Hostname: page-component-7dd5485656-wxk4p Total loading time: 0 Render date: 2025-10-31T09:38:16.772Z Has data issue: false hasContentIssue false
  • English
  • Français

A mathematical model for the dynamic desulfurization process ofultra-low-sulfur steel in the LF refining process

Published online by Cambridge University Press:  05 March 2014

Ya-nan Chen Chen ,
Yan -ping Bao ,
Min Wang ,
Li -hua Zhao  and
Zun Peng
Ya-nan Chen Chen
Affiliation:
State Key Laboratory of Advanced Metallurgy, University of Science and Technology Beijing, Beijing 100083, P.R. China. e-mail: ustbchenyanan@gmail.com School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing, Beijing 100083, P.R. China
Yan -ping Bao
Affiliation:
State Key Laboratory of Advanced Metallurgy, University of Science and Technology Beijing, Beijing 100083, P.R. China. e-mail: ustbchenyanan@gmail.com School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing, Beijing 100083, P.R. China
Min Wang
Affiliation:
National Engineering Research Center of Flat Rolling Equipment, University of Science and Technology Beijing, Beijing 100083, P.R. China
Li -hua Zhao
Affiliation:
State Key Laboratory of Advanced Metallurgy, University of Science and Technology Beijing, Beijing 100083, P.R. China. e-mail: ustbchenyanan@gmail.com School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing, Beijing 100083, P.R. China
Zun Peng
Affiliation:
State Key Laboratory of Advanced Metallurgy, University of Science and Technology Beijing, Beijing 100083, P.R. China. e-mail: ustbchenyanan@gmail.com School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing, Beijing 100083, P.R. China
Get access

Abstract

In order to obtain the dynamic variation rule of the sulfur content of liquid steel inthe LF refining process, a complete mathematical model including a desulfurization kineticmodel and temperature model in the deep desulfurization process is presented, based on thepractical production and reaction mechanism of ultra-low-sulfur steel in a LF. The resultsshow that the calculated values of the sulfur content in liquid steel using the model fitthe experimental values well, and the relative error is less than 8%. The effects ofrefining slag on the desulfurization process are analyzed in this paper, which shows thatslag basicity is most important at the early and middle stages of the process, while slagweight is most important at the middle and late stages. The effect of the above factors onthe final sulfur content of liquid steel is further analyzed quantitatively. The simulatedresults provide a theoretical basis to segment control the refining process in order toachieve the maximum effect, improving efficiency, saving energy and reducingconsumption.

Keywords

ladle furnacedeep desulfurizationmathematical modelultra-low-sulfur steel

Information

Type
Research Article
Information
Metallurgical Research & Technology , Volume 111 , Issue 1 , 2014 , pp. 37 - 43
Copyright
© EDP Sciences 2014

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

Schambron, T., Phillips, A.W., O’Brien, D.M. et al., ISIJ Int. 49 (2009) 284
Zhao, M.C., Hanamura, T., Qiu, H. et al., ISIJ Int. 45 (2005) 116
Riboud, P.V., Gatellier, C., Ironmaking Steelmaking 12 (1985) 79–86
Merson, D., Dement’ev, S., Ioffe, A. et al., ISIJ Int. 51 (2011) 1682
Yang, X.M., Jiao, J.S., Ding, R.C. et al., ISIJ Int. 49 (2009) 1828
Li, S.Q., Xiong, G.H., Li, S.Q. et al., J Univ. Sci. Technol. Beijing 26 (2004) 244
Shi, C.B., Yang, X.M. , Jiao, J.S. et al., ISIJ Int. 50 (2010) 1362
Zou, Z.S., Zou, Y.S., Zhang, L.B. et al., ISIJ Int. 41 (2001) S66
Coudure, J.M., Irons, G.A., ISIJ Int. 34 (1994) 155
Asai, Shigeo, Iwao Muchi. ISIJ 55 (1969) 122
Jiang, G.C., Xu, K.D., Guo, Z.C. et al., Acta Metallurgica Sinica 26 (1990) 33
Gornerup M. Studies of Slag Metallurgy in Stainless Steelmaking [Dissertation]. Stockholm: Department of Metallurgy, Royal Institute of Technology (1997)
Nzotta, M.M., Sichen, D., ISIJ Int. 38 (1998) 1170
Ohta, H., Suito, H., Metall Trans. B 28 (1998) 119
Andersson, M.A.T., Jonsson, P.G., Nzotta, M.M., ISIJ Int. 39 (1999) 1140
J.Y. Zhang, Metallurgical physical chemistry, The Metallurgical Industry Press, Beijing, 2009, p. 232 (in Chinese)