The evolution of fatigue performance and surface mechanical properties of AISI 304 stainless steel induced by the electropulsing-assisted ultrasonic surface rolling process (EP-USRP) was systematically investigated by integrating instrumented indentation, scanning electron microscopy with electron backscatter diffraction, and transmission electron microscopy. The results indicate that higher hardness, greater strength, finer ultra-refined grains, and higher residual compressive stress are formed within the strengthened layer compared with the original ultrasonic surface rolling process (USRP). EP-USRP with the optimized experimental parameters can produce a higher average rotating bending fatigue strength for AISI 304 stainless steel than USRP. Anomalously and noteworthily, all fatigue specimens treated by EP-USRP showed an incomplete fracture, revealing a higher reservation of safety in practical engineering applications. The further modified structure strengthening and stress strengthening induced by EP-USRP are likely the primary intrinsic reasons for the observed phenomena. Furthermore, the influence mechanism of EP-USRP was discussed scrupulously.

Internal stresses and textures of electroplated copper films (t=2, 8, 15, 30, 45, and 60) electrodeposited on Al substrates were studied using X-ray diffraction techniques. Results show that the stresses in the films are tensile. The 8 to 60 μm thick films have (220) fiber texture, in good agreement with strain energy minimization calculation. Results also show that a further rotational alignment of the fiber-textured grains was developed, and small amounts of the fiber-textured grains have their (2, −2, 0) planes aligned parallel to the flow direction of the electrodeposited currents. The degree of the rotation alignment increases with film thickness. Values of stress and the degree of texture of copper films were found to be adjustable using an ultrasound technique. Internal stress and the degree of the (220) texture decrease significantly by applying an ultrasound treatment during the electrodeposition process.

It is well known that c-Jun N-terminal kinase (JNK) plays pivotal roles in various mitotic events, but its function in mammalian oocyte meiosis remains unknown. In this study, we found that no specific JNK2 signal was detected in germinal vesicle stage. JNK2 was associated with the spindles especially the spindle poles and cytoplasmic microtubule organizing centers at prometaphase I, metaphase I, and metaphase II stages. JNK2 became diffusely distributed and associated with the midbody at telophase I stage. Injection of myc-tagged JNK2α1 mRNA into oocytes also revealed its localization on spindle poles. The association of JNK2 with spindle poles was further confirmed by colocalization with the centrosomal proteins, γ-tubulin and Plk1. Nocodazole treatment showed that JNK2 may interact with Plk1 to regulate the spindle assembly. Then we investigated the possible function of JNK2 by JNK2 antibody microinjection and JNK specific inhibitor SP600125 treatment. These two manipulations caused abnormal spindle formation and decreased the rate of first polar body (PB1) extrusion. In addition, inhibition of JNK2 resulted in impaired localization of Plk1. Taken together, our results suggest that JNK2 plays an important role in spindle assembly and PB1 extrusion during mouse oocyte meiotic maturation.