Hostname: page-component-89b8bd64d-mmrw7 Total loading time: 0 Render date: 2026-05-07T08:10:17.055Z Has data issue: false hasContentIssue false

GaN Device Processing

Published online by Cambridge University Press:  10 February 2011

S. J. Pearton
Affiliation:
Department of Materials Science and Engineering, University of Florida, Gainesville, FL
F. Ren
Affiliation:
Bell Laboratories, Lucent Technologies, Murray Hill, NJ
J. C. Zolper
Affiliation:
Office of Naval Research, Arlington, VA
R. J. Shul
Affiliation:
Sandia National Laboratories, Albuquerque, NM
Get access

Abstract

Recent progress in the development of dry and wet etching techniques, implant doping and isolation, thermal processing, gate insulator technology and high reliability contacts is reviewed. Etch selectivities up to 10 for InN over AIN are possible in Inductively Coupled Plasmas using a Cl2/Ar chemistry, but in general selectivities for each binary nitride relative to each other are low (≤2)b ecause of the high ion energies needed to initiate etching. Improved ntype ohmic contact resistances are obtained by selective area Si+ implantation followed by very high temperature (>1300°C) anneals in which the thermal budget is minimized and AIN encapsulation prevents GaN surface decomposition. Implant isolation is effective in GaN, AlGaN and AlInN, but marginal in InGaN. Candidate gate insulators for GaN include AIN, A1ON and Ga(Gd)Ox, but interface state densities are still to high to realize state-of-the-art MIS devices.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable