3 results
Linear stability of confined flow around a 180-degree sharp bend
- Azan M. Sapardi, Wisam K. Hussam, Alban Pothérat, Gregory J. Sheard
-
- Journal:
- Journal of Fluid Mechanics / Volume 822 / 10 July 2017
- Published online by Cambridge University Press:
- 09 June 2017, pp. 813-847
-
- Article
- Export citation
-
This study seeks to characterise the breakdown of the steady two-dimensional solution in the flow around a 180-degree sharp bend to infinitesimal three-dimensional disturbances using a linear stability analysis. The stability analysis predicts that three-dimensional transition is via a synchronous instability of the steady flows. A highly accurate global linear stability analysis of the flow was conducted with Reynolds number $\mathit{Re}<1150$ and bend opening ratio (ratio of bend width to inlet height) $0.2\leqslant \unicode[STIX]{x1D6FD}\leqslant 5$. This range of $\mathit{Re}$ and $\unicode[STIX]{x1D6FD}$ captures both steady-state two-dimensional flow solutions and the inception of unsteady two-dimensional flow. For $0.2\leqslant \unicode[STIX]{x1D6FD}\leqslant 1$, the two-dimensional base flow transitions from steady to unsteady at higher Reynolds number as $\unicode[STIX]{x1D6FD}$ increases. The stability analysis shows that at the onset of instability, the base flow becomes three-dimensionally unstable in two different modes, namely a spanwise oscillating mode for $\unicode[STIX]{x1D6FD}=0.2$ and a spanwise synchronous mode for $\unicode[STIX]{x1D6FD}\geqslant 0.3$. The critical Reynolds number and the spanwise wavelength of perturbations increase as $\unicode[STIX]{x1D6FD}$ increases. For $1<\unicode[STIX]{x1D6FD}\leqslant 2$ both the critical Reynolds number for onset of unsteadiness and the spanwise wavelength decrease as $\unicode[STIX]{x1D6FD}$ increases. Finally, for $2<\unicode[STIX]{x1D6FD}\leqslant 5$, the critical Reynolds number and spanwise wavelength remain almost constant. The linear stability analysis also shows that the base flow becomes unstable to different three-dimensional modes depending on the opening ratio. The modes are found to be localised near the reattachment point of the first recirculation bubble.
Linear stability and energetics of rotating radial horizontal convection
- Gregory J. Sheard, Wisam K. Hussam, Tzekih Tsai
-
- Journal:
- Journal of Fluid Mechanics / Volume 795 / 25 May 2016
- Published online by Cambridge University Press:
- 13 April 2016, pp. 1-35
-
- Article
- Export citation
-
The effect of rotation on horizontal convection in a cylindrical enclosure is investigated numerically. The thermal forcing is applied radially on the bottom boundary from the coincident axes of rotation and geometric symmetry of the enclosure. First, a spectral element method is used to obtain axisymmetric basic flow solutions to the time-dependent incompressible Navier–Stokes equations coupled via a Boussinesq approximation to a thermal transport equation for temperature. Solutions are obtained primarily at Rayleigh number $\mathit{Ra}=10^{9}$ and rotation parameters up to $Q=60$ (where $Q$ is a non-dimensional ratio between thermal boundary layer thickness and Ekman layer depth) at a fixed Prandtl number $\mathit{Pr}=6.14$ representative of water and enclosure height-to-radius ratio $H/R=0.4$. The axisymmetric solutions are consistently steady state at these parameters, and transition from a regime unaffected by rotation to an intermediate regime occurs at $Q\approx 1$ in which variation in thermal boundary layer thickness and Nusselt number are shown to be governed by a scaling proposed by Stern (1975, Ocean Circulation Physics. Academic). In this regime an increase in $Q$ sees the flow accumulate available potential energy and more strongly satisfy an inviscid change in potential energy criterion for baroclinic instability. At the strongest $Q$ the flow is dominated by rotation, accumulation of available potential energy ceases and horizontal convection is suppressed. A linear stability analysis reveals several instability mode branches, with dominant wavenumbers typically scaling with $Q$. Analysis of contributing terms of an azimuthally averaged perturbation kinetic energy equation applied to instability eigenmodes reveals that energy production by shear in the axisymmetric mean flow is negligible relative to that produced by conversion of available potential energy from the mean flow. An evolution equation for the quantity that facilitates this exchange, the vertical advective buoyancy flux, reveals that a baroclinic instability mechanism dominates over $5\lesssim Q\lesssim 30$, whereas stronger and weaker rotations are destabilised by vertical thermal gradients in the mean flow.
Combining an obstacle and electrically driven vortices to enhance heat transfer in a quasi-two-dimensional MHD duct flow
- Ahmad H. A. Hamid, Wisam K. Hussam, Gregory J. Sheard
-
- Journal:
- Journal of Fluid Mechanics / Volume 792 / 10 April 2016
- Published online by Cambridge University Press:
- 03 March 2016, pp. 364-396
-
- Article
- Export citation
-
The design of vortex promoters in a heated-wall duct is often limited by the considerations of practicality, especially in complex systems such as fusion blankets. The present study investigates the use of current injection to invoke a street of vortices in quasi-two-dimensional high transverse magnetic field magnetohydrodynamic duct flows to enhance instability behind a cylinder. The intent is to generate intensive flow vorticity parallel to a magnetic field downstream of a field-aligned cylinder. Electric current enters the flow through an electrode embedded in one of the Hartmann walls, radiates outward, imparting a rotational forcing around the electrode due to the Lorentz force. The quasi-two-dimensional nature of these flows then promotes a vortical rotation across the interior of the duct with axis aligned to the magnetic field. The hot and cold walls are parallel to the magnetic field. Electric current amplitude and pulse width, excitation frequency and electrode position are systematically varied to explore their influences on the convective heat transport phenomenon. This investigation builds on a recommendation from previous work of Bühler (J. Fluid Mech., vol. 326, 1996, pp. 125–150) dedicated to understanding of the flow stability in a similar configuration. This study provides supportive evidence for the use of current injection as an alternative to the conventional mechanically actuated turbuliser, with heat transfer almost doubled for negligible additional pumping power requirements.