Hostname: page-component-848d4c4894-75dct Total loading time: 0 Render date: 2024-05-21T11:37:42.421Z Has data issue: false hasContentIssue false
  • English
  • Français

Hydromechanics of lunate-tail swimming propulsion. Part 2

Published online by Cambridge University Press:  11 April 2006

M. G. Chopra  and
T. Kambe
M. G. Chopra
Affiliation:
Department of Applied Mathematics and Theoretical Physics, University of Cambridge Present address: Defence Science Laboratory, Metcalfe House, Delhi, India.
T. Kambe
Affiliation:
Department of Applied Mathematics and Theoretical Physics, University of Cambridge Present address: Department of Physics, University of Tokyo, Hongo, Bunkyo-ku, Tokyo, Japan
Get access Rights & Permissions [Opens in a new window]

Abstract

This paper investigates the propulsive performance of the lunate tails of aquatic animals achieving high propulsive efficiency (the hydromechanical efficiency being defined as the ratio of the work done by the mean forward thrust to the mean rate at which work is done by the tail movements on the surrounding fluid). Small amplitude heaving and pitching motions of a finite flat-plate wing of general planform with a rounded leading edge and a sharp trailing edge are considered. This is a generalization of Chopra's (1974) work on model rectangular tails. This motion characterizes vertical oscillations of the horizontal tail flukes of some cetacean mammals. The same oscillations, turned through a right angle to become horizontal motions of side-slip and yaw, characterize the caudal fins of certain fast-swimming fishes; viz. wahoo, tunny, wavyback skipjack, etc., from the Percomorphi and whale shark, porbeagle, etc., from the Selachii. Davies’ (1963, 1976) method of finding the loading distribution on the wing and generalized force coefficients, through approximate solution of an integral equation relating the loading and the upwash (lifting-surface theory), is used to find the total thrust and the rate of working of the tail, which in turn specify the hydromechanical swimming performance of the animals. The physical parameters concerned are the tail aspect ratio ((span)2/planform area), the reduced frequency (angular frequency x typical length/forward speed), the feathering parameter (the ratio of the tail slope to the slope of the path of the pitching axis), the position of the pitching axis, and the curved shapes of the leading and trailing edges. The variation of the thrust and the propulsive efficiency with these parameters has been discussed to indicate the optimum shape of the tail. It is found that, compared with a rectangular tail, a curved leading edge as in lunate tails gives a reduced thrust contribution from the leading-edge suction for the same total thrust; however, a sweep angle of the leading edge exceeding about 30° leads to a marked reduction of efficiency. Another implication of the present analysis is that no negative work is involved in the actual oscillation of the tail.

The present results are used to obtain an estimate of the drag coefficient for the motion of the animals, based on observed data and the computed thrust. The results show some evidence of differences between the CD's for cetacean mammals and scombroid fish respectively. Some discussion of this difference is also given.

Type
Research Article
Information
Journal of Fluid Mechanics , Volume 79 , Issue 1 , 20 January 1977 , pp. 49 - 69
Copyright
© 1977 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Breder, C. M. 1926 Zoologica, 4, 159.
Chopra, M. G. 1974 J. Fluid Mech. 64, 375.
Chopra, M. G. 1976 J. Fluid Mech. 74, 161.
Davies, D. E. 1963 Aero. Res. Counc. R. & M. no. 3409.
Davies, D. E. 1976 R.A.E. Tech. Memo. Structures, no. 881. Royal Aircraft Establishment, Farnborough, Hampshire, England.
Fierstine, H. L. & Walters, V. 1968 Mem. S. Calif. Acad. Sci. 6, 1.
Goldstein, S. 1938 Modern Development in Fluid Dynamics, vol. 2. Oxford University Press.
Hoerner, S. F. 1965 Fluid-Dynamic Drag. Published by the author.
Lighthill, M. J. 1960 J. Fluid Mech. 9, 305.
Lighthill, M. J. 1969 Ann. Rev. Fluid Mech. 1, 413.
Lighthill, M. J. 1970 J. Fluid Mech. 44, 265.
Lighthill, M. J. 1971 Proc. Roy. Soc. B 179, 125.
Lighthill, M. J. 1975 Mathematical Biofluiddynamics. Philadelphia: S.I.A.M.
Masuda, H., Araga, C. & Yoshino, T. 1975 Coastal Fishes of Southern Japan. Tokyo: Tokai University Press.
Wu, T. Y. 1961 J. Fluid Mech. 10, 321.
Wu, T. Y. 1971a J. Fluid Mech. 46, 337.
Wu, T. Y. 1971b J. Fluid Mech. 46, 521.
Wu, T. Y. 1971c J. Fluid Mech. 46, 545.
Wu, T. Y. 1971d Adv. in Appl. Mech. 11, 1.