Small luminescent Y2O3:Eu3+ particles were prepared by a hydrothermal method first, and then, Y2O3:Eu3+/C3N4 nanocomposites were further prepared by a chemisorption method. The luminescent Y2O3:Eu3+/C3N4 nanocomposites are not only a promising down-conversion luminescent material, but also it could be used to improve the efficiencies of dye-sensitized solar cells (DSSCs). Especially, the morphology of Y2O3:Eu3+ has great influence on the performance of DSSCs. Compared with Y2O3:Eu3+ nanorods, the introduction of small Y2O3:Eu3+ particles into the cells is conducive to the improvement of cell efficiency. The efficiencies of TiO2-Y2O3:Eu3+–C3N4 composite cells were not only higher than those of pure TiO2 cells but also higher than those of TiO2-Y2O3:Eu3+ or TiO2-C3N4 composite cells, resulting in the enhancement of the average efficiency of the TiO2-Y2O3:Eu3+–C3N4 composite cell from 7.16% to 8.14%, with 14% improvement over the pure TiO2 cell. The enhancement of the efficiency can be attributed to the synergetic effect of small Y2O3:Eu3+ particles and C3N4.

Sulphur reduction catalysts represent a viable option for S reduction in the fluid catalytic cracking (FCC) process. In this paper, a kaolin in situ crystallization catalyst was modified with vanadium and evaluated in a fixed fluid bed (FFB) reactor. The relation between the acidity of the catalyst, the S reduction rate and the catalyst activity is discussed. The results show that increasing weak Lewis acid acidity favours S reduction in the FCC process. Increasing the V content enhances the weak Lewis acidity, so causing the S reduction rate to increase. The kaolin in situ crystallization catalyst modified with 0.6 wt.% of V leads to a 34.5% reduction in the S content of the liquid product. Comprehensive evaluation of the FFB results and the S reduction ability indicates that the catalyst modified with 0.45 wt.% V provided the best performance.

The effects of acid and Al concentration, type of Al salt, treatment temperature and time of removal of Mg from sepiolite have been investigated, as has the use of modified sepiolite as an active fluid catalytic cracking (FCC) matrix. The samples were characterized by N2 adsorption and X-ray diffraction. Mg removal from sepiolite increased with increasing acid and Al ion concentration, treatment time and temperature. The temperature had the greatest impact on Mg removal. After acid and Al modification, 29% of the Mg was removed. When using the modified sepiolites as active matrices in FCC catalysts, the specific surface area, pore volume and mesoporous pore volume of the catalysts increased and they exhibited excellent performance in resisting the effects of heavy-metals as a result of the introduction of Mg oxide from the modified sepiolite.

A 36C1 peak has been found at about 37 ka BP in the Guliya ice core, drilled from the Qinghai-Tibetan Plateau. This peak is indicative of enhanced cosmogenic isotope production in the atmosphere, rather than a change in accumulation rate. Comparison with the records of 10Be and 36C1 in ice cores from Antarctica and Greenland indicates that peaks of the cosmogenic isotopes are global, and that they can be used as time markers for dating ice cores. Interestingly, the 37 ka BP global event coincided with a cold period.

The authors investigated the effects of annealing in Ar atmosphere at different temperatures (350–1100 °C) on the densification and leakage current characteristics of thermally oxidized SiO2 films on n-type 4H-SiC. A strong correlation between densification improvement and leakage current reduction was observed. Densification of the SiO2 films, which were characterized by spectroscopic ellipsometry, Fouriertransform infrared spectroscopy and atomic force microscopy, can be significantly improved after annealing at moderate temperature (600 °C). The leakage current is decreased by two orders of magnitude of the SiO2 thin film after annealing at 600 °C. Based on the studies, SiO2 film of the highest quality can be obtained after annealing at 600 °C. Improvements in the quality of the SiO2 thin films after annealing at 600 °C may be explained by the consumption and formation of carbon-related and oxygen-related defects during annealing.

Amplified fragment length polymorphism (AFLP) markers linked to the stem nematode resistance gene were developed in sweet potato (Ipomoea batatas (L.) Lam.). Using bulked segregant analysis (BSA), 800 AFLP primer combinations were screened in the resistant and susceptible bulked DNA from the 186 progeny of an F1 single-cross population of Xu781 (resistant parent)×Xushu18 (susceptible parent), and 245 of these AFLP primers showed polymorphic bands between resistant and susceptible DNA. Primer combinations detecting polymorphism between the two bulks were used to screen the parents and eight individuals from each of the bulks. The results showed that E2M23 and E33M20 produced a specific band of about 500 bp and 200 bp in length, respectively, in the resistant plants but not in the susceptible plants, suggesting that the markers named E2M23500 and E33M20200 linked to a gene for stem nematode resistance. Amplified analysis of the 186 F1 individuals indicated that the genetic distance between these two markers and the stem nematode resistance gene was 6.9 cM and 11.1 cM, respectively, measured with Mapmaker 3.0. These two AFLP markers were used to identify ten sweet potato varieties planted widely in China and the results were consistent with those of conventional resistance identification, indicating that the two markers can be used in molecular marker-assisted breeding for stem nematode resistance in the sweet potato.

The RNA-dependent RNA polymerase (RdRp) gene of Bombyx mori cypovirus 1 (BmCPV-1) (China strain) was cloned in three fragments using step-by-step reverse transcriptase-polymerase chain reaction (RT-PCR). The whole RdRp gene of 3691 bp was sequenced (GenBank accession number: AY496445). Vector pET-28b(+) was used to construct the expression vector pET28b–RdRp which was expressed in Escherichia coli BL21 (DE3) induced with isopropyl β-d-thiogalactoside (IPTG). The molecular weight of the expression product was about 138 Da. The primary antibody employed was rabbit antibody against BmCPV–RdRp recombinant protein and the secondary antibody was 15 nm immunogold-labelled goat anti-rabbit IgG. Immunogold was mostly bound to the virions which were dispersed in a virus generation matrix and polyhedron in the columnar cells of the midgut of the silkworms, and the average marking ratio was about 35%. This result demonstrated that BmCPV–RdRp complexes are indeed located at the BmCPV capsid.

The bone morphogenetic protein receptor IB (BMPR-IB) gene, which controls the fecundity of Booroola Merino ewes, was studied as a candidate gene for the prolificacy of Small Tail Han and Hu ewes. A single nucleotide polymorphism of the BMPR-IB gene was detected in both high (Small Tail Han and Hu) and low (Suffolk and Dorset) fecundity sheep breeds by polymerase chain reaction–single-strand conformation polymorphism (PCR-SSCP) analysis. The results indicated the presence of the same mutation (A746G) of the BMPR-IB gene in both Small Tail Han and Hu ewes and in Booroola Merino ewes, but not in both Suffolk and Dorset ewes. In Small Tail Han ewes, frequencies of BB, B+ and ++ genotypes were 0.524, 0.383 and 0.093, respectively. In Hu ewes, these frequencies were 0.882, 0.118 and 0.000. The BMPR-IB genotype distributions were significantly different (P<0.001) among high- and low-fecundity sheep breeds. Small Tail Han ewes with genotype BB had 0.92 (P<0.01) and 1.02 (P<0.01) lambs more than those with genotype ++ in the first and second parity, respectively. These results demonstrated that the BMPR-IB gene is a major gene affecting the prolificacy in both Small Tail Han and Hu ewes, and could be used as a molecular genetic marker to select the litter size in sheep.