of Solids, Academic Press, Florida, 1985.Google Scholar
10. Aspnes, D.E., Theeten, J.B., Hottier, F.; Phys. Rev. 20 (1979) 3292.Google Scholar
11. Collins, R.W., Cavese, J.; J. Vac. Sci. Technol., A5 (1987) 2797.Google Scholar
12. Lacquet, B.M.; Optical Modelling and Characterization of silicon-oninsulator layers and related structures, D.Eng. Thesis, RAU 1988.Google Scholar
13. Bruggeman, D.A.G.; Annal. Phys. (Leipzig), 24(1935) 633.Google Scholar
14. Paul, W.; Proc Int School of Phys. “Enrico Fermi,”, Course 34 (1966) 256.Google Scholar
15. Gerhardt, U.; Phys. Rev. Lett., 15 (1965) 401.Google Scholar