Hostname: page-component-848d4c4894-m9kch Total loading time: 0 Render date: 2024-05-16T03:07:07.510Z Has data issue: false hasContentIssue false

An Approximate Method for the Calculation of Turbulent Boundary Layers in Diffusers

Published online by Cambridge University Press:  07 June 2016

J. F. Norbury*
Affiliation:
Department of Fluid Mechanics, University of Liverpool
Get access

Summary

An approximate method is described for the calculation of turbulent boundary layers in which the turbulence is developed before the commencement of the adverse pressure gradient, as in most diffuser layers. It is based on a method due to Spence which has been modified and also extended to the calculation of three-dimensional diverging layers such as occur in ducts whose breadth is increasing. The velocity profiles occurring in a diverging layer are examined and it is shown that the inner part obeys the universal logarithmic law, as in two-dimensional layers. This result is used to obtain an equation for the form parameter in diverging layers, by substitution in the equation of motion and incorporation of the equations of momentum and continuity for diverging flow. The form parameter equation contains a term involving the gradient of shear stress at y = θ and values of this term are obtained by the analysis of experimental data and the substitution of known values for all the other terms in the form parameter equation. Values of the term involving shear stress gradient are then correlated in terms of known boundary layer quantities, and the resulting correlation allows the formulation of a step-by-step method for the solution of the form parameter equation. This may be used in conjunction with the momentum equation to predict the boundary layer growth. It was not found possible to effect a satisfactory correlation for boundary layers on lifting aerofoils, in which the turbulence develops within the adverse pressure gradient, and the method cannot be used for the prediction of such layers. The results of a number of calculations are given.

Type
Research Article
Copyright
Copyright © Royal Aeronautical Society. 1957

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Rubert, K. F. and Persh, J. A procedure for Calculating the Development of Turbulent Boundary Layers under the Influence of Adverse Pressure Gradients. N.A.C.A. T.N. 2478, 1950.Google Scholar
2. Spence, D. A. The Development of Turbulent Boundary Layers. Journal of the Aeronautical Sciences, Vol. 23, p. 3, January 1956.CrossRefGoogle Scholar
3. Ludwieg, H. and Tillmann, W. Investigation of the Wall Shearing Stress in Turbulent Boundary Layers. Untersuchungen uber die Wandschubspannung in turbulenten Reibungsschichten. N.A.C.A. T.M. 1285, A.R.C. 14,800, 1950.Google Scholar
4. Squire, H. B. and Young, A. D. The Calculation of the Profile Drag of Aerofoils. R. & M. 1838, 1937.Google Scholar
5. Schubauer, G. B. and Klebanoff, P. S. Investigation of Separation of the Turbulent Boundary Layer. N.A.C.A. Report 1030, 1950.Google Scholar
6. McCullough, G. B. and Gault, D. E. Examples of Three Representative Types of Airfoil-Section Stall at Low Speeds. N.A.C.A. T.N. 2502, 1951.Google Scholar
7. Altman, J. M. and Hayter, Nora-Lee F. A Comparison of the Turbulent Boundary Layer on an Unswept and a Swept Wing. N.A.C.A. T.N. 2500, 1951.Google Scholar
8. Von Doenhoff, A. E. and Tetervin, N., Determination of General Relations for the Behaviour of Turbulent Boundary Layers. N.A.C.A. Report 772, 1943.Google Scholar
9. Sandborn, V. A. Preliminary Experimental Investigation of Low-speed Turbulent Boundary Layers in Adverse Pressure Gradients. N.A.C.A. T.N. 3031, 1953.Google Scholar
10. Maskell, E. C. Approximate Calculation of the Turbulent Boundary Layer in Two-dimensional Incompressible Flow. A.R.C. 14, 654, 1951.Google Scholar