Hostname: page-component-7c8c6479df-xxrs7 Total loading time: 0 Render date: 2024-03-29T06:57:09.588Z Has data issue: false hasContentIssue false

1D and 2D Monte Carlo Simulations of Pulsed Laser Ablation Of Si/Ga Into Ar/O2 With A Substrate

Published online by Cambridge University Press:  15 February 2011

D. L. Capewell
Affiliation:
Division of Engineering and Applied Science, California Institute of Technology. Pasadena, CA 91125
D. G. Goodwin
Affiliation:
Division of Engineering and Applied Science, California Institute of Technology. Pasadena, CA 91125
Get access

Abstract

The Direct Simulation Monte Carlo (DSMC) method is applied to the problem of pulsed laser deposition in both 1D and 2D axisymmetric simulations. A source of target atoms expands into a cylindrical volume containing a background gas at room temperature and pressures up to 100 mTorr in the presence of a diffusely reflecting substrate. At regular intervals, the density and temperature of each species are computed. Particle flux and energy per particle incident on the substrate are also monitored as functions of time. The simulation results qualitatively compare well with experimental plume diagnostics, with measured film growth rates as a function of background gas pressure, and with measured changes in film growth stoichiometry resulting from the introduction of a background gas into a two-component PLD system.

Type
Research Article
Copyright
Copyright © Materials Research Society 1995

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

[1] Bird, G. A., Molecular Gas Dynamics and the Direct Simulation of Gas Flows, Oxford University Press, New York, 1994.Google Scholar
[2] Fogarassy, E., Slaoui, A., Fuchs, C., and Stoquert, J. P., Appl. Surf. Sci. 54, 180 (1992).Google Scholar
[3] Geohegan, D. B., Appl. Phys. Lett. 60, 2732 (1992).Google Scholar
[4] Goodwin, D. G., Capewell, D. L. and Paul, P. H., ”Planar laser-induced fluorescence diagnostics of pulsed laser ablation of silicon,” presented at Mat. Res. Soc. Symposium Q, Spring 1995, San Francisco.Google Scholar
[5] Kee, R. J. et al., Technical Report No. SAND86-8246, Sandia National Laboratories (unpublished).Google Scholar
[6] Taylor, M. E., He, G. and Atwater, H. A., ”Inhibited Sn Surface Segregation in Epitaxial SnxGe1−x Alloy films Grown by Pulsed Laser Deposition,” presented at Mat. Res. Soc. Symposium Q, Spring 1995, San Francisco.Google Scholar