Hostname: page-component-cb9f654ff-nr592 Total loading time: 0 Render date: 2025-08-07T00:12:55.914Z Has data issue: false hasContentIssue false
  • English
  • Français

Characterization of Ceria Stabilized Zirconia Coatings on Metal Substrates

Published online by Cambridge University Press:  28 February 2011

Rosa Di Maggio ,
Paolo Scardi  and
Andrea Tomasi
Rosa Di Maggio
Affiliation:
Department of Materials Engineering,University of Trento,Italy;
Paolo Scardi
Affiliation:
Department of Materials Engineering,University of Trento,Italy;
Andrea Tomasi
Affiliation:
Institute for Scientific and Thecnologic Research,Trento,Italy.
Get access

Abstract

In this study ceria stabilized zirconia was used to obtain an uniform and adherent film on iron and 304 S.S.. Coatings were prepared by dipping in solutions of organometallic precursors of zirconium and cerium. Structure and morphology of samples were investigated using SEM and XRD techniques before and after thermal treatments. The oxidation behaviour in air of coated samples was followed through thermogravimetrical analysis in a range of temperature from 773 K to 1123 K. The preliminary results show, for the samples coated and pretreated in high vacuum at 923 K, a good decrease in oxidation rate.

Information

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 180: Symposium A – Better Ceramics Through Chemistry IV , 1990 , 481
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

REFERENCES

[1] “Sol-gel technology for thin films, fibers, preforms, electronic and specialty shapes”.Edited by Klein, L.C.,Noyes Publications, Parkridge, New Jersey, U.S.A.(1988).Google Scholar
[2] Mackenzie, J.D., Journal of Non-Crystalline Solids 100, 162–168 (1988)Google Scholar
[3] Kundu, D., Biswas, P.K. and Ganguli, D., Thin Solid Films, 163, 273–27 (1988)8.Google Scholar
[4] “Coatings for high temperature applications”. Chapter 6, pg. 169–192.Edited by Lang, E. , Applied Science Publishers, London and New York, (1983).Google Scholar
[5] Izumi, K.,Murakami, M.,Deguchi, T.,Morita, A.,Tohge, N. and Minami, T., J,Am. Ceram. Soc., 72 [8] 1465–68 (1989)Google Scholar
[6] Lutteretti, L. & Scardi, P., J. Appl. Cryst. 23 (1990)Google Scholar