Hostname: page-component-76fb5796d-25wd4 Total loading time: 0 Render date: 2024-04-26T05:38:46.428Z Has data issue: false hasContentIssue false
  • English
  • Français

Predicted performance characteristics of avariable cycle turbofan

Published online by Cambridge University Press:  04 July 2016

I. Ulizar  and
P. Pilidis
I. Ulizar
Affiliation:
Industria de Turbopropulsores - Ajalvir Torrejon de Ardoz Madrid, Spain
P. Pilidis
Affiliation:
School of Mechanical EngineeringCranfield University Bedford, UK
Get access Rights & Permissions [Opens in a new window]

Abstract

The selective bleed turbofan is a two shaft, three compressor, variable cycle aircraft engine. Its bypass ratio (BPR) can be modulated to suit the operating flight conditions. At subsonic flight speeds it operates as a medium bypass turbofan (low pressure mode or LPM). It becomes a low bypass turbofan (high pressure mode or HPM) when flying faster and is capable of supersonic cruise without reheat (RH).

The aim of this paper is to describe the selection of the main engine design parameters in the HP mode and to outline the challenges to be met to enable the powerplant to operate in the other mode. The components have to perform satisfactorily over a wide range of varying conditions. The resulting demands are reflected in many ways, for example in the operating lines of the low pressure compressors and in the overall efficiency changes with increased bypass ratio. In the case of the present investigation the two bypass ratios selected are 0·3 for the high pressure mode and 0·7 for the low pressure mode. The latter was selected after an examination of a choice of bypass ratios ranging from 0·4 to 1·0. The change in variable stators required to achieve the LP mode cycle is indicated.

The effect of changing bypass ratio on engine performance and handling is shown. The main conclusion is that the design of this engine seems to be feasible within current technological capabilities and further investigation is encouraged because it appears to yield significant benefits.

Type
Research Article
Information
The Aeronautical Journal , Volume 101 , Issue 1006 , July 1997 , pp. 263 - 268
Copyright
Copyright © Royal Aeronautical Society 1997 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Adkins, R.C. and Pilidis, P. Advanced Propulsion Systems for STOVL Aircraft, Internal Cranfield Report, Unpublished, Cranfield Institute of Technology, 1987.Google Scholar
2. do Nascimento, M.A.R. The Selective Bleed Variable Cycle Engine, PhD Thesis, Cranfield Institute of Technology, 1992.Google Scholar
3. do Nascimento, M.A.R. and Pilidis, P. The selective bleed variable cycle engine, ASME Paper 91-GT-388.Google Scholar
4. Gammon, N. Aircraft Engine Design for AStovl aircraft, Thermal Power MSc Thesis, Cranfield Institute of Technology, 1988.Google Scholar
5. Ulizar, J.I. and Pilidis, P. The handling of a variable cycle engine: selective bleed turbofan, ASME Paper 93-GT-384.Google Scholar
6. Ulizar, J.I. Design and Off-Design Performance Study of a Variable Cycle Engine, with Con-Di Nozzle, Thermal Power MSc Thesis, Cranfield Institute of Technology, 1992.Google Scholar
7. Palmer, J.R. The TURBOMATCH Scheme for Gas Turbine Performance Calculations, Users' Guide, SME, Cranfield Institute of Technology, October 1983.Google Scholar