Hostname: page-component-cb9f654ff-w5vf4 Total loading time: 0 Render date: 2025-08-31T17:25:08.208Z Has data issue: false hasContentIssue false
  • English
  • Français

A Comparison of the Experimentally Measured and Theoretically Predicted Temperature Profiles for an Argon Plasma Jet Discharging into a Nitrogen Environment

Published online by Cambridge University Press:  21 February 2011

A.H. Dilawari ,
J. Szekely ,
R. Westhoff ,
B. A. Detering  and
C.B. Shaw Jr
A.H. Dilawari
Affiliation:
Department of Materials Science and Engineering, Massachusetts Institute of Technology, Cambridge, MA. 02139
J. Szekely
Affiliation:
Department of Materials Science and Engineering, Massachusetts Institute of Technology, Cambridge, MA. 02139
R. Westhoff
Affiliation:
Department of Materials Science and Engineering, Massachusetts Institute of Technology, Cambridge, MA. 02139
B. A. Detering
Affiliation:
Idaho National Materials Technology Engineering Laboratory, Idaho Falls, ID. 83415–2210
C.B. Shaw Jr
Affiliation:
Idaho National Materials Technology Engineering Laboratory, Idaho Falls, ID. 83415–2210
Get access

Abstract

Experimental measurements and computed results are reported, describing the behavior of a non-transferred arc plasma torch operating in a laminar mode, discharging into a nitrogen environment. The experimental measurements of the temperature fields in the vicinity of the torch exit, obtained using emission spectroscopy, were compared with theoretical predictions. The calculations were based on the solution of the axi-symmetric heat, mass, momentum, and species balance equations. The theoretical predictions were found to be in excellent agreement with measurement, with the error usually being in the 5–10% range and the maximum error being about 15%.

Information

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 190: Symposium M – Plasma Processing and Synthesis of Materials III , 1990 , 199
Copyright
Copyright © Materials Research Society 1991

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

REFERENCES

1. Grey, J., Sherman, M.P., Williams, P.M. and Frodkin, D.B., AIAA J. 4, 986,(1966).Google Scholar
2. Donaldson, C.P. and Gray, K.E., AIAA J., 4, 2017, (1966).Google Scholar
3. Incropera, I.P. and Leppert, G., Int. J. Heat Mass Transfer, 10, 1861, (1967).Google Scholar
4. Schaeffer, J.F., AIAA J., 16, 1068, (1978).Google Scholar
5. Mckelliget, J., Szekely, J., Vardelle, M., and Fauchais, P., Plasma Chem. Plasma Plasma Process., 2, (3), 317, (1982).Google Scholar
6. Correa, S.M., 6th Int. Symp. on Plasma Chem., Montreal, July 24–28, 1, (1983).Google Scholar
7. Dilawari, A. H. and Szekely, J., Plasma Chem. Plasma Process., 7, (3), 317, (1987).Google Scholar
8. Dilawari, A.H. and Szekely, J., Int. J. Heat Mass Transfer, 30, (11), 2357, (1987).Google Scholar
9. Dilawari, A. H. and Szekely, J., Proc. MRS Symp. on Materials Process. in Plasma Systems, 98, 3, (1987).Google Scholar
10. Dilawari, A. H., Szekely, J., Coudert, J.F., and Fauchais, P., Int. J. Heat Mass Transfer, 32, (1), 35, (1989).Google Scholar
11. Dilawari, A. H., and Szekely, J., Proc. T.B. King Memorial Symp., Met. Trans. B, 20B, April, 243, (1989).Google Scholar
12. Chyou, Y.P and Pfender, E., Plasma Chem. Plasma Process., 9, (2), 291, (1989).Google Scholar
13. Dilawari, A.H., Szekely, J., Batdorf, J. and Shaw, C.B., Plasma Chem. Plasma Process., 10, (2), (1990).Google Scholar
14. Dilawari, A.H., Szekely, J. and Westhoff, R., Plasma Chem. Plasma Process. 10, (3), 501, (1990).Google Scholar
15. Coudert, J.F., Baronnet, J.F., and Fauchais, P., ISPC-6, Montreal, 1, 108, (1983).Google Scholar
16. Vardelle, M., Ph.D. Thesis, No. 80–7, Universite de Limoges (1980).Google Scholar
17. Gravelle, D., Beaulinieu, M., Carlone, C., Iacocca, D., and Boulos, M.I., ISPC-8, Montreal, 1, 108, (1983).Google Scholar
18. Boulos, M., Fauchais, P., and Pfender, E., U.S. Department of Energy, Office of Basic Energy Sciences, Washington, D.C., DOE/ER-0270, 190, (1986).Google Scholar
19. OMA III, Model 1460V, Optical Multichannel Analyzer, EG&G Princeton Applied Research, Princeton, N.J.Google Scholar
20. Yasutomo, Y., et. al., IEEE Trans Plasma Sci., PS-9, 1, 18, (1981)Google Scholar
21. Liu, C. H., Ph.D. Thesis, Department of Mechanical Engineering, Univ. Of Minnesota, Minneapolis, Minnesota (1977).Google Scholar
22. Evans, D. C. and Tankin, R. S., Phys. Fluids 10, 1137 (1967).Google Scholar
23. Bird, R.B., et. al., Transport Phenomena, Wiley, N.Y., 511, (1960).Google Scholar
24. Wilke, C. R., J. Chem Phys., 18, 517–519 (1950).Google Scholar
25. Pun, W.M. and Spalding, D.B., Rep. No. HTS/76/2, Heat Transfer Section, Imperial College, London (1976).Google Scholar