Hostname: page-component-76fb5796d-9pm4c Total loading time: 0 Render date: 2024-04-27T02:14:28.759Z Has data issue: false hasContentIssue false
  • English
  • Français

The Dependence of Indentation Cracking in Silicon on Indentation Spacing and Relative Orientation

Published online by Cambridge University Press:  10 February 2011

M. Manoharan  and
G. Muralidharan
M. Manoharan
Affiliation:
Division of Materials Engineering, School of Applied Science Nanyang Technological University, Singapore - 639798;, asmmanoharan@ntu.edu.sg
G. Muralidharan
Affiliation:
Failure Analysis and Reliability Department, Institute of Microelectronics 11 Science Park Rd., Science Park II, Singapore- 117685
Get access

Abstract

The issue of multiple cracks in materials and their interaction is central in understanding the overall fracture behaviour of materials. In the case of materials used in the microelectronics industry, indentation cracking has been extensively used for the measurement of fracture toughness due to its small sample size requirements as well as a relatively good correlation with values obtained from traditional fracture mechanics tests. The majority of these studies have focused on the fracture behaviour of a single indent. The present study was aimed at understanding the effect of interaction between the cracks generated on Si from a pair of sequential indents as well as a set of four sequential indents placed at the comers of a square. The distance between the indents was varied from a level comparable to the crack size to a level where interaction could be ignored. This paper discusses the changes in the nature as well as the sizes of cracks due to interaction between the stress fields of the indents.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 522: Symposium T – Fundamentals of Nanoindentation & Nanotribology , 1998 , 359
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Cook, R. F. and Pharr, G. M., J. Am. Ceram. Soc., 73, p. 787, (1990).Google Scholar
2. Lankford, J. and Davidson, D. L., J. Mater. Sci., 14, p. 1669, (1979).Google Scholar
3. Lankford, J., J. Mater. Sci., 16 , p. 1177, (1981).Google Scholar
4. Lawn, B.R., Evans, A.G. and Marshall, D.B., J. Am. Ceram. Soc., 63 , p. 574, (1980).Google Scholar
5. Buijs, M. and Martens, L. A. A. G., J. Am. Ceram. Soc., 75, p. 2809, (1992).Google Scholar