Hostname: page-component-54dcc4c588-xh45t Total loading time: 0 Render date: 2025-09-12T05:21:33.009Z Has data issue: false hasContentIssue false
  • English
  • Français

Rapid Thermal Processing of Multiple Low Dose Oxygen Implantations for SIMOX

Published online by Cambridge University Press:  28 February 2011

J. Blake ,
J. C. Gelpey ,
D. M. Lee ,
L. Rowland  and
G. A. Rozgony
J. Blake
Affiliation:
Eaton Corporation, Danvers, MA 01923
J. C. Gelpey
Affiliation:
Eaton Corporation, Danvers, MA 01923 Currently with Peak Systems
D. M. Lee
Affiliation:
Department of Materials Science and Engineering North Carolina State University, Raleigh, NC 27695–7916
L. Rowland
Affiliation:
Department of Materials Science and Engineering North Carolina State University, Raleigh, NC 27695–7916
G. A. Rozgony
Affiliation:
Department of Materials Science and Engineering North Carolina State University, Raleigh, NC 27695–7916
Get access

Abstract

A cross-sectional transmission electron microscopy study has been performed on SIMOX wafers prepared using three sequential low dose (6 x 1017 cm2) oxygen implantations. After each implant the wafers were annealed using rapid thermal processing at temperatures up to 1360°C for times of 1 to 5 minutes. The TEM results show that, although low dislocation densities are obtained, oxygen precipitate dissolution is incomplete for these conditions. Therefore, longer annealing times will be required. In addition, lower increments of oxygen dose are recommended to approach dislocation-free superficial silicon layers.

Information

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 107: Symposium H – Silicon-on-Insulator and Buried Metals in Semiconductors , 1987 , 61
Copyright
Copyright © Materials Research Society 1988

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

1 Homma, Y., Oshima, M. and Hayashi, T., Jap. J. Appl. Phys. 21, 890 (1982)Google Scholar
2 Hill, D., Fraundorf, P. and Fraundorf, G., IEEE SOS/SOI Workshop, Durango, CO, Sept. 1987. To be published in J. Appl. Phys., 1988.Google Scholar
3 Cheek, T. and Chen, C.E., These Proceedings.Google Scholar
4 Celler, G. K., Hemment, P. L. F., West, K. W. and Gibson, J. M., Mat. Res. Soc. Symp. Proc. 53, 227 (1986)Google Scholar
5 Krause, S., Jung, C. O. and Wilson, S.R., These Proceedings.Google Scholar
6 Griffin, P. B., Ahm, S. T., Tiller, W. A. and Plummer, J. D., Appl. Phys. Letters 51, 115(1987)Google Scholar