Hostname: page-component-cb9f654ff-nr592 Total loading time: 0 Render date: 2025-08-30T22:43:19.214Z Has data issue: false hasContentIssue false
  • English
  • Français

Advanced Metal Matrix Composites

Published online by Cambridge University Press:  21 February 2011

C. Robert Crowe
C. Robert Crowe*
Affiliation:
Naval Research Laboratory, Materials Science and Technology Division, Washington, DC 20375
Get access

Abstract

Advanced metal matrix composites are emerging as materials of construction for high performance aerospace applications. The thrust is to develop high specific strength and high specific modulus ultra-lightweight composites using Al or Mg as matrix materials for space structure applications, and for higher temperature applications, to develop materials using various aluminides as matrix materials. This paper presents an overview of the methodology used to develop advanced MMC's and discusses the problems and limitations faced in achieving the composite materials development goals.

Information

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 125: Symposium N – Materials Stability and Environmental Degradation , 1988 , 31
Copyright
Copyright © Materials Research Society 1988

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

REFERENCES

1. Simenz, R. F., Phil., Trans. Lond, R. Soc, A322, 323 (1987).Google Scholar
2. Piggot, M. R., Load Bearing Fibre Composites, (Pergamon Press: New York: 1980).Google Scholar
3. Stephen Tsai, W., Composite Design, (Think Composites: Dayton, 0: 1986).Google Scholar
4. Chou, T. W. and Kelly, A., Ann. Rev. Mater. Sci., 10, 229 (1980).Google Scholar
5. Schoutens, J. E. and Zarate, D. A., Composites, 17, 188 (1986).Google Scholar
6. Christodoulou, L., Parrish, P. A., and Crowe, C. R., XDTM Titanium Aluminide Composites, MRS Spring Meeting, Reno, NV, April 5, 1988, Paper No. G1.3.Google Scholar
7. Everett, R. K. and Skowronek, C. J., ”The Effect of Consolidation Parameters on the Mechanical Properties and Tensile Failure Modes of Aluminum Ion-Plated Graphite,” in Failure Mechanisms in High Performance Materials, ed. Early, J. G., Shives, T. R., and Smith, J. H. (Cambridge U. Press: Cambridge, MA: 1985) pp. 128–137.Google Scholar
8. Spitzig, W. A., Kelly, J. F., and Richmond, O., Metallography, 18, 26 (1985).Google Scholar
9. Okura, A. and Motoki, K., Com. Sci. and Tech., 24, 243 (1985).Google Scholar
10. Brindley, P. K., NASA Lewis Research Center, unpublished data.Google Scholar