3 results
Global dynamics and topology of two-phase mixing layer flow through simultaneous gas and liquid velocity measurements
- Alessandro Della Pia, Theodoros Michelis, Matteo Chiatto, Marios Kotsonis, Luigi de Luca
-
- Journal:
- Journal of Fluid Mechanics / Volume 981 / 25 February 2024
- Published online by Cambridge University Press:
- 19 February 2024, A13
-
- Article
- Export citation
-
This study reports the first time-resolved particle image velocimetry characterization of a planar two-phase mixing layer flow, whose velocity field is measured simultaneously in gas and liquid streams. Two parallel air and water flows meet downstream of a splitter plate, giving rise to an initially spanwise invariant configuration. The aim is to elucidate further the mechanisms leading to the flow breakup in gas-assisted atomization. The complete experimental characterization of the velocity field represents a database that could be used in data-driven reduced-order models to investigate the global behaviour of the flow system. After the analysis of a selected reference case, a parametric study of the flow behaviour is performed by varying the liquid ($Re_l$) and gas ($Re_g$) Reynolds numbers, and as a consequence also the gas-to-liquid dynamic pressure ratio ($M$), shedding light on both time-averaged (mean) and unsteady velocity fields. In the reference case, it is shown that the mean flow exhibits a wake region just downstream of the splitter plate, followed by the development of a mixing layer. By increasing both $Re_l$ and $Re_g$, the streamwise extent of the wake decreases and eventually vanishes, the flow resulting in a pure mixing layer regime. The spectral analysis of the normal-to-flow velocity fluctuations outlines different flow regimes by variation of the governing parameters, giving more insights into the global characteristics of the flow field. As a major result, it is found that at high $Re_g$ and $M$ values, the velocity fluctuations are characterized by low-frequency temporal oscillations synchronized in several locations within the flow field, which suggest the presence of a global mode of instability. The proper orthogonal decomposition of velocity fluctuations, performed in both gas and liquid phases, reveals finally that the synchronized oscillations are associated with a low-frequency dominant flapping mode of the gas–liquid interface. Higher-order modes correspond to interfacial wave structures travelling with the so-called Dimotakis velocity. For lower gas Reynolds numbers, the leading modes describe higher frequency fingers shedding at the interface.
On the origin of spanwise vortex deformations in laminar separation bubbles
- Theodoros Michelis, Serhiy Yarusevych, Marios Kotsonis
-
- Journal:
- Journal of Fluid Mechanics / Volume 841 / 25 April 2018
- Published online by Cambridge University Press:
- 19 February 2018, pp. 81-108
-
- Article
-
- You have access Access
- Open access
- HTML
- Export citation
-
This work investigates the three-dimensional, spatio-temporal flow development in the aft portion of a laminar separation bubble. The bubble is forming on a flat plate geometry, subjected to an adverse pressure gradient, featuring maximum reverse flow of approximately 2 % of the local free-stream velocity. Time-resolved velocity measurements are performed by means of planar and tomographic particle image velocimetry, in the vicinity of the reattachment region. The measurements are complemented with a numerical solution of the boundary layer equations in the upstream field. The combined numerical and measured boundary layer is used as a baseline flow for linear stability theory analysis. The results provide insight into the dynamics of dominant coherent structures that form in the separated shear layer and deform along the span. Stability analysis shows that the flow becomes unstable upstream of separation, where both normal and oblique modes undergo amplification. While the shear layer roll up is linked to the amplification of the fundamental normal mode, the oblique modes at angles lower than approximately $30^{\circ }$ are also amplified substantially at the fundamental frequency. A model based on the stability analysis and experimental measurements is employed to demonstrate that the spanwise deformations of rollers are produced due to a superposition of normal and oblique instability modes initiating upstream of separation. The degree of the initial spanwise deformations is shown to depend on the relative amplitude of the dominant normal and oblique waves. This is confirmed by forcing the normal mode through a controlled impulsive perturbation introduced by a spanwise invariant dielectric-barrier-discharge plasma actuator, resulting in the formation of spanwise coherent vortices. The findings elucidate the link between important features in the bubble shedding dynamics and stability characteristics and provide further clarification on the differences in the development of coherent structures seen in recent experiments. Moreover, the results present a handle on the development of effective control strategies that can be used to either promote or suppress shedding in separation bubbles, which is of interest for system performance improvement and control of aeroacoustic emissions in relevant applications.
Response of a laminar separation bubble to impulsive forcing
- Theodoros Michelis, Serhiy Yarusevych, Marios Kotsonis
-
- Journal:
- Journal of Fluid Mechanics / Volume 820 / 10 June 2017
- Published online by Cambridge University Press:
- 12 May 2017, pp. 633-666
-
- Article
- Export citation
-
The spatial and temporal response characteristics of a laminar separation bubble to impulsive forcing are investigated by means of time-resolved particle image velocimetry and linear stability theory. A two-dimensional impulsive disturbance is introduced with an alternating current dielectric barrier discharge plasma actuator, exciting pertinent instability modes and ensuring flow development under environmental disturbances. Phase-averaged velocity measurements are employed to analyse the effect of imposed disturbances at different amplitudes on the laminar separation bubble. The impulsive disturbance develops into a wave packet that causes rapid shrinkage of the bubble in both upstream and downstream directions. This is followed by bubble bursting, during which the bubble elongates significantly, while vortex shedding in the aft part ceases. Duration of recovery of the bubble to its unforced state is independent of the forcing amplitude. Quasi-steady linear stability analysis is performed at each individual phase, demonstrating reduction of growth rate and frequency of the most unstable modes with increasing forcing amplitude. Throughout the recovery, amplification rates are directly proportional to the shape factor. This indicates that bursting and flapping mechanisms are driven by altered stability characteristics due to variations in incoming disturbances. The emerging wave packet is characterised in terms of frequency, convective speed and growth rate, with remarkable agreement between linear stability theory predictions and measurements. The wave packet assumes a frequency close to the natural shedding frequency, while its convective speed remains invariant for all forcing amplitudes. The stability of the flow changes only when disturbances interact with the shear layer breakdown and reattachment processes, supporting the notion of a closed feedback loop. The results of this study shed light on the response of laminar separation bubbles to impulsive forcing, providing insight into the attendant changes of flow dynamics and the underlying stability mechanisms.